Excellent Performance of Fe78Si9B13 Metallic Glass for Activating Peroxymonosulfate in Degradation of Naphthol Green B

Removal of nitrate by FeSiBC metallic glasses: high efficiency and superior reusability

The development of sustainable technologies for efficient nitrate removal has attracted increasing attention, because excessive nitrate emissions can result in serious environmental, economic, and health effects. Herein, we propose to utilize FeSiBC metallic glass (MG) powders as a potential solution for nitrate removal. In terms of removal efficiency and reusability, our results show that the MG powders, as special zero-valent iron carriers, are 2-3 orders of magnitude more efficient in nitrate removal than the previous studies, while maintaining more than 50% nitrate removal efficiency after 9 cycles of reaction. Moreover, the optimal FeSiBC MG dosage, pH value, and temperature for nitrate removal are determined. The mechanism of nitrate removal is also revealed. The present study offers a promising approach to remediate nitrate, one of the world's most widespread water pollutants.

Enhanced degradation performance of Fe75B12.5Si12.5 amorphous alloys on azo dye

The Fe₇₅B_12.5Si_12.5 and Fe₇₅B_12.5C_12.5 amorphous alloy ribbons were prepared by the melt spinning method. The decolorization performances of these ribbons were investigated in details. It is found that the Fe₇₅B_12.5C_12.5 amorphous ribbons and Fe₇₅B_12.5Si_12.5 annealed ribbons only adsorbed the azo dye molecules, with no chemical degradation process. However, the Fe₇₅B_12.5Si_12.5 amorphous ribbons can reduce -N = N- to -NH₂ because of their high reactivity and the local galvanic effect that occurred during the reaction to accelerate electron transfer. The reaction rate constant k_obs is 0.0872 min^-1, 0.0474 min^-1, and 0.0064 min^-1 for Fe₇₅B_12.5Si_12.5 amorphous ribbons, Fe₇₅B_12.5C_12.5 amorphous ribbons, and Fe₇₅B_12.5Si_12.5 annealed ribbons in the same condition, respectively. Fe₇₅B_12.5Si_12.5 amorphous ribbons can effectively degrade Acid Orange II (AO II) azo dyes and achieve decolorization by breaking azo bonds in the dye in a short time, indicating the prominent capacity of Fe₇₅B_12.5Si_12.5 ribbons on the degradation of AO II. Furthermore, the influence of chemical factors such as ribbons thickness, reaction temperature, initial pH, and AO II concentration of the solution on the reaction rate constant k_obs of Fe₇₅B_12.5Si_12.5 amorphous ribbons had also been studied. The k_obs can reach 0.177 min^-1 under optimal conditions. In addition, all the degradation processes in this work were fitted well with the pseudo-first-order kinetic model. The results are guidance for the practical applications, and they have important implications in developing Fe-based amorphous alloys for functional application materials in the field of wastewater treatment.

Design and perspective of amorphous metal nanoparticles from laser synthesis and processing

Amorphous metal nanoparticles (A-NPs) have aroused great interest in their structural disordering nature and combined downsizing strategies (e.g. nanoscaling), both of which are beneficial for highly strengthened properties compared to their crystalline counterparts. Conventional synthesis strategies easily induce product contamination and/or size limitations, which largely narrow their applications. In recent years, laser ablation in liquid (LAL) and laser fragmentation in liquid (LFL) as "green" and scalable colloid synthesis methodologies have attracted extensive enthusiasm in the production of ultrapure crystalline NPs, while they also show promising potential for the production of A-NPs. Yet, the amorphization in such methods still lacks sufficient rules to follow regarding the formation mechanism and criteria. To that end, this article reviews amorphous metal oxide and carbide NPs from LAL and LFL in terms of NP types, liquid selection, target elements, laser parameters, and possible formation mechanism, all of which play a significant role in the competitive relationship between amorphization and crystallization. Furthermore, we provide the prospect of laser-generated metallic glass nanoparticles (MG-NPs) from MG targets. The current and potential applications of A-NPs are also discussed, categorized by the attractive application fields e.g. in catalysis and magnetism. The present work aims to give possible selection rules and perspective on the design of colloidal A-NPs as well as the synthesis criteria of MG-NPs from laser-based strategies.

Role of Boron in Enhancing Electron Delocalization to Improve Catalytic Activity of Fe-Based Metallic Glasses for Persulfate-Based Advanced Oxidation

Metallic glasses (MGs) with superior catalytic performance have recently been recognized as attractive candidates for wastewater treatment. However, further improving their performance will require knowledge of how to precisely regulate their electronic structures via compositional control. Here, two Fe-based MGs (Fe₇₈Si₉B₁₃ and Fe₈₀Si₉B₁₁) were prepared to compare how slightly altering boron content affected their electronic structure and catalytic performance. Density functional theory revealed that the Fe₇₈Si₉B₁₃ MG with 2 atom % higher boron exhibits an attractive electron delocalization, a high persulfate adsorption energy, and a superb work function due to precise regulation of the electronic structure, leading to exceptional degradation performance for seven organic pollutants. Furthermore, it can be reused 23 times without significant deterioration of catalytic performance, amorphous structure, and surface morphology. This work provides a new paradigm for the fundamental theory explaining how electronic structure is controlled by composition, creating a solid foundation to explore novel catalysts for water treatment.

Fe-Based Metallic Glasses and Dyes in Fenton-Like Processes: Understanding Their Intrinsic Correlation

Fe-based metallic glasses have been demonstrated as effective heterogeneous catalysts in Fenton-like processes for dye degradation. Yet, currently corresponding studies have limitations due to the limited study object (dyes) and the correlation between metallic glasses and dye pollutants in Fenton-like processes is still not comprehensively studied. Accordingly, this work intensively investigated the thermal catalytic behavior correlations between two Fe-based metallic glasses (Fe78Si9B13 and Fe73.5Si13.5B9Cu1Nb3) and eight different dyes. Results indicated a lower activation energy in the more active metallic glass and a dependence of the activation energy of Fe-based metallic glasses in dye solutions. In addition, a high H2O2 concentration led to a declined catalytic efficiency but a photo-enhanced Fenton-like process overcame this limitation at high concentration of H2O2 due to the decrease of pH and enhancement of irradiation. Furthermore, the average mineralization rates of Fe78Si9B13 and Fe73.5Si13.5B9Cu1Nb3 have been measured to be 42.7% and 12.6%, respectively, and the correlation between decolorization and mineralization revealed that a faster decolorization in a Fenton-like process contributed to a higher mineralization rate. This work provides an intrinsic viewpoint of the correlation between Fe-based metallic glasses and dyes in Fenton-like processes and holds the promise to further promote the industrial value of metallic glasses.

Fast Activating Persulfate by Crystallization of Fe-Based Metallic Glasses with External Energy

Very recently, crystallization of metallic glasses (MGs) has presented promising properties in the catalytic field. This work has investigated enhanced catalytic performance of crystallized Fe78Si9B13 ribbons for fast activating persulfate (PS) with assistance of UV-vis light and heat. The ribbons were obtained by annealing at 750°C (Fe-A750) and cibacron brilliant yellow 3G-P (BY 3G-P) dye was used as pollutant. The results indicated that UV-vis light had limited capability to enhance PS activation efficiency by crystallized ribbons while the reaction rate using heat at 65°C was 7.5 times higher than at 25°C, suggesting an advanced performance with heat assistance of Fe-A750 ribbons. Activation energy ∆E for Fe-A750 was measured as 44.5 kJ mol-1. In addition, 5 times reusability could be achieved for Fe-A750 ribbons under 45°C without catalytic decay. The surface morphologies of glassy ribbons, as-annealed Fe-A750 ribbons, HCl-treated Fe-A750 ribbons and after-reused Fe-A750 ribbons have also been systematically studied. This work provides a novel clue to promote applicability of novel crystallized ribbons from MGs.

Pt nanoparticles decorated heterostructured g-C3N4/Bi2MoO6 microplates with highly enhanced photocatalytic activities under visible light

Exploring an efficient and photostable heterostructured photocatalyst is a pivotal scientific topic for worldwide energy and environmental concerns. Herein, we reported that Pt decorated g-C₃N₄/Bi₂MoO₆ heterostructured composites with enhanced photocatalytic performance under visible light were simply synthesized by one-step hydrothermal method for methylene blue (MB) dye degradation. Results revealed that the synthetic Pt decorated g-C₃N₄/Bi₂MoO₆ composites with Bi₂MoO₆ contents of 20 wt.% (Pt@CN/20%BMO) presented the highest photocatalytic activity, exhibiting 7 and 18 times higher reactivity than the pure g-C₃N₄ and Bi₂MoO₆, respectively. Structural analyses showed that Bi₂MoO₆ microplates were anchored on the wrinkled flower-like g-C₃N₄ matrix with Pt decoration, leading to a large expansion of specific surface area from 10.79 m²/g for pure Bi₂MoO₆ to 46.09 m²/g for Pt@CN/20%BMO. In addition, the Pt@CN/20%BMO composites exhibited an improved absorption ability in the visible light region, presenting a promoted photocatalytic MB degradation. Quenching experiments were also conducted to provide solid evidences for the production of hydroxyl radicals (^•OH), electrons (e⁻), holes (h⁺) and superoxide radicals (^•O²⁻) during dye degradation. The findings in this critical work provide insights into the synthesis of heterostructured photocatalysts with the optimization of band gaps, light response and photocatalytic performance in wastewater remediation.

Biodegradation of metal complex Naphthol Green B and formation of iron-sulfur nanoparticles by marine bacterium Pseudoalteromonas sp CF10-13

Treatment of metal complex dye wastewater has attracted growing attention due to the degradation-resistant, high cost and potential hazards of current techniques. This study reported a marine bacterium (Pseudoalteromonas sp CF10-13) with potential performance in decolorization and degradation of a metal complex dye-Naphthol Green B (NGB) at wide ranges of salinity, dye concentration and alkalinity under anaerobic conditions. It was inferred that the secretion of electron mediators in soluble extracellular metabolites by P. sp CF10-13 played important roles in NGB decolorization and degradation through extracellular electron transfer. Naphthalenesulfonate, the major structure in NGB molecule, was further degraded into low-toxic benzamide. Black stable iron-sulfur nanoparticles were formed endogenously avoiding H₂S releasing, exogenous sulfur addition and metal sludge in accumulation. Accordingly, this study provided a cost-effective and eco-friendly biodegradation method to refractory NGB, further promoting the understanding of dye resources recovery.

Efficient removal of organic and bacterial pollutants by Ag-La0.8Ca0.2Fe0.94O3-δ perovskite via catalytic peroxymonosulfate activation

Removal of toxic organics and bacterial disinfection are important tasks in wastewater treatment. Most heavy metal-based catalysts for degradation of aqueous organic pollutants in heterogeneous Fenton-like processes suffer from the toxicity of leached metals. The present work reports environmentally benign systems for both degradation of organics and bacterial disinfection. Calcium substituted LaFeO_3-δ perovskite was demonstrated as an efficient catalyst to activate peroxymonosulfate (PMS) for degradation of phenol, methylene blue and rhodamine 6 G. Compared to LaFeO_3-δ and nanocrystal Fe₃O₄, the lattice oxygen vacancies in B-site cation-deficient perovskite of La_0.8Ca_0.2Fe_0.94O₃-_δ (LaCaFeO_3-δ) particles renders this material a greatly improved catalytic performance. Electron paramagnetic resonance (EPR) suggested that both sulfate (SO₄-) and hydroxyl radicals (OH) played critical roles in the advanced oxidation processes. Moreover, silver doped perovskite (Ag-LaCaFeO_3-δ)/PMS successfully inhibited the growth of waterborne pathogen Escherichia coli and Methicillin-resistant Staphylococcus aureus (MRSA) at a lower dose than silver ions, proving a synergetic effect between free radicals and Ag⁺ in killing the bacteria. Therefore, Ag-LaCaFeO_3-δ/PMS would be promising for practical wastewater treatment.

Heat-Activated Persulfate by Fe-Based Metallic Glass: A Comparative Study of Two Dyes

In this work, the heat-activated persulfate (PS) in the presence of Fe78Si9B13 metallic glasses (MGs) shows an extremely difference in degradation of azo dye and triarylmethane dye, where Fe78Si9B13 MGs exhibits a superior activation ability for PS with assistance of heat leading to the fast removal of two dyes. The structural features of Fe78Si9B13 MGs are firstly characterized by X-ray diffraction (XRD) and differential scanning calorimetry (DSC), following analysis of surface topography by scanning electron microscope (SEM). The results show that with the addition of Fe78Si9B13 MGs, the recalcitrant azo dye is completely removed within 5 min while only 6% of removal rate can be achieved without adding MGs, indicating that the refractory azo dye can be easily degraded by sulfate radical (SO4•–) from heat/MGs/PS. On the other hand, no big variation occurs between PS and MGs/PS under heat activation in degrading triarylmethane dye. Sole PS activated by heat results in a fast removal rate, indicating that triarylmethane dye can be easily degraded by PS itself compared to azo dye. The findings in this work present an in-depth understanding of heat/MGs/PS system in dyes degradation.