Structural, Magnetic and Gas Sensing Activity of Pure and Cr Doped In2O3 Thin Films Grown by Pulsed Laser Deposition

Attuning doped ZnO-based composites for an effective light-driven mineralization of pharmaceuticals via PMS activation

Water treatment technologies need to go beyond the current control of organic contaminants and ensure access to potable water. However, existing methods are still costly and often inadequate. In this context, novel catalysts that improve the mineralization degree of a wider range of pharmaceuticals through more benign and less consuming methodologies are highly sought after. ZnO, especially when doped, is a well-known semiconductor that also excels in the photocatalytic removal of persistent organic pollutants. In this study, we investigated the effect of doping ZnO nanoparticles with either copper, gallium or indium on the structure, morphology, photophysical properties and photocatalytic mineralization of pharmaceuticals. Their architecture was further improved through the fabrication of composites, pairing the best performing doped ZnO with either BaFe12O19 or nickel nanoparticles. Their suitability was tested on a complex 60-ppm multi-pollutant solution (tetracycline, levofloxacin and lansoprazole). The activation strategy combined photocatalysis with peroxymonosulfate (PMS) as an environmentally friendly source of highly oxidative sulfate radicals. The alliance of doped ZnO and BaFe12O19 was particularly successful, resulting in magnetic microcroquette-shaped composites with excellent inter-component synergy. In fact, indium outperformed the other proposed metal dopants, exceeding 97% mineralization after 1 h and achieving complete elimination after 3 h. All composites excelled in terms of reusability, with no catalytic loss after 10 consecutive cycles and minimal leakage of metal ions, highlighting their applicability in water remediation.

Special Issue “Functional Oxide Thin Films and Nanostructures: Growth, Properties, and Applications”

It has been almost three years since we enthusiastically accepted the offer to be guest editors for this Special Issue of Coatings, entitled “Functional Oxide Thin Films and Nanostructures: Growth, Properties, and Applications” [...]

Ag Functionalized In2O3 Derived From MIL-68(In) as an Efficient Electrochemical Glucose Sensor

In this study, Ag@In2O3 modified nickel foam (NF) was reported for its role as a non-enzymatic glucose sensor. Ag@In2O3 was prepared by a simple two-step method; preparation of a metal-organic framework (MOF) MIL-68(In) by solvothermal method, entrapment of Ag + by adding AgNO3 then drying it for 2 h to complete the entrapment process and subsequent calcination at 650°C for 3 h. The Ag@In2O3 modified NF was employed as a non-enzymatic glucose sensor to determine glucose concentrations in an alkaline medium. Two linear ranges were obtained from Ag@In2O3 modified electrode, i.e., 10 μM to 0.8 mM and 0.8–2.16 mM with a sensitivity of 3.31 mA mM−1 cm−2 and 1.51 mA mM−1 cm−2 respectively, with a detection limit of 0.49 µM. Ag@In2O3 modified NF exhibited high selectivity for glucose, among other interfering agents.