Effect of Bioactive Glass-Containing Light-Curing Varnish on Enamel Remineralization

A comparative evaluation of human enamel remineralization ability of biomimetic nacre against casein phosphopeptide-amorphous calcium phosphate: An in vitro study

Introduction

This study aimed to assess and compare the efficacy of Nacre and casein phosphopeptide-amorphous calcium phosphate (CPP-ACP) on the remineralization of enamel using surface microhardness analysis, scanning electron microscopy (SEM), and energy dispersive X-ray (EDX) spectroscopy.

Materials and Methods

Twenty human maxillary premolars extracted for orthodontic reasons were collected. Under cool water spray, the crowns were sectioned mesiodistally into buccal and palatal halves using a diamond disc. The samples were subsequently mounted in self-cure acrylic resin. The samples were then subjected to Vickers hardness testing and SEM-EDX for baseline. To simulate carious lesions, all of the samples were acid-etched with 37% phosphoric acid for 30 s in a specific area on the enamel samples and subjected to surface microhardness testing and SEM-EDX. The enamel samples were randomly assigned to Group 1: Nacre water-soluble matrix (WSM), Group 2: Nacre varnish, and Group 3: CPP-ACP for remineralization. After 21 days, remineralization assessment of the test samples was done using SMH analysis and SEM-EDX analysis. Data obtained were statistically analyzed using the one-way analysis of variance to reveal the significant differences between the groups. Tukey's test was used for post hoc comparisons.

Results

All three groups showed a significant increase in surface microhardness. All three groups showed a significant calcium and phosphorous ratio increase after remineralization. Among the three groups, the highest Ca:P ratio was seen in the Nacre WSM group (0.58) followed by the Nacre Varnish (0.57) and CPP-ACP group (0.57). SEM images of the Nacre surface revealed the presence of extensive interlocking. A layer of packed hydroxyapatite particles was formed on the surface of the nacre through surface reactions.

Conclusion

All the groups in the present study showed some extent of remineralizing ability irrespective of the different materials and mechanisms of action. Nacre WSM showed a remarkable hardness spike close to natural enamel after demineralization.

Protecting primary teeth from dental erosion through bioactive glass

OBJECTIVES

The present study aimed to evaluate the effectiveness of bioactive glass (BAG) in preventing dental erosion in primary teeth.

METHODS

Enamel and dentin specimens (2 × 2 × 2 mm) were obtained from extracted primary teeth, which were randomly divided into the following groups based on the pretreatments (n = 12): DW (deionized water), NaF (2 % sodium fluoride), 2BAG (2 % BAG), 4BAG (4 % BAG), 6BAG (6 % BAG), and 8BAG (8 % BAG). The specimens were immersed in the respective solutions for 2 min and subjected to in vitro erosive challenges (4 × 5 min/d) for 5 d. The erosive enamel loss (EEL), erosive dentin loss (EDL), and the thickness of the demineralized organic matrix (DOM) were measured using a contact profilometer. The surface microhardness (SMH) was measured, and the percentage of SMH loss (%SMHL) was calculated. The surface morphology and mineral composition were evaluated by scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDS), respectively.

RESULTS

After the erosive challenges, the EEL, EDL, and%SMHL of the 2BAG, 4BAG, 6BAG, and 8BAG groups significantly reduced, with the greatest reduction was observed in the 6BAG (EEL: 6.5 ± 0.2 μm;%SMHL in enamel: 12.8 ± 2.6; EDL: 7.9 ± 0.3 μm; %SMHL in dentin: 22.1 ± 2.7) and 8BAG groups (EEL: 6.4 ± 0.4 μm;%SMHL in enamel: 11.0 ± 1.9; EDL: 7.8 ± 0.5 μm; %SMHL in dentin: 22.0 ± 2.5) (P < 0.05). With increasing BAG concentrations, the number of surface deposits containing Ca, P, and Si increased.

CONCLUSIONS

6BAG was the most effective for preventing dental erosion in primary teeth and showed a particularly strong potential for dentin erosion prevention.

CLINICAL SIGNIFICANCE

Bioactive glass, especially at a 6 % concentration, has proven effective in reducing erosive tooth wear and surface microhardness loss while also protecting demineralized organic matrix in primary dentin.

New generation of orthodontic devices and materials with bioactive capacities to improve enamel demineralization

OBJECTIVE

The article reviewed novel orthodontic devices and materials with bioactive capacities in recent years and elaborated on their properties, aiming to provide guidance and reference for future scientific research and clinical applications.

DATA, SOURCES AND STUDY SELECTION

Researches on remineralization, protein repellent, antimicrobial activity and multifunctional novel bioactive orthodontic devices and materials were included. The search of articles was carried out in Web of Science, PubMed, Medline and Scopus.

CONCLUSIONS

The new generation of orthodontic devices and materials with bioactive capacities has broad application prospects. However, most of the current studies are limited to in vitro studies and cannot explore the true effects of various bioactive devices and materials applied in oral environments. More research, especially in vivo researches, is needed to assist in clinical application.

CLINICAL SIGNIFICANCE

Enamel demineralization (ED) is a common complication in orthodontic treatments. Prolonged ED can lead to dental caries, impacting both the aesthetics and health of teeth. It is of great significance to develop antibacterial orthodontic devices and materials that can inhibit bacterial accumulation and prevent ED. However, materials with only preventive effect may fall short of addressing actual needs. Hence, the development of novel bioactive orthodontic materials with remineralizing abilities is imperative. The article reviewed the recent advancements in bioactive orthodontic devices and materials, offering guidance and serving as a reference for future scientific research and clinical applications.

Comparative analysis of the effect of Bioactive Glass 45S5 on enamel erosion progression in human dentitions (in vitro study)

OBJECTIVES

The aim of the present study was to compare the surface morphology alterations, mineral content, and surface roughness of eroded enamel surface versus eroded enamel surface which was preceded by Bioactive Glass 45S5 (BAG45S5) application in both primary and permanent human dentitions.

MATERIALS AND METHODS

Fifty-two primary teeth and fifty-two permanent teeth were selected. Teeth were randomly divided into 4 groups of twenty-six teeth each. Groups A1 and B1 underwent erosion with 1% citric acid, while groups A2 and B2 were subjected to application of BAG45S5 powder followed by the same erosive conditions as A1 and B1. Measurements were performed by scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), and surface profilometry. They were used to examine the surface morphology alterations, mineral content, and surface roughness, respectively.

RESULTS

SEM of enamel which received BAG45S5 showed smoother surface in primary teeth post erosion. EDX analysis showed that enamel exhibited crucial resistance to mineral loss in the group which received BAG45S5 prior to inducing erosion as compared to the induced erosion-only group. This was significant (p < 0.005) in both human dentitions. Erosion-only groups showed significantly less surface roughness in permanent teeth (p < 0.045). A marked decrease in surface roughness was observed in surfaces receiving BAG45S5, primary teeth (p < 0.001), and permanent teeth (p < 0.001).

CONCLUSIONS

Bioactive Glass 45S5 proved successful against erosive conditions in both primary and permanent teeth with better performance in the permanent teeth so it can be regarded as a means of prevention.

CLINICAL RELEVANCE

Bioactive Glass 45S5 powder could be used not only to remove stains but also as a prophylactic preventive measure against the multiple episodes of acidic food and beverage consumption in children.

Remineralization effects of Er,Cr:YSGG and/or bioactive glass on human enamel after radiotherapy-an in vitro study

The aim was to evaluate the effects of Er,Cr:YSGG and/or bioactive glass 45S5 (BG) on the chemical and physical properties of enamel after radiotherapy. Third molar crowns were cut in half (buccal-lingually), and the mid part of the labial/oral surface was subjected to different protocols. All samples were treated with standard 70 Gy. After radiotherapy, enamel was treated with either Er,Cr:YSGG (2780 nm; pulse 60 μs) and BG or only BG, and control samples were kept in deionized water. Vickers microhardness, scanning electron microscopy (SEM), and characteristic X-ray spectroscopy (EDS) were performed before, after radiotherapy, and after treatment. Analysis of variance (ANOVA) was used. A significant drop in enamel microhardness was observed after radiotherapy (p < 0.001). After Er,Cr:YSGG and BG or BG alone, there was a significant increase in microhardness (p < 0.001), which was on average significantly higher compared to the initial measurements for Er,Cr:YSGG with BG (p < 0.001), but not observed in BG alone (p = 0.331). After radiotherapy, SEM showed increased surface roughness with eroded prisms. Er,Cr:YSGG and BG or BG alone both showed disorderly packed glass particles on the enamel surface. Radiotherapy noticeably reduced the concentrations of calcium and phosphorus. Er,Cr:YSGG and BG treatment increased the concentrations of calcium, sodium, phosphorus, and silicate. BG treatment alone increased the concetration of calcium and phosphorus. Directly induced radiotherapy led to potential damage of enamel, but afterwards treatment with Er,Cr:YSGG laser and BG resulted in a higher increase of enamel microhardness compared to BG alone, reflecting in a possible better remineralization effect.

The effect of minimally invasive treatments on enamel microhardness and resistance to further demineralization

Objectives: The present study aimed to compare microhardness of inactive proximal lesions treated by resin infiltration, Er:YAG laser + resin infiltration and Bioactive glass, and investigate the resistance of treated lesions to further demineralization challenge. Methods: In this in-vitro study, 30 human molars with inactive proximal lesions were selected and randomly divided into three groups of 10. In group 1 (resin infiltration), the lesions were treated by a resin infiltrant (Icon). In group 2, the surface was conditioned by an Er:YAG laser prior to resin infiltration. The specimens in group 3 were remineralized by bioactive glass. The treated specimens were kept in artificial saliva for 1 week and then immersed in a demineralization solution for 8 weeks. Surface microhardness was measured at baseline (T0), after remineralization (T1) and after exposure to the demineralization solution (T2), and the difference in microhardness between time points (ΔVHN) was calculated. Results: Microhardness after demineralization (T2) was significantly lower than those of other intervals (P0.05). The statistical analysis revealed no significant difference either in ΔVHNT1-T0 or in ΔVHNT2-T1 among the study groups (P>0.05) Conclusion: Pretreatment by the Er:YAG laser prior to resin infiltration was more effective that other treatments in enhancing microhardness and protecting the tooth against acidic challenge. However, the difference between groups did not reach a statistical significance, implying the need for further studies to achieve more conclusive results.

Remineralization of Artificially Demineralized Human Enamel and Dentin Samples by Zinc-Carbonate Hydroxyapatite Nanocrystals

(1) Background: Decalcified enamel and dentin surfaces can be regenerated with non-fluoride-containing biomimetic systems. This study aimed to investigate the effect of a zinc carbonate-hydroxyapatite-containing dentifrice on artificially demineralized enamel and dentin surfaces. (2) Methods: Human enamel and dentin discs were prepared and subjected to surface demineralization with 30% orthophosphoric acid for 60 s. Subsequently, in the test group (n = 20), the discs were treated three times a day for 3 min with a zinc carbonate-hydroxyapatite-containing toothpaste (biorepair^®). Afterwards, all samples were gently rinsed with PBS (5 s) and stored in artificial saliva until next use. Samples from the control group (n = 20) received no dentifrice-treatment and were stored in artificial saliva, exclusively. After 15 days of daily treatment, specimens were subjected to Raman spectroscopy, energy-dispersive X-ray micro-analysis (EDX), white-light interferometry, and profilometry. (3) Results: Raman spectroscopy and white-light interferometry revealed no significant differences compared to the untreated controls. EDX analysis showed calcium phosphate and silicon dioxide precipitations on treated dentin samples. In addition, treated dentin surfaces showed significant reduced roughness values. (4) Conclusions: Treatment with biorepair^® did not affect enamel surfaces as proposed. Minor mineral precipitation and a reduction in surface roughness were detected among dentin surfaces only.

Effect of Dentin Desensitizer Containing Novel Bioactive Glass on the Permeability of Dentin

The objective of this study was to evaluate the effect of novel bioactive glass (BAG)-containing desensitizers on the permeability of dentin. Experimental dentin desensitizers containing 3 wt% BAG with or without acidic functional monomers (10-MDP or 4-META) were prepared. A commercial desensitizer, Seal & Protect (SNP), was used as a control. To evaluate the permeability of dentin, real-time dentinal fluid flow (DFF) rates were measured at four different time points (demineralized, immediately after desensitizer application, after two weeks in simulated body fluid (SBF), and post-ultrasonication). The DFF reduction rate (ΔDFF) was also calculated. The surface changes were analyzed using field emission scanning electron microscopy (FE-SEM). Raman spectroscopy was performed to analyze chemical changes on the dentin surface. The ΔDFF of the desensitizers containing BAG, BAG with 10-MDP, and BAG with 4-META significantly increased after two weeks of SBF storage and post-ultrasonication compared to the SNP at each time point (p < 0.05). Multiple precipitates were observed on the surfaces of the three BAG-containing desensitizers. Raman spectroscopy revealed hydroxyapatite (HAp) peaks on the dentin surfaces treated with the three BAG-containing desensitizers. Novel BAG-containing dentin desensitizers can reduce the DFF rate about 70.84 to 77.09% in the aspect of reduction of DFF through the HAp precipitations after two weeks of SBF storage.