Laser Superficial Fusion of Gold Nanoparticles with PEEK Polymer for Cardiovascular Application

Characterization of the Polyetheretherketone Weldment Fabricated via Rotary Friction Welding

Polyether ether ketone (PEEK) is frequently employed in biomedical engineering due to its biocompatibility. Traditionally, PEEK manufacturing methods involve injection molding, compression molding, additive manufacturing, or incremental sheet forming. Few studies have focused on rotational friction welding (RFW) with PEEK plastics. Based on years of RFW practical experience, the mechanical properties of the weldment are related to the burn-off length. However, few studies have focused on this issue. Therefore, the main objective of this study is to assess the effects of burn-off length on the mechanical properties of the welded parts using PEEK polymer rods. The welding pressure can be determined by the rotational speed according to the proposed prediction equation. The burn-off length of 1.6 mm seems to be an optimal burn-off length for RFW. For the rotational speed of 1000 rpm, the average bending strength of the welded parts was increased from 108 MPa to 160 Mpa, when the burn-off length was increased from 1 mm to 1.6 mm and the cycle time of RFW was reduced from 80 s to 76 s. A saving in the cycle time of RFW of about 5% can be obtained. The bending strength of the welded part using laser welding is lower than that using RFW, because only the peripheral material of the PEEK cylinder was melted by the laser.

Influence of Citrus Fruit Waste Filler on the Physical Properties of Silicone-Based Composites

Silicones have been used as protective coatings due to their resistance to hydrolytic degradation and UV (ultraviolet) degradation. There is a growing problem with managing organic waste, which can be used as fillers in composites. This research demonstrated the use of organic waste from citrus peels, including grapefruit, lime, lemon, and orange peels. Silicone-based composites were prepared by gravity-casting using 2.5, 5, and 10 wt.% waste filler. Samples made from the composite panels were subjected to static tensile, density, hardness, pin-on-disc, and Schopper-Schlobach abrasion tests. The test results showed that lower tensile strength values characterized the composite materials compared to the silicone used as a filler. All materials had greater hardness than the silicone without the addition. At the same time, composites with a mass density of the filler of 2.5 and 5 wt.% showed more excellent abrasion resistance than the silicone used as a matrix. This research showed that the samples containing 2.5 wt.% grapefruit filler had the best mechanical properties and the lowest abrasive wear.