Recent Trends and Advances of Co3O4 Nanoparticles in Environmental Remediation of Bacteria in Wastewater

Biologically inspired nanoformulations for the control of bacterial canker pathogens Clavibacter michiganensis subsp. michiganensis and subsp. capsici

Clavibacter michiganensis subsp. michiganensis (Cmm) and C. michiganensis subsp. capsici (Cmc) are phytopathogenic bacteria that cause bacterial canker disease in tomatoes and peppers, respectively. Bacterial canker disease poses serious challenges to solanaceous crops, causing significant yield losses and economic costs. Effective management necessitates the development of sustainable control strategies employing nanobiotechnology. In this study, the antibacterial effects of four Aspergillus sojae-mediated nanoformulations, including cobalt oxide nanoparticles (Co3O4 NPs), zinc oxide nanoparticles (ZnO NPs), cobalt ferrite nanoparticles (CoFe2O4 NPs), and CoFe2O4/functionalized multi-walled carbon nanotube (fMWCNT) bionanocomposite, were evaluated against Cmm and Cmc. The diameters of the zone of inhibition of A. sojae-mediated Co3O4 NPs, ZnO NPs, CoFe2O4 NPs, and CoFe2O4/fMWCNT bionanocomposite against Cmm and Cmc were 23.60 mm, 22.09 mm, 27.65 mm, 22.51 mm, and 19.33 mm, 17.66 mm, 21.64 mm, 18.77 mm, respectively. The broth microdilution assay was conducted to determine the minimal inhibitory and bactericidal concentrations. The MICs of Co3O4 NPs, ZnO NPs, CoFe2O4 NPs, and CoFe2O4/fMWCNT bionanocomposite against Cmm were 2.50 mg/mL, 1.25 mg/mL, 2.50 mg/mL, and 2.50 mg/mL, respectively. While, their respective MBCs against Cmm were 5.00 mg/mL, 2.50 mg/mL, 5.00 mg/mL, and 5.00 mg/mL. The respective MICs of Co3O4 NPs, ZnO NPs, CoFe2O4 NPs, and CoFe2O4/fMWCNT bionanocomposite against Cmc were 2.50 mg/mL, 1.25 mg/mL, 5.00 mg/mL, and 5.00 mg/mL. While, their respective MBCs against Cmc were 5.00 mg/mL, 2.50 mg/mL, 10.00 mg/mL, and 10.00 mg/mL. The morphological and ultrastructural changes of Cmm and Cmc cells were observed using field-emission scanning and transmission electron microscopy before and after treatment with sub-minimal inhibitory concentrations of the nanoformulations. Nanoformulation-treated bacterial cells became deformed and disrupted, displaying pits, deep cavities, and groove-like structures. The cell membrane detached from the bacterial cell wall, electron-dense particles accumulated in the cytoplasm, cellular components disintegrated, and the cells were lysed. Direct physical interactions between the prepared nanoformulations with Cmm and Cmc cells might be the major mechanism for their antibacterial potency. Further research is required for the in vivo application of the mycosynthesized nanoformulations as countermeasures to combat bacterial phytopathogens.

Pseudomonas aeruginosa and related antibiotic resistance genes as indicators for wastewater treatment

This review aims to examine the existence of Pseudomonas aeruginosa (P. aeruginosa) and their antibiotic resistance genes (ARGs) in aquatic settings and the alternative treatment ways. P. aeruginosa in a various aquatic environment have been identified as contaminants with impacts on human health and the environment. P. aeruginosa resistance to multiple antibiotics, such as sulfamethoxazole, ciprofloxacin, quinolone, trimethoprim, tetracycline, vancomycin, as well as specific antibiotic resistance genes including sul1, qnrs, blaVIM, blaTEM, blaCTX, blaAIM-1, tetA, ampC, blaVIM. The development of resistance can occur naturally, through mutations, or via horizontal gene transfer facilitated by sterilizing agents. In addition, an overview of the current knowledge on inactivation of Pseudomonas aeruginosa and ARG and the mechanisms of action of various disinfection processes in water and wastewater (UV chlorine processes, catalytic oxidation, Fenton reaction, and ozonation) is given. An overview of the effects of nanotechnology and the resulting wetlands is also given.

Recent advances of modification effect in Co3O4-based catalyst towards highly efficient photocatalysis

Tricobalt tetroxide (Co3O4) has been developed as a promising photocatalyst material for various applications. Several reports have been published on the self-modification of Co3O4 to achieve optimal photocatalytic performance. The pristine Co3O4 alone is inadequate for photocatalysis due to the rapid recombination process of photogenerated (PG) charge carriers. The modification of Co3O4 can be extended through the introduction of doping elements, incorporation of supporting materials, surface functionalization, metal loading, and combination with other photocatalysts. The addition of doping elements and support materials may enhance the photocatalysis process, although these modifications have a slight effect on decreasing the recombination process of PG charge carriers. On the other hand, combining Co3O4 with other semiconductors results in a different PG charge carrier mechanism, leading to a decrease in the recombination process and an increase in photocatalytic activity. Therefore, this work discusses recent modifications of Co3O4 and their effects on its photocatalytic performance. Additionally, the modification effects, such as enhanced surface area, generation of oxygen vacancies, tuning the band gap, and formation of heterojunctions, are reviewed to demonstrate the feasibility of separating PG charge carriers. Finally, the formation and mechanism of these modification effects are also reviewed based on theoretical and experimental approaches to validate their formation and the transfer process of charge carriers.

The Addition of Co into CuO-ZnO Oxides Triggers High Antibacterial Activity and Low Cytotoxicity

In the present work, a simple two-step method is proposed for mixed oxide synthesis aimed at the achievement of antibacterial nanomaterials. In particular, Cu, Zn and Co have been selected to achieve single-, double- and triple-cation oxides. The synthesized samples are characterized by XRD, IR, SEM and EDX, indicating the formation of either crystalline or amorphous hydrocarbonate precursors. The oxides present one or two crystalline phases, depending on their composition; the triple-cation oxides form a solid solution of tenorite. Also, the morphology of the samples varies with the composition, yielding nanoparticles, filaments and hydrangea-like microaggregates. The antibacterial assays are conducted against E. coli and indicate an enhanced efficacy, especially displayed by the oxide containing 3% Co and 9% Zn incorporated into the CuO lattice. The oxides with the highest antibacterial properties are tested for their cytotoxicity, indicating a low toxicity impact, in line with literature data.

Interfacial charge transfer of Carrisa edulis fruit extract capped Co3O4 nanoparticles on the surface of MK30: An efficient photocatalytic removal of methylthioninium chloride and tetracycline organic pollutants

The in-depth usage of organic pollutants by pharmaceutical industries constitutes a major contaminant to the bodies of water due to their solubility, great mobility, ability to get attached to water bodies for a long period of time, and low biodegradability. Due to these, it may further cause disease and change the ecosystem of aqueous and other living organisms. Accordingly, effective removal of organic contaminants from waste water is a vital step in reducing the hazards. Photocatalysis is a potential technique for removing hazardous organic pollutants from wastewater. In this work, a simple ultra-sonication assisted approach, a series of Carrisa edulis fruit extract capped Co₃O₄ nanoparticles decorated on Montmorillonite K30 nanosheets (Co₃O₄/MK30) were prepared. The inherent physicochemical appearance and optical properties of as-prepared nanomaterials were investigated using a variety of analytical techniques. TEM analysis depicted the spherical shape of the Co₃O₄ NPs with the size of 11.25 nm. The degradation of methylthioninium chloride as a dye and tetracycline drug pollutants has been investigated in this study using individual and simultaneous photocatalysis systems in the presence of pure Co₃O₄ NPs and different ratios of Co₃O₄/MK30 nanocomposites. Owing to the generation of OH and O₂ radicals, the 20% loaded Co₃O₄ on MK30 had the best photocatalytic performance of methylthioninium chloride (98.12%) and tetracycline degradation (87.4%), on exposing it to visible light. This research introduces a new design for MK30-based nanomaterials and proposes its use in environmental challenges.

Sustainable and Efficacy Approach of Green Synthesized Cobalt Oxide (Co3O4) Nanoparticles and Evaluation of Their Cytotoxicity Activity on Cancerous Cells

In this study, rosemary leaf extract was effectively used to synthesize cobalt oxide nanoparticles (Co₃O₄ NPs) using a rapid, low-cost, and environmentally friendly approach. The prepared Co₃O₄ NPs were examined using various analytical techniques. However, UV spectrum analysis displayed two sharp absorption peaks at ~350 and 745 nm. The dynamic light scattering and zeta potential measurements were used to evaluate the particle size and the effective stabilization of the synthetic nanoparticles in the suspensions. A semi-triangular pyramidal shape of the Co₃O₄ NPs with a wide particle-size distribution could be observed in the scanning electron microscopy images. The energy-dispersive X-ray spectrum confirmed their successful synthesis, as the experimental atomic percentages agreed with the theoretical values. Moreover, X-ray diffraction analysis revealed that the synthesized Co₃O₄ NPs had a cubic crystalline structure corroborating that of theoretical Co₃O₄. Additionally, the Co₃O₄ NPs were not toxic at ≤62.5 µg/mL for Hep G2 and at ≤31.25 µg/mL for Mcf7. Therefore, these unique environmentally friendly Co₃O₄ NPs at this safe concentration could be studied in the future for their therapeutic activity.