Assessment of Ag Nanoparticles Interaction over Low-Cost Mesoporous Silica in Deep Desulfurization of Diesel

Computational and experimental assessment of efficient dye adsorption method from aqueous effluents by halloysite and palygorskite clay minerals

The removal of dyes from effluents of textile industries represents a technological challenge, due to their significant environmental impact. The application of halloysite (Hal) and palygorskite (Pal) clay minerals as adsorbents for the removal of Congo red (CR) and methylene blue (MB) was evaluated in this work. The materials were applied both in natural and acid-treated forms, and characterized by XRD, XPS, SEM-EDS, FTIR, and N2 adsorption-desorption isotherm techniques to identify their properties and main active sites. The adsorbents showed potential to remove CR (> 98%) and MB (> 85%) within 180 min, using 0.3 g adsorbent and initial dye concentration of 250 mg L-1. Semi-empirical quantum mechanical calculations (SQM) confirmed the interaction mechanism between dyes and the adsorbents via chemisorption (- 69.0 kcal mol-1 < Eads <  - 28.8 kcal mol-1), which was further observed experimentally due to the high fit of adsorption data to pseudo-second order kinetic model (R2 > 0.99) and Langmuir isotherm (R2 > 0.98). The use of Pal and Hal to remove dyes was proven to be economically and environmentally viable for industrial application.

Immobilization of Ag(0) nanoparticles on quaternary ammonium functionalized polyacrylonitrile fiber as a highly active catalyst for 4-nitrophenol reduction

Ag(0) nanoparticles were immobilized on various pyridine salt, imidazole salt and quaternary ammonium functionalized polyacrylonitrile fibers (PANFs) to prepare Ag(0)-immobilized fiber catalysts. The catalytic activities of these immobilized catalysts for 4-nitrophenol (4-NP) reduction were detected. Among them, the quaternary ammonium fiber with butyl group immobilized Ag(0) nanoparticle catalyst PANQA-C4F-Ag(0) showed the best catalytic activity, and can effectively catalyze 4-nitrophenol (4-NP) reduction with a high conversation rate of 99.6%. Furthermore, PANQA-C4F-Ag(0) can be easily recovered, and it was reused 20 times with little decrease in catalytic activity and moderate Ag retention (53.5%). Notably, the cationic groups in the functionalized fibers can stabilize Ag(0) nanoparticles through electrostatic interactions and steric effects, and play an important role in phase transfer catalysis. Accordingly, possible mechanisms for the 4-NP reduction catalyzed by PANQA-C4F-Ag(0) were proposed.

A novel BMSN (biologically synthesized mesoporous silica nanoparticles) material: synthesis using a bacteria-mediated biosurfactant and characterization

Mesoporous materials (MMs) have recently been applied as advanced nanomaterials in different fields (separation, catalysis, adsorption etc.). Synthesis of MMs by chemical surfactants is not ecofriendly. This study focused on the biological synthesis of a MM by sol-gel method, using a Bacillus subtilis BBK006-mediated surfactant (template) and a precursor (TEOS). The biologically synthesized mesoporous silica nanoparticles (BMSN) were formed at calcination temperatures of 450-600 °C. The BMSN comprise Si and O elements with specific weights of 56.09% and 42.13% respectively, where the atomic% was detected to be 41.79% and 55.10%, respectively. The phase identity of the synthesized particles (61-300 nm uniform spherical shape; surface area: 8.2616 m2 g-1; pore diameter at 550 °C: 14.8516 nm) was confirmed with wide-angle XRD (10°-81°). A typical type IV isotherm was exhibited (BET curves) following IUPAC nomenclature and confirmed the mesoporous nature. The green-synthesized biosurfactant-mediated BMSN is an environmentally promising material to apply in biomedical science (e.g., antimicrobial activity, drug delivery, CMC, anticancer activity) and oil spill management.

Investigating Methylene Blue Removal from Aqueous Solution by Cysteine-Functionalized Mesoporous Silica

In this study, mesoporous silica nanoparticles (MSNs) were synthesised using the Stober method and functionalised with cysteine (MSN-Cys) for removal of Methylene Blue (MB) from aqueous solution using the batch method. The adsorbent nanoparticles were characterised by Scanning Electron Microscopy (SEM), Transmission Electron Microscopy (TEM), FTIR, BET, and TGA. Several influential factors on the adsorption of MB onto the surface of MSN-Cys particles were investigated, including pH, initial concentration, and contact time. The adsorption capacity of MB from aqueous solution increased from circa 70 mg/g MSN-Cys in acidic media to circa 140 mg/g MSN-Cys in basic media. Adsorption isotherms and kinetic models of adsorption were used to clarify the adsorption process. The measured adsorption isotherm was fitted with a Freundlich model for all solutions, and the kinetic model was determined to be pseudo-second-order.

Sulfur dioxide removal: An overview of regenerative flue gas desulfurization and factors affecting desulfurization capacity and sorbent regeneration

Numerous mitigation techniques have been incorporated to capture or remove SO₂ with flue gas desulfurization (FGD) being the most common method. Regenerative FGD method is advantageous over other methods due to high desulfurization efficiency, sorbent regenerability, and reduction in waste handling. The capital costs of regenerative methods are higher than those of commonly used once-through methods simply due to the inclusion of sorbent regeneration while operational and management costs depend on the operating hours and fuel composition. Regenerable sorbents like ionic liquids, deep eutectic solvents, ammonium halide solutions, alkyl-aniline solutions, amino acid solutions, activated carbons, mesoporous silica, zeolite, and metal-organic frameworks have been reported to successfully achieve high SO₂ removal. The presence of other gases in flue gas, e.g., O₂, CO₂, NOx, and water vapor, and the reaction temperature critically affect the sorption capacity and sorbent regenerability. To obtain optimal SO₂ removal performance, other parameters such as pH, inlet SO₂ concentration, and additives need to be adequately governed. Due to its high removal capacity, easy preparation, non-toxicity, and low regeneration temperature, the use of deep eutectic solvents is highly feasible for upscale utilization. Metal-organic frameworks demonstrated highest reported SO₂ removal capacity; however, it is not yet applicable at industrial level due to its high price, weak stability, and robust formulation.

Effective Interactions of Ag Nanoparticles on the Surface of SBA-15 in Performing Deep Desulfurization of Real Diesel Fuel

SBA-15 materials as-synthesized and impregnated with Ag nanoparticles were applied to perform adsorptive desulfurization of real diesel fuel. High-angle annular dark-field scanning transmission electron microscopy and field-emission scanning electron microscopy coupled with energy-dispersive X-ray spectroscopy (HAADF-STEM-EDX and FESEM-EDX) and X-ray photoelectron spectroscopy (XPS) results confirmed that there is uniform distribution of Ag nanodomains on the surface and in the channels of a 2AgSBA-15 (2% Ag) sample. The interaction between sulfur compounds and adsorbent mainly occurred via π-complexation mechanisms, as observed via XPS and equilibrium data. The kinetic results for 2AgSBA-15 were better fitted to the pseudo-second-order model (R2 > 0.9999), indicating that the determining step of the adsorptive process is chemisorption, whereas the equilibrium results were better fitted to the Langmuir model (R2 > 0.9994), thus indicating that the adsorption occurs on the adsorbent surface monolayer with significant adsorption capacity (qm = 20.30 mgS/g), approximately two times greater than that observed for pure SBA-15. The mean desulfurization reached by the adsorbents was up to 86.8% for six recycling steps.

Catalysis for Global Development. Contributions around the Iberoamerican Federation of Catalysis

Following biennial meetings held since 1968, the Iberoamerican Federation of Catalysis Societies (FISoCat), the Portuguese Chemical Society (SPQ) and the University of Coimbra jointly organized the XXVI Iberoamerican Congress on Catalysis (CICat 2018), which took place in the historic city of Coimbra, Portugal, between the 9th and 14th of September 2018 [...]