An Overview of the Analytical Methods for the Determination of Organic Ultraviolet Filters in Cosmetic Products and Human Samples

Biomonitoring of benzophenones in guano samples of wild bats in Poland

Benzophenones (BPs) are substances used in the production of sunscreens, cosmetics, and personal care products. However, there is a lack of knowledge of BPs in wild animals. Therefore, the study aimed to assess the concentration of selected BPs commonly used in the cosmetic industry in guano samples collected from 4 colonies of greater mouse-eared bats (Myotis myotis). Liquid chromatography with tandem mass spectrometry (LC-MS/MS) was used to determine guano concentrations of benzophenone 1 (BP-1), benzophenone 2 (BP-2), benzophenone 3 (BP-3) and benzophenone 8 (BP-8). BP-1 levels above the method quantification limit (MQL) were noted in 97.5% of samples and fluctuated from <0.1 ng/g to 259 ng/g (mean 41.50 ng/g, median 34.8). The second most common was BP-3, which fluctuated from <0.1 ng/g to 19 ng/g (mean 6.67 ng/g, median 5.05), and its levels higher than MQL were observed in 40% of samples. BP-2 and BP-8 concentrations did not exceed the method detection limit (0.04 ng/g) in any analyzed sample. There were visible differences in the BP-1 and BP-3 levels among the studied bat colonies. Mean BP-1 concentration fluctuated from 11.23±13.13 ng/g to 76.71±65.51 ng/g and differed significantly between the colonies. Mean BP-3 concentration fluctuated from 5.03±6.03 ng/g to 9.18±7.65 mg/g, but it did not differ significantly between the colonies. The results show that guano is a suitable matrix for the assessment of wildlife exposure to BPs. This could be particularly advantageous in protected species, where not disturbing and stressing the animals are crucial.

Easy determination of benzophenone and its derivatives in sunscreen samples by direct-immersion solid-phase microextraction and gas chromatography-mass spectrometry

Benzophenones (BPs) absorb different sun radiation wavelengths, making them effective UVA and UVB filters, widely used in industry. In Europe, sunscreen products contain regulated amounts (6 % w/w) of benzophenone-3 (BP-3), usually combined with other filters like octocrylene. BPs are mutagens in UV radiation, and octocrylene may degrade into BPs, making their monitoring crucial. The present manuscript proposed a novel procedure based on liquid-liquid extraction followed by direct-immersion solid-phase microextraction (LLE-DI-SPME) to isolate and determine 10 BPs in sunscreen lotions with potential results. Parameters like extraction solvent, pH, adsorption, desorption time, stirring, sating effect, and presence of organic solvents were optimized and compared with different SPME fibers, being polyacrylate (PA) fiber the most effective. Detection and quantification were performed by gas chromatography-mass-spectrometry. Analytical parameters as limits of detection were 0.05-0.10 µg kg-1, while the linear range was 0.16 up to 2000 µg kg-1. In terms of recovery, the method ranged from 83 % to 103 %; the precision of the method was good in terms of relative standard deviation (RSD) from 3.2 % to 18.7 % and without a remarkable matrix effect (-15.06-8.45 %). Despite the complexity of the samples and the difficulty posed by the DI-SPME technique, the method proved robust. The proposed method successfully detected 10 BPs in 6 different sunscreen lotions. The total presence of BPs in sunscreens ranged from 165 to 931 mg kg-1, with BP-3 detected in all samples from 4.2 to 740 mg kg-1.

Dispersive liquid-liquid microextraction and Monte Carlo simulation of margin of safety for octocrylene, EHMC, 2ES, and homosalate in sunscreens

Dispersive liquid-liquid microextraction (DLLME) using a floating organic drop has been optimized and used for the sample preparation of four commonly used ultraviolet filter (UVF) substances in sunscreens. Plackett-Burman experimental design was used to screen 10 variables in DLLME. The most significant variables were then optimized by using a response surface method with a Box-Behnken design. DLLME followed by an optimized HPLC identified octocrylene, 2-ethylhexyl-4-methoxycinnamate, ethylhexyl salicylate, and homosalate as the frequently found UVFs in commercial sunscreens. The systemic exposure dosage and margin of safety (MoS) for the identified UVFs were estimated using in-use concentrations and application patterns. The average systemic exposure dosage values for octocrylene, 2-ethylhexyl-4-methoxycinnamate, ethylhexyl salicylate, and homosalate were 0.52, 0.61, 0.020, and 0.079 mg/kg body weight per day, respectively. Whereas the average MoS values for individual UVFs ranging from 296 to 3160 were all significantly higher than the limit value of 100, the combined exposure risks were slightly above the limit. The probabilistic health risk assessment using Monte Carlo simulation revealed that the combined MoS values were (mean, 10‰, 90‰) 342, 119, and 441, respectively. Regarding the usage of sunscreen cosmetics containing the UVFs studied, these results indicate a safety concern for those who apply multiple UVF products.

Determination of Benzophenones in Water and Cosmetics Samples: A Comparison of Solid-Phase Extraction and Microextraction by Packed Sorbent Methods

Benzophenones (BPs) are extensively used in a wide variety of cosmetic products and other materials (e.g., textiles or plastics) to avoid damaging effects of UV radiation. In the present work, we compared two extraction methods for the determination of BPs, namely, 2,4-dihydroxybenzophenone (BP-1), 2-hydroxy-4-methoxybenzophenone (BP-3) and 2,2-dihydroxy-4-methoxybenzophenone (BP-8), in water and cosmetics samples. The following extraction methods were used for the research: solid-phase extraction (SPE) and microextraction by packed sorbent (MEPS), whereas analysis was performed by gas chromatography with mass spectrometric detection. A comparison between the methods indicates that the MEPS technique(s) can be reliably used for analysis of BPs (sunscreen residue) in water samples and cosmetic samples with satisfactory results. This microextraction technique is cheap, easy, quick to implement, and consumes small amounts of solvents. On the other hand, the main advantage of the SPE method are low detection limits for the determination of BPs in water samples, i.e., from 0.034 to 0.067 µg L⁻¹, while, for the MEPS method, LODs were at the level of 1.8–3.2 µg L⁻¹. For both methods, the recoveries of BPs were 96–107% and 44–70% for water and cosmetics samples, respectively. The presented methods are suitable for use in cosmetics quality control and environmental pollution assessment.