Carboxin and Diuron Adsorption Mechanism on Sunflower Husks Biochar and Goethite in the Single/Mixed Pesticide Solutions

Agricultural biomass/waste-based materials could be a potential adsorption-type remediation contributor to environmental pollution induced by pesticides-A critical review

The widespread use of pesticides that are inevitable to keep the production of food grains brings serious environmental pollution problems. Turning agricultural biomass/wastes into materials addressing the issues of pesticide contaminants is a feasible strategy to realize the reuse of wastes. Several works summarized the current applications of agricultural biomass/waste materials in the remediation of environmental pollutants. However, few studies systematically take the pesticides as an unitary target pollutant. This critical review comprehensively described the remediation effects of crop-derived waste (cereal crops, cash crops) and animal-derived waste materials on pesticide pollution. Adsorption is considered a superior and highlighted effect between pesticides and materials. The review generalized the sources, preparation, characterization, condition optimization, removal efficiency and influencing factors analysis of agricultural biomass/waste materials. Our work mainly emphasized the promising results in lab experiments, which helps to clarify the current application status of these materials in the field of pesticide remediation. In the meantime, rigorous pros and cons of the materials guide to understand the research trends more comprehensively. Overall, we hope to achieve a large-scale use of agricultural biomass/wastes.

Separation of plant protection products from complex aqueous bodies using carbon-mineral composites incorporated with double metals (Ni/Mn or Ni/Fe)

Due to the extensive application of pesticides and their hazardous effects on organisms, there is an urgent need to remove them effectively from wastewater. Metal-incorporated carbon-mineral composites (Ni/Mn-CMC and Ni/Fe-CMC) described in this paper can certainly be applied for this purpose. They were synthesized by combining mechanochemical and pyrolytic processes and their physicochemical properties were investigated using numerous methods (SEM-EDS, N2 adsorption/desorption, XRD, surface charge, FTIR). Adsorption capacity towards diuron and carboxin with and without impurities commonly detected in natural ecosystems, cadmium ions or arsenite, was measured. The obtained results indicated that Ni/Fe-CMC is more efficient adsorbent of pesticides due to its well-developed surface. It was able to bind 158.34 mg g-1 of diuron and 133.58 mg g-1 of carboxin in the solutions, where only one pesticide was present. In turn, these values for the Ni/Mn-CMC sample were 126.49 mg g-1 and 102.08 mg g-1, respectively. It should be noted that the composites maintained their high adsorption capacity in the multicomponent solutions, i.e., containing both pesticide and metal ions. Then, the maximum reduction in pesticide adsorption was only 8.36. Ni/Mn-CMC and Ni/Fe-CMC were successfully regenerated with ethanol without changing their structure and adsorption capacity. Also, the extracts from investigated materials did not have negative impact on plant growth. This confirmed suitability of carbon-mineral composites for repeated multiple use without toxic effects to organisms.

Complete biodegradation of fungicide carboxin and its metabolite aniline by Delftia sp. HFL-1

Fungicide carboxin was commonly used in the form of seed coating for the prevention of smut, wheat rust and cotton damping-off, leading carboxin and its probable carcinogenic metabolite aniline to directly enter the soil with the seeds, causing residual pollution. In this study, a novel carboxin degrading strain, Delftia sp. HFL-1, was isolated. Strain HFL-1 could use carboxin as the carbon source for growth and completely degrade 50 mg/L carboxin and its metabolite aniline within 24 h. The optimal temperatures and pH for carboxin degrading by strain HFL-1 were 30 to 42 °C and 5 to 9, respectively. Furthermore, the complete mineralization pathway of carboxin by strain HFL-1 was revealed by High Resolution Mass Spectrometer (HRMS). Carboxin was firstly hydrolyzed into aniline and further metabolized into catechol through multiple oxidation processes, and finally converted into 4-hydroxy-2-oxopentanoate, a precursor of the tricarboxylic acid cycle. Genome sequencing revealed the corresponding degradation genes and cluster of carboxin. Among them, amidohydrolase and dioxygenase were key enzymes involved in the degradation of carboxin and aniline. The discovery of transposons indicated that the aniline degradation gene cluster in strain HFL-1 was obtained via horizontal transfer. Furthermore, the degradation genes were cloned and overexpressed. The in vitro test showed that the expressed degrading enzyme could efficiently degrade aniline. This study provides an efficient strain resource for the bioremediation of carboxin and aniline in contaminated soil, and further revealing the molecular mechanism of biodegradation of carboxin and aniline.

Scavenging of copper(II) ions, phosphate(V) ions, and diuron from aqueous media by goethite modified with chitosan or poly(acrylic acid)

Goethite was modified by chitosan (CS) or poly(acrylic acid) (PAA) to improve its adsorptive abilities toward components of agrochemicals, i.e., copper ions (Cu), phosphate ions (P), and diuron. The pristine goethite effectively bound Cu (7.68 mg/g, 63.71%) and P (6.31 mg/g, 50.46%) only in their mixed systems. In the one adsorbate solutions, the adsorption levels accounted for 3.82 mg/g (30.57%) for Cu, 3.22 mg/g (25.74%) for P, and 0.15 mg/g (12.15%) for diuron. Goethite modification with CS or PAA did not yield spectacular results in adsorption. The maximum increase in adsorbed amount was noted for Cu ions (8.28%) after PAA modification as well as for P (6.02%) and diuron (24.04%) after CS modification. Both goethite modifications contributed to clear reduction in desorption of pollutants (even by 20.26% for Cu after PAA coating), which was mainly dictated by electrostatic attractive forces and hydrogen bonds formation occurring between macromolecules and impurities. The only exception in this phenomenon was Cu desorption from CS-modified solid-the polymer made it higher (to 95.00%). The Cu adsorption on PAA-modified goethite enhanced solid aggregation and thus facilitated metal cation separation from aqueous media. Consequently, the goethite modification with PAA was considered more promising for environmental remediation.

A Stable Fe-Zn Modified Sludge-Derived Biochar for Diuron Removal: Kinetics, Isotherms, Mechanism, and Practical Research

To remove typical herbicide diuron effectively, a novel sludge-derived modified biochar (SDMBC600) was prepared using sludge-derived biochar (SDBC600) as raw material and Fe-Zn as an activator and modifier in this study. The physico-chemical properties of SDMBC600 and the adsorption behavior of diuron on the SDMBC600 were studied systematically. The adsorption mechanisms as well as practical applications of SDMBC600 were also investigated and examined. The results showed that the SDMBC600 was chemically loaded with Fe-Zn and SDMBC600 had a larger specific surface area (204 m²/g) and pore volume (0.0985 cm³/g). The adsorption of diuron on SDMBC600 followed pseudo-second-order kinetics and the Langmuir isotherm model, with a maximum diuron adsorption capacity of 17.7 mg/g. The biochar could maintain a good adsorption performance (8.88-12.9 mg/g) under wide water quality conditions, in the pH of 2-10 and with the presence of humic acid and six typical metallic ions of 0-20 mg/L. The adsorption mechanisms of SDMBC600 for diuron were found to include surface complexation, π-π binding, hydrogen bonding, as well as pore filling. Additionally, the SDMBC600 was tested to be very stable with very low Fe and Zn leaching concentration ≤0.203 mg/L in the wide pH range. In addition, the SDMBC600 could maintain a high adsorption capacity (99.6%) after four times of regeneration and therefore, SDMBC600 could have a promising application for diuron removal in water treatment.

Management of hazardous fly-ash energy waste in the adsorptive removal of diclofenac by the use of synthetic zeolitic materials

Zeolite-carbon composites (Na-P1(C), Na-X(C)) and pure zeolites (Na-P1, Na-X) were synthesized from hazardous high-carbon fly ash waste (HC FA) via hydrothermal reaction with sodium hydroxide (NaOH). These solids were applied in the removal of diclofenac (DCF) from aqueous solution, with and without poly(acrylic acid) (PAA). The experiments included adsorption-desorption measurements, as well as electrokinetic and stability analyses. The obtained results showed that HC FA and Na-P1(C) had the greatest adsorption capacity towards DCF, i.e., 26.51 and 21.19 mg/g, respectively. PAA caused considerable decrease in the DCF adsorption due to the competition of both adsorbates of anionic character for active sites. For example, the adsorbed amount of DCF on Na-P1 without PAA was 14.11 mg/g, whereas the one measured with PAA was 5.08 mg/g. Most of prepared solids were effectively regenerated by the use of NaOH. Desorption degree reached even 73.65% in the single systems (with one adsorbate) and 97.24% in the mixed ones (with two adsorbates). Zeolitic materials formed suspensions of rather low stability, which underwent further deterioration in the organic molecules presence. All the results obtained in this study indicated that HC FA can be successfully managed in the removal of organic substances.

Study on electrical double layer nanostructure on zeolitic materials’ surface in the presence of impurities of different nature

The aim of the research was to compare the adsorption mechanisms of heavy metal ions (Pb(II) and Zn(II)), as well as organic substances [diclofenac molecules and pol(acrylic acid) macromolecules on the surfaces of Na-X and Na-P1 synthetic zeolites as well their Na-X© and Na-P1© carbon composites]. The single and mixed adsorbate systems were considered. The more probable structures of the formed adsorption layers were proposed based on the results of the solid surface charge density and zeta potential experiments. The great applicability of the analysis of the parameters characterizing the electrical double layer in determination of the binding mechanism of simple inorganic ions and more complex organic molecules on the surface of the examined solids from the one- and two-component solutions was proved. Moreover, the changes of the surface and electrokinetic factors after the addition of the organic molecules enable specification of drug molecule orientation as well as the polymeric chain conformation at the solid/liquid interface.

Chemical modification of biochars as a method to improve its surface properties and efficiency in removing xenobiotics from aqueous media

Biochar (BC) is a carbonaceous material produced by pyrolysis of biomass, applied in various areas such as water purification, fuel production, soil amendment, etc. Many types of BC are characterized by insufficient textural parameters or poor surface chemistry, and hence by low adsorption capacity. This makes innovative chemical methods increasing BC ability to remove xenobiotics from aquatic environments highly needed. Many of them have already been described in the literature. This review presents them in detail and evaluates their effectiveness in improving textural parameters, surface chemistry, and adsorption capacity of BC.

Assessment of agricultural waste biochars for remediation of degraded water-soil environment: Dissolved organic carbon release and immobilization of impurities in one- or two-adsorbate systems

This paper presents a method of agricultural waste management - the production of two biochars (BC) from potato and raspberry stems. It defines the potential of these materials for remediation of degraded water and soil environments. The performed study included analyses of BC physicochemistry, dissolved organic carbon (DOC) release and ability to immobilize copper (Cu), tetracycline (TC) and carboxin (CB) in one- and two-adsorbate systems. The BCs were obtained with pyrolysis at 600 °C for 30 min in a nitrogen atmosphere. Their DOC was predominantly constituted of substances with large molecular weights and high aromaticity, meaning that both BCs can be safely applied as soil additives. Potato-biochar (P-BC) had a more developed surface than raspberry-biochar (R-BC). The specific surface area (S_BET) of P-BC was 122 m²/g, whilst of R-BC was 87 m²/g. As a result, the efficiency of impurity adsorption in the one-adsorbate systems was higher for P-BC (61.75% for Cu, 73.84% for TC, and 54.43% for CB). In the two-adsorbate systems, organic impurities improved the immobilization of heavy metal ions on BCs. The efficiency of Cu adsorption on P-BC when TC was present was 88.29%. Desorption of Cu from BC was highest using HCl, whilst that of TC and CB was highest using NaOH. Maximum desorption was observed in a two-adsorbate system with TC + CB (up to 63.6% for TC). These results confirmed that potato and raspberry stems can be used to produce highly effective BCs with large application potential, especially for remediation of degraded soils and polluted waters.

Effect of Biochar Modification by Vitamin C, Hydrogen Peroxide or Silver Nanoparticles on Its Physicochemistry and Tetracycline Removal

Chemical modification of biochars can improve their adsorption capacity relative to antibiotics, posing a serious threat to the environment. Therefore, this research is aimed at the treatment of sunflower husk biochar (BC) by vitamin C, hydrogen peroxide or silver nanoparticles and the impact of this procedure on the biochar porosity, surface chemistry, and ability to remove tetracycline (TC). During the study, BC was produced by pyrolysis of sunflower husks at 650 °C. All solids were characterized using potentiometric titration, nitrogen adsorption/desorption, Fourier transform infrared spectroscopy, etc. The experimental adsorption data was described by kinetics equations: pseudo-first order, pseudo-second order, and particle internal diffusion (IPD) models as well as by isotherms of Langmuir, Langmuir-Freundlich, and Redlich-Peterson. The obtained results indicated that the biochar upgraded by vitamin C (BCV) had the highest ability to attract antibiotic molecules and, as a result, the TC adsorption on its surface was the largest. Furthermore, the TC desorption from this material was minimal. The measured TC adsorbed amounts for the modified BCs were as follows: 47.75% (7.47 mg/g) for BCV, 37.35% (8.41 mg/g)-for biochar treated by hydrogen peroxide (BCH), and 42.04% (9.55 mg/g) for biochar modified by silver nanoparticles (BCA). The lowest adsorption level was noted for non-modified biochar, i.e., 34.17% (6.83 mg/g). Based on the presented results it can be stated that the upgraded biochars had a good potential to improve the tetracycline removal from aqueous media, e.g., groundwater.