Electrospun Ceramic Nanofibers for Photocatalysis

Electrospinning Nonspinnable Sols to Ceramic Fibers and Springs

Electrospinning has been applied to produce ceramic fibers using sol gel-based spinning solutions consisting of ceramic precursors, a solvent, and a polymer to control the viscosity of the solution. However, the addition of polymers to the spinning solution makes the process more complex, increases the processing time, and results in porous mechanically weak ceramic fibers. Herein, we develop a coelectrospinning technique, where a nonspinnable sol (<10 mPa s) consisting of only the ceramic precursor(s) and solvent(s) is encapsulated inside a polymeric shell, forming core-shell precursor fibers that are further calcined into ceramic fibers with reduced porosity, decreased surface defects, uniform crystal packing, and controlled diameters. We demonstrate the versatility of this method by applying it to a series of nonspinnable sols and creating high-quality ceramic fibers containing TiO2, ZrO2, SiO2, and Al2O3. The polycrystalline TiO2 fibers possess excellent flexibility and a high Young's modulus reaching 54.3 MPa, solving the extreme brittleness problem of the previously reported TiO2 fibers. The single-component ZrO2 fibers exhibit a Young's modulus and toughness of 130.5 MPa and 11.9 KJ/m3, respectively, significantly superior to the counterparts prepared by conventional sol-gel electrospinning. We also report the creation of ceramic fibers in micro- and nanospring morphologies and examine the formation mechanisms using thermomechanical simulations. The fiber assemblies constructed by the helical fibers exhibit a density-normalized toughness of 3.5-5 times that of the straight fibers due to improved fracture strain. This work expands the selection of the electrospinning solution and enables the development of ceramic fibers with more attractive properties.

Photocatalytic behavior for removal of methylene blue from aqueous solutions via nanocomposites based on Gd2O3/CdS and cellulose acetate nanofibers

Efficient cleaning of contaminated water by photocatalysis has become an effective strategy in recent years due to its environmental and ecological designation. Cadmium sulfate (CdS) is an excellent photocatalyst in the visible region but has low quantum efficiency. In order to increase the photocatalytic efficiency, CdS was modified with gadolinium oxide (Gd2O3) and combined with graphene oxide (GO) nanoparticles. The estimated crystallite size (Ds) for Gd2O3, CdS/Gd2O3, and CdS/Gd2O3@GO was 29.6, 11.6, and 11.5 nm, respectively. The degradation of methylene blue (MB) reaches the highest values after 60 min under visible light irradiation with a dye concentration of (0.25 ppm). Whereas in powdered composition the efficiency of dye removal has been enhanced under UV irradiation, it reduced by increasing the MB concentration to 0.50 ppm with visible light irradiation. In addition, the CdS with/without Gd2O3 and GO were integrated into electrospun nanofibrous cellulose acetate (CA) through the electrospinning technique. The compounds of Gd2O3, CdS/Gd2O3, and CdS/Gd2O3/GO were encapsulated into CA nanofibers for the degradation of MB under visible and UV irradiation. The apparent rate constant (k) achieves a value of 0.006, 0.007, and 0.0013 min-1 while the removal efficiency reaches 41.02%, 54.71%, and 71.42% for Gd2O3@CA, CdS/Gd2O3@CA, and CdS/Gd2O3/GO@CA, respectively, after 60 min under UV irradiation.

Rational construction of ZnO/CuS heterostructures-modified PVDF nanofiber photocatalysts with enhanced photocatalytic activity

PVDF/ZnO/CuS photocatalysts with ZnO/CuS heterojunctions were synthesized via electrospinning, hydrothermal, and ion-exchange techniques. As matrix materials, electrospun PVDF nanofibers are easy to be recycled and reused. ZnO nanorods anchored on PVDF nanofiber with high specific surface area provide abundant active reaction sites for photocatalysis. While the loaded CuS nanoparticles as a photosensitizer compensate the low quantum efficiency of ZnO and improve the visible-light photocatalytic efficiency. As a result, the PVDF/ZnO/CuS composited photocatalyst exhibits outstanding photocatalytic performance in exposure to UV and visible light owing to the suppressed recombination of electron-hole pairs and widened visible light absorption range. The kinetic constants of PVDF/ZnO/CuS nanocomposites under UV irradiation (9.01 × 10^-3 min^-1) and visible light (6.53 × 10^-3 min^-1) irradiation were 3.66 and 2.53 times higher than that of PVDF/ZnO (2.46 × 10^-3 min^-1 & 2.58 × 10^-3 min^-1), respectively. Furthermore, PVDF/ZnO/CuS nanocomposites demonstrate excellent robustness in terms of recycling and reuse, which is advantageous in practical applications.

The Research Progress in the Application of Ceramic Nanofibers in Antibacterial Textile Materials

In order to investigate the application effect of ceramic nanofibers in antibacterial textile materials and improve the comprehensive use efficiency of antibacterial textile materials, ceramic nanofibers were introduced firstly and their fabrication methods and specific functions were discussed. Then, the antibacterial textile materials were introduced and their main uses and contributions were discussed. Finally, the application of ceramic nanofibers in antibacterial textile materials was investigated based on CiteSpace software. The results showed that the research on ceramic nanofibers had increased rapidly since 2000. Also, the number of the foreign literature retrieval was about 9,200 at most and 6,300 at least. The number of Chinese literature was about 6,000 at most and 1,000 at least. It can be seen that the current research of ceramic nanofibers is quite mature. But the quantity of the research on ceramic nanofibers in the application of antibacterial materials is relatively small. In the foreign literature retrieval, the number of the literature was about 1,300 at most and about 220 at least. In the Chinese literature retrieval, the number of the literature was about 600 at most and about 30 at least. It can be seen that the current domestic research on the application of ceramic nanofibers in antibacterial textile materials is not mature, but the foreign research is relatively good. The research not only provides a reference for the further research of ceramic nanofibers but also contributes to the improvement of antibacterial textile materials.