Videoscope-Assisted Minimally Invasive Surgery (VMIS) for Bone Regeneration around Teeth and Implants: A Literature Review and Technique Update

Laser and scanning electron microscopy evaluation of residual microislands of calculus

BACKGROUND

Recent studies suggest a role for microscopic crystalline particles of residual dental calculus in the pathogenesis of periodontitis. The purpose of this ex vivo study was to compare the effectiveness of scaling and root planing (SRP) alone versus SRP combined with 24% ethylenediamine-tetra acetic acid (EDTA) gel in removing calculus from extracted teeth and to determine the optimal length of time for application of the EDTA.

METHODS

Specimens consisted of 32 extracted teeth with heavy root calculus. A 4-mm diameter site was prepared on the root surface of each tooth which then underwent SRP. EDTA was applied to four timed groups: 30 s; 60 s; 120 s; and 180 s. Photomicrographs were taken at 40× magnification using white light (WL) and laser fluorescence (LF). Photomicrographs were analyzed using ImageJ. Specimens were also evaluated with scanning electron microscopy (SEM).

RESULTS

The mean area of residual calculus after SRP was 45%-53% (45.6% ± 19.6% WL, 53.8% ± 19.7% LF). Burnishing with EDTA for one minute following SRP reduced calculus to only 14%-18% (13.9% ± 12.5% LF, 18.2% ± 11.1% WL). Use of EDTA for greater than 1 min showed no further calculus removal. SEM revealed the surface of remaining calculus was altered by burnishing with EDTA.

CONCLUSION

SRP alone or SRP + 24% EDTA gel failed to remove all calculus. SRP alone removed >60% of calculus from root surfaces. Adjunctive use of 24% EDTA gel burnished on the root surface removed most of the calculus residual after SRP. Calculus remaining after EDTA burnishing exhibited a significantly altered morphologic appearance.

Subgingival scaling and root planing during minimally invasive periodontal surgery: A randomized controlled split-mouth trial

BACKGROUND

The purpose of this randomized, controlled split-mouth study was to evaluate a videoscope as a visual adjunct to scaling and root planing when utilized in combination with minimally invasive surgery.

METHODS

Twenty-five pairs (89 interproximal surfaces) of periodontally hopeless teeth planned for extraction were scaled and root planed with minimal surgical access using surgical loupes (control) or adjunctive use of a videoscope (test). Teeth were extracted with minimal trauma, stained with methylene blue, and photographed with a digital microscope for analysis. The primary outcome of residual calculus was calculated as a percentage of the total interproximal area of interest. Secondary outcomes included treatment time, as well as residual calculus according to probing depth, tooth location, and treatment date. Data were analyzed using Student's paired t-tests, two-way analyses of variance, and Spearman's correlation tests.

RESULTS

Residual calculus area was 2.61% on control and 2.71% on test surfaces with no significant difference between groups. Subgroup analysis showed no difference in residual calculus between groups at moderate or deep sites. Treatment time per surface was significantly longer in the test group compared to the control group. Treatment order, tooth location, and operator experience did not significantly affect the primary outcome.

CONCLUSIONS

Though the videoscope provided excellent visual access, it did not improve the efficacy of root planing for flat interproximal surfaces during minimally invasive periodontal surgery. Small amounts of calculus remain after instrumentation even with minimal surgical access and when root surfaces appear visually clean and tactilely smooth.

A novel periodontal endoscopy-aided non-incisional periodontal regeneration technique in the treatment of intrabony defects: a retrospective cohort study

BACKGROUND

Gingival recession and post-operation discomfort are still a problem for patients receiving the periodontal regeneration surgery for intra-bony defects. To further reduce the trauma and the post-operation gingival recession, a novel periodontal endoscopy-aided non-incisional regeneration technique (NIT) was proposed in the treatment of intra-bony defects.

METHODS

Retrospective analysis of 21 subjects treated with NIT and 21 subjects with periodontal endoscopy-aided scaling and root planing (PSRP) at baseline and 1-year evaluation was conducted. After removing the subgingival calculus and granulation tissue, bone grafting materials were placed into intrabony defects with the assistance of a gingival retractor in the NIT group. Probing depth (PD), gingival recession (GR), clinical attachment level (CAL), as well as the distance between bone crest (BC) level and base of the defect (BD) (intrabony defect depth, IBD) were evaluated at baseline and 1 year after treatment.

RESULTS

At 1-year follow-up, the value of CAL, PD and IBD were statistically significant different compared with baseline in both two groups (p<0.001). CAL gain (p = 0.012) and PD reduction (p = 0.004) was greater in the NIT than PSRP. However, no difference in the IBD reduction was found between the NIT group and PSRP. Better CAL gain and PD reduction was achieved in the 1-year term in the NIT when compared with PSRP.

CONCLUSION

NIT have resulted in significant gains in both clinical and radiographic parameters. NIT might be utilized as an alternative of the surgical treatment for periodontal intrabony defects.

TRIAL REGISTRATION

This clinical trial registration was registered retrospectively (August 3, 2023) and the number is ChiCTR2300074317.

[Comparison of clinical effects between periodontal endoscopy aiding subgingival debridement and flap surgery]

OBJECTIVE

To compare the clinical effects of periodontal endoscopy aiding subgingival debridement with periodontal flap surgery on residual deep pockets of chronic periodontitis.

METHODS

In the single-blind randomized control clinical study, residual deep pockets of periodontitis patients were still existing when re-evaluation after receiving initial periodontal treatment.The pockets which were necessary for bone surgery or guided tissue regeneration surgery were excluded.The sites were divided into test group and control group randomly.Test group sites underwent periodontal endoscopy aiding debridement and control group sites had periodontal flap surgery.At the baseline and 3 months later, parameters, such as plaque index (PLI), bleeding index (BI), probing depth (PD), attachment loss (AL) were examined.Bone height was measured by parallelly digital X-ray dental film.Meanwhile, treatment time and comfort scale (visual analogue scale, VAS) were also recorded.

RESULTS

At baseline, 41 proximal sites with residual deep pockets were enrolled (test sites=21, control sites=20).All the parameters were not significantly different between the two groups.PD decreased by (1.67±0.91) mm from (5.62±0.86) mm to (3.95±0.74) mm in test group and by (2.25±1.12) mm from (5.95±1.19) mm to (3.70±0.73) mm in control group significantly (P < 0.05).The difference between the two groups was not significant.The PD of all the sites decreased lower than 5 mm, meanwhile, 76% was lower than 4 mm in test group and 85% was lower than 4 mm in control group.The BI decreased by 0.81±0.93 in test group and 0.65±0.99 in control group significantly (P < 0.05).The difference between the two groups was not significant.The PLI showed a tendency of decrease more in test group and bone height showed a trend of decrease more in control group, however, the difference was not significant.The treatment time was almost the same.The patients felt more comfortable in the test group (VAS was 0.60±0.89) than the control group (VAS was 1.20±1.64), however, the difference was not significant.

CONCLUSION

Periodontal endoscopy aiding subgingival debridement could improve periodontal status by reducing the PD and BI significantly in short term.The effect was almost the same with periodontal surgery and endoscopy treatment may decrease the necessity of surgery.Meanwhile, periodontal endoscopy has more comfortable treatment experience than flap surgery and does not need extra treatment time.

A Method for Preventing Aerosols During Dental Treatment With an Oroscope

Dentists have a much higher risk of exposure to coronavirus disease (COVID-19) than other healthcare workers. The virus is transmitted primarily through respiratory droplets and close/direct contact. Aerosol propagation is also possible in the case of prolonged exposure to high concentrations in a relatively closed environment. In this report, we describe the use of an aerosol box model to prevent aerosol generation during dental procedures. This report serves to inform clinicians on the potential effectiveness of this stopgap measure in cases where aerosol-generating procedures are unavoidable and medical supplies and personal protective equipment are in short supply.

Hard Tissue Preservation and Recovery in Minimally Invasive Alveolar Surgery Using Three-Dimensional Printing Guide Plate

BACKGROUND

For completely impacted teeth, it is of great significance to locate teeth accurately, preserve hard tissue and recovering the height of alveolar ridge. This can be effectively solved by the digital three-dimensional printing guide technology.

METHODS

Ten patients with completely impacted tooth were selected in this experiment. After cone-beam computed tomography scan, the dicom formal computed tomography data was analyzed for three-dimensional reconstruction by mimics 17.0 software. Then determining the surgical plan and making surgical guide plate. Three-dimensional printing guide plate assisted piezosurgery was used to remove bone and extract impacted teeth. After that, the removed bone cap was back to the original position. Cone-beam computed tomography was used for each operated patients after 1 week and 6 months.

RESULT

The surgical guide plates can locate teeth accurately and the surgery time was reduced for all patients. A week later, all patients healed well and removed the stitches on time. Cone-beam computed tomography showed that the retention of bone caps was good and there was no displacement. All patients showed a normal parameter of pain. Six months later, cone-beam computed tomography showed good bone formation in the extraction area, which filled with new bones completely. The recovery of bone outline and height of alveolar crest at the surgical site were basically consistent with those before the operation.

CONCLUSIONS

Three-dimensional printing guide plates combining with fenestration and bone-cap restoration can locate impacted teeth accurately, reduce the extraction volume of bone, shorten surgery time, and alleviate complications. This was conducive to preserve and restore hard tissue and had great prospective.