Influence of Oil-Pressboard Mass Ratio on the Equilibrium Characteristics of Furfural under Oil Replacement Conditions

Investigation of Novel Solid Dielectric Material for Transformer Windings

Improvement techniques aimed at enhancing the dielectric strength and minimizing the dielectric loss of insulation materials have piqued the interest of many researchers. It is worth noting that the electrical breakdown traits of insulation material are determined by their electrochemical and mechanical performance. Possible good mechanical, electrical, and chemical properties of new materials are considered during the generation process. Thermoplastic polyurethane (TPU) is often used as a high-voltage insulator due to its favorable mechanical properties, high insulation resistance, lightweight qualities, recovery, large actuation strain, and cost-effectiveness. The elastomer structure of thermoplastic polyurethane (TPU) enables its application in a broad range of high-voltage (HV) insulation systems. This study aims to evaluate the feasibility of using TPU on transformer windings as a solid insulator instead of pressboards. The investigation conducted through experiments sheds light on the potential of TPU in expanding the range of insulating materials for HV transformers. Transformers play a crucial role in HV systems, hence the selection of suitable materials like cellulose and polyurethane is of utmost importance. This study involved the preparation of an experimental setup in the laboratory. Breakdown tests were conducted by generating a non-uniform electric field using a needle-plane electrode configuration in a test chamber filled with mineral oil. Various voltages ranging from 14.4 kV to 25.2 kV were applied to induce electric field stress with a step rise of 3.6 kV. The partial discharges and peak numbers were measured based on the predetermined threshold values. The study investigated and compared the behaviors of two solid insulating materials under differing non-electric field stress conditions. Harmonic component analysis was utilized to observe the differences between the two materials. Notably, at 21.6 kV and 25.2 kV, polyurethane demonstrated superior performance compared to pressboard with regards to the threshold value of leakage current.

Degree of polymerization mapping Raman feature extraction of oil-paper insulation aging based on quadratic mutual information

To assess the aging of oil-paper insulation, an accelerated aging experiment is executed. Raman spectroscopy, a nondestructive detection method with access to component identification and fault diagnosis, is used to analyze the aging of oil-paper insulation. Raman feature of oil-paper insulation aging with a close relationship with the degree of polymerization is obtained based on the concept of quadratic mutual information. By analyzing the relationship between the extracted feature and the degree of polymerization of samples at different aging degrees, the feasibility of reflecting the aging degree of oil-paper insulation is determined. By load analysis, the chemical correlation between the extracted feature and oil-paper insulation aging is clarified. For eight test samples, the prediction error of degree of polymerization based on Raman features is less than 50. These results show that the features extracted in this paper are helpful to realizing the Raman spectrum diagnosis of oil-paper insulation aging.