Simultaneous Partial Nitrification and Denitrification Maintained in Membrane Bioreactor for Nitrogen Removal and Hydrogen Autotrophic Denitrification for Further Treatment

Revamping of a Full-Scale Membrane Plant for Landfill Leachate Pretreatment Using Partial Nitritation

This paper describes a case study involving a revamping of a full-scale membrane bioreactor that treats landfill leachate and other liquid wastes. The main change was the introduction of nitritation/denitritation in alternating cycles instead of the classic denitrification/nitrification process, together with the installation of fine bubble diffusers, a reduction in the volume of the biological compartment, and an increase in the equalization volume. The most significant results were obtained for the biological compartment, with a decrease in the specific energy consumption of 46.6%. At the same time, the removal efficiency of COD, BOD, and TN substantially remained the same before and after plant revamping, while the removal efficiency of TP increased over the years, reaching an average value of almost 71%. Regarding the ultrafiltration unit, the specific flux (or permeability) was characterized by an increasing trend. At the same time, the specific energy consumption of this section decreased by 9.4%. These results led to the conclusion that the changes introduced with the revamp led to a more stable process, a reduction in membrane fouling, and important energy savings.

Anticancer drugs impact the performance and prokaryotic microbiome of an aerobic granular sludge system operated in a sequential batch reactor

Increased concerns exist about the presence of anticancer drugs in wastewater. However, knowledge of the impacts of anticancer drugs on the performance of the system and microbial communities during wastewater treatment processes is limited. We examined the effect of three anticancer drugs commonly detected in influents of wastewater treatment plants applied at three different concentration levels on the performance, efficiency of anticancer drug removal, and prokaryotic microbiome in an aerobic granular sludge system (AGS) operated in a sequential batch reactor (SBR). We showed that an AGS can efficiently remove anticancer drugs, with removal rates in the range of 53-100% depending on the type of drug and concentration level. Anticancer drugs significantly decreased the abundance of total bacterial and archaeal communities, an effect that was linked to reduced nitrogen removal efficiency. Anticancer drugs also reduced the diversity, altered the prokaryotic community composition, reduced network complexity, and induced a decrease of a wide range of predicted bacterial functions. Specific bacterial taxa responsive to the addition of anticancer drugs with known roles in nitrification and denitrification were identified. This study shows anticancer drugs should be monitored in the future as they can induce changes in the performance and microbiome of wastewater treatment technologies.

Research progress of novel bio-denitrification technology in deep wastewater treatment

Excessive nitrogen emissions are a major contributor to water pollution, posing a threat not only to the environment but also to human health. Therefore, achieving deep denitrification of wastewater is of significant importance. Traditional biological denitrification methods have some drawbacks, including long processing times, substantial land requirements, high energy consumption, and high investment and operational costs. In contrast, the novel bio-denitrification technology reduces the traditional processing time and lowers operational and maintenance costs while improving denitrification efficiency. This technology falls within the category of environmentally friendly, low-energy deep denitrification methods. This paper introduces several innovative bio-denitrification technologies and their combinations, conducts a comparative analysis of their denitrification efficiency across various wastewater types, and concludes by outlining the future prospects for the development of these novel bio-denitrification technologies.

Advanced Membrane Technologies for Wastewater Treatment and Recycling

In the face of the ever-growing severe problem of water scarcity, wastewater reuse, recycling and resource recovery are increasingly recognized as crucial part of the solution [...].

Simultaneous removal of nitrate and ammonium by hydrogen-based partial denitrification coupled with anammox in a membrane biofilm reactor

Hydrogen-based membrane biofilm reactors (MBfRs) are effective for nitrogen removal. However, the safety of hydrogen limited the application of MBfR. Here, a hydrogen-based partial denitrification system coupled with anammox (H₂-PDA) was constructed in an MBfR for reducing hydrogen demand significantly. The metabolomics and structures of microbial communities were analyzed to determine the phenotypic differences and drivers underlying denitrification, anammox, and H₂-PDA. These findings indicated that total nitrogen (TN) removal increased from 57.1% in S1 to 93.7% in S2. During the H₂-PDA process, partial denitrification and anammox contributed to TN removal by 93.7% and 6.3%, respectively. Community analysis indicated that the H₂-PDA system was dominated by the genus Meiothermus, which is involved in partial denitrification. Collectively, these findings confirmed the feasibility of incorporating the H₂-PDA process in a MBfR and form a foundation for the establishment of novel and practical methods for efficient nitrogen removal.

Enhanced Bio-P removal: Past, present, and future - A comprehensive review

Excess amounts of phosphorus (P) and nitrogen (N) from anthropogenic activities such as population growth, municipal and industrial wastewater discharges, agriculture fertilization and storm water runoffs, have affected surface water chemistry, resulting in episodes of eutrophication. Enhanced biological phosphorus removal (EBPR) based treatment processes are an economical and environmentally friendly solution to address the present environmental impacts caused by excess P present in municipal discharges. EBPR practices have been researched and operated for more than five decades worldwide, with promising results in decreasing orthophosphate to acceptable levels. The advent of molecular tools targeting bacterial genomic deoxyribonucleic acid (DNA) has also helped us reveal the identity of potential polyphosphate-accumulating organisms (PAO) and denitrifying PAO (DPAO) responsible for the success of EBPR. Integration of process engineering and environmental microbiology has provided much-needed confidence to the wastewater community for the successful implementation of EBPR practices around the globe. Despite these successes, the process of EBPR continues to evolve in terms of its microbiology and application in light of other biological processes such as anaerobic ammonia oxidation and on-site carbon capture. This review provides an overview of the history of EBPR, discusses different operational parameters critical for the successful operation of EBPR systems, reviews current knowledge of EBPR microbiology, the influence of PAO/DPAO on the disintegration of microbial communities, stoichiometry, EBPR clades, current practices, and upcoming potential innovations.

Precise portrayal of microscopic processes of wastewater biofilm formation: Taking SiO2 as the model carrier

Precise characterization of the microscopic processes of wastewater biofilm formation is essential for regulating biofilm behavior. Nevertheless, it remains a great challenge. This study investigated biofilm formation on SiO₂ carriers under gradually increasing shear force combining the extended Derjaguin-Landau-Verwey-Overbeek (XDLVO) theory in a Couette-Taylor reactor, and precisely revealed the micro-interface interaction and species colonization during biofilm formation. The results indicated that bacterial reversible adhesion distance on SiO₂ carrier surface was 3.06 ± 0.48 nm. Meanwhile, the secondary minimum of total XDLVO interaction energy could be used as a novel indicator to distinguish biofilm formation stages. The revealed biofilm formation stages were also confirmed by the electrochemical analysis. Additionally, the pioneer species that colonized at first were Comamonadaceae, Azospira, Flavobacterium and Azonexus, while keystone species such as Hydrogenophaga, AKYH767, Aquimonas and Ignavibacterium determined the stability of microbial community. In conclusion, this study provided a methodological example to study wastewater biofilm micro-interface behavior through the integration of an experimental platform as well as multiple monitoring and analysis methods, which opened up new perspectives for biofilm research and provided useful guidance for the regulation of biofilm-related treatment processes and new technology development.

Nitrogen Removal From Nitrate-Containing Wastewaters in Hydrogen-Based Membrane Biofilm Reactors via Hydrogen Autotrophic Denitrification: Biofilm Structure, Microbial Community and Optimization Strategies

The hydrogen-based membrane biofilm reactor (MBfR) has been widely applied in nitrate removal from wastewater, while the erratic fluctuation of treatment efficiency is in consequence of unstable operation parameters. In this study, hydrogen pressure, pH, and biofilm thickness were optimized as the key controlling parameters to operate MBfR. The results of 653.31 μm in biofilm thickness, 0.05 MPa in hydrogen pressure and pH in 7.78 suggesting high-efficiency NO3−−N removal and the NO3−−N removal flux was 1.15 g·m⁻² d⁻¹. 16S rRNA gene analysis revealed that Pseudomonas, Methyloversatilis, Thauera, Nitrospira, and Hydrogenophaga were the five most abundant bacterial genera in MBfRs after optimization. Moreover, significant increases of Pseudomonas relative abundances from 0.36 to 9.77% suggested that optimization could effectively remove nitrogen from MBfRs. Membrane pores and surfaces exhibited varying degrees of calcification during stable operation, as evinced by Ca²⁺ precipitation adhering to MBfR membrane surfaces based on scanning electron microscopy (SEM), atomic force microscopy (AFM) analyses. Scanning electron microscopy–energy dispersive spectrometer (SEM–EDS) analyses also confirmed that the primary elemental composition of polyvinyl chloride (PVC) membrane surfaces after response surface methodology (RSM) optimization comprised Ca, O, C, P, and Fe. Further, X-ray diffraction (XRD) analyses indicated the formation of Ca₅F(PO₄)₃ geometry during the stable operation phase.