Solidification/Stabilization of Contaminated Soil in a South Station of the Khurmala Oil Field in Kurdistan Region, Iraq

Effect of liming on polycyclic aromatic hydrocarbons leaching from hydrocarbon-contaminated tectogenic industriosol

Soil stabilization/solidification is commonly employed remediation method for contaminated soils. Until now, limited attention has been given to the application of quicklime in polycyclic aromatic hydrocarbons (PAHs) contaminated soil. We treated a tectogenic industriosol spiked with 50 mg kg-1 of four PAHs (12.5 mg kg-1 each of fluorene (FLU), phenanthrene (PHE), fluoranthene (FLT) and pyrene (PYR)) using three different liming agents at 1% (w:w): quicklime (CaO), hydrated lime (Ca(OH)2) and carbonate calcium (CaCO3). All treated samples were leached in water at a solid-liquid ratio of 10, with subsequent analysis of leached soil and leachates for PAHs content. Results revealed that the addition of liming agents led to a reduction in FLU and PHE concentrations in treated soil by 6.81 ± 2.47% and 28.88 ± 4.18%, respectively, compared to a not-treated sol. However, no significant impact was observed on the 4-cycles PAHs (FLT and PYR). The addition of liming agents also significantly decreased the amount of PAHs in the leachate, by 100% for FLU and PHE, and by 74.9 ± 17.5% and 72.3 ± 34.8%, for FLT and PYR, respectively, compared to not limed soil. Among the liming agents, quicklime was the most effective in reducing the amount of 4 cycles PAHs in the leachate. Various mechanisms, such as encapsulation, volatilization and oxidation could contribute to this observed reduction. Quicklime treatment at a concentration of 1% w:w in PAHs-contaminated soil emerges as a promising technique to effectively reduce PAHs concentration in soils and mitigate PAHs mobility through leaching. This study also sheds light on the possibility to limit CO2 emissions and resources exploitation to assure the remediation process, thereby enhancing its overall environmental sustainability.

Assessment of Heavy Metal and Oil-Contaminated Silty Sand Treatment by Electrical Resistance Heating Method

The feasibility of the electrical resistance heating method developed in this study was evaluated for the remediation of multi-contaminated silty sand in terms of environmental and geotechnical aspects. The multi-contaminated silty sand sampled in this study was polluted with 21,081 mg/kg of heavy oils, as well as heavy metals. Silty sand, treated using the electrical resistance _heating method was environmentally, as well as geotechnically, compared with the multi-contaminated silty sand in terms of residual concentration, leaching, shear modulus and modified California bearing ratio (CBR). The remediation test was conducted with a target temperature of 700 °C. The removal efficiency of total petroleum hydrocarbon (TPH) was estimated as 99.99% after remediation in 48 h; most of the heavy metals, as some of the contaminants, were isolated as a crystal in treated silty sand without any harmful leakage, and heavy oil was fully extracted with a form of mist and dust. Moreover, it was also geotechnically found that the decontamination process, including the removal of heavy metals and oils, had an effect on the increase in the internal friction angle, shear modulus and modified CBR of treated silty sand. In conclusion, it is shown that the electrical resistance heating method developed in this study is an environmentally and geotechnically effective technology for the recovery of clean construction fill material from hazardous-waste-contaminated silty sand.

Trends and Prospects in Geotechnics

The Special Issue, titled “Trends and Prospects in Geotechnics”, was launched with an invitation to authors from all over the world to address current and future challenges in geotechnics [...]