Adsorption and Separation of the H2O/H2SO4 and H2O/C2H5OH Mixtures: A Simulated and Experimental Study

Natural Zeolite for The Purification of Saline Groundwater and Irrigation Potential Analysis

Groundwater is one of the main sources of water for irrigation used worldwide. However, the application of the resource is threatened by the possibility of high saline levels, especially in low-lying coastal regions. Furthermore, the lack of readily accessible materials for successful treatment procedures makes the purification of such water a constant challenge. Based on the fact that natural zeolite is one of the easily accessible and relatively cheap filter materials, this study examined the potential use of high-salinity groundwater filtered by natural zeolite for irrigation. Zeolite-filled filters at two different depths (0.5 m and 1 m) were studied. The samples were collected from the low-lying areas of Dar es Salaam City, Tanzania. The study observed that when the raw groundwater samples were exposed to the 0.5 m column depth, sodium (Na⁺) had the lowest removal efficiency at 40.2% and calcium (Ca²⁺) had the highest removal efficiency at 98.9%. On the other hand, magnesium (Mg²⁺) had the lowest removal efficiency, at about 61.2%, whereas potassium (K⁺) had up to about 99.7% removal efficiency from the 1 m column depth treatment system. Additionally, from the salinity hazard potential analysis, most of the samples fell within C4 (based on the electrical conductivity), which is a "very high salinity" class, and based on the quality it means the water cannot be directly applied for irrigation purposes. From the 0.5 m column depth, most of the samples fell within C3 (the "high salinity" class), and from the 1 m column depth most of the samples fell within C1 ("low salinity" class). The findings of this study offer some valuable insight into the prospective use of natural zeolite for the filtration of saline groundwater before its application for irrigation.

Review of the Pressure Swing Adsorption Process for the Production of Biofuels and Medical Oxygen: Separation and Purification Technology

The production of biofuels has had a great impact on climate change and the reduction of the use of fossil fuels. There are different technologies used for the separation and production of biofuels, which allow having compounds such as ethanol, methane, oxygen, and hydrogen, one of these promising technologies is the Pressure Swing Adsorption process (PSA). The objectives of this article focus on the production and purification of compounds that achieve purities of 99.5% bioethanol, 94.85% biohydrogen, 95.00% medical oxygen, and 99.99% biomethane through the PSA process; also, a significant review is contemplated to identify the different natural and synthetic adsorbents that have greater adsorption capacity, the different configurations in which a PSA operates are studied and identified, and the different mathematical models that describe the dynamic behavior of all the variables are established that interact in this PSA process, parametric studies are carried out in order to identify the variables that have the greatest effect on the purity obtained. The results obtained in this review allow facilitating the calculation of parameters, the optimization of the process, the automatic control to manipulate certain variables and to achieve the rejection of disturbances to have a recovery and production of biofuels with a high degree of purity.

A New Study on the Eastern Flank of the Loma Blanca Deposit (Cuba) to Establish the Mineralogical, Chemical, and Pozzolanic Properties of Zeolitised Tuffs

The geological nature of the territory of the Republic of Cuba has favoured the formation of large and varied deposits of volcanic tuffs enriched by various species of zeolites. Today, new zeolite deposits continue to be discovered in the country. This work aims to present the results of a study carried out in an unexplored area that is located approximately 1.2 km east of the Loma Blanca deposit, outside the mining operation limits. To carry out this research and to establish a qualitative comparison between both sample populations, four samples were taken from the study area, and another four were taken from the Loma Blanca deposit. The characterisation of the samples was performed by XRD, SEM, and XRF. The pozzolan quality was determined by the pozzolanicity test (PT) and quality chemical analysis (QCA). Finally, a study of the mechanical strength (MST) was performed at 7, 28, and 90 days, using mortar specimens made with PC/ZT: 75–25% and PC/ZT: 70–30%, respectively. The results of the studies using XRD, SEM, and XRF indicated that both groups of samples had a similar complex mineralogical composition, consisting mainly of mordenite and clinoptilolite accompanied by secondary phases such as quartz and amorphous materials in the form of altered glass. The pozzolanicity test showed that both the samples from the study area and those from the Loma Blanca deposit behaved like typical pozzolans, which is a trend that can be seen in the high values of mechanical strength to compression up to 72 MPa for the PC/ZT: 75–25% formulation and 66 MPa for the PC/ZT: 70–30%. The results obtained establish that the zeolite varieties detected in the study area are similar to those of the Loma Blanca deposit, which could have a positive impact on the increase in current reserves, especially for manufacturing pozzolanic cements with properties that contribute to the preservation of the environment.

Exploring the Properties of Micronized Natural Zeolitic Volcanic Tuff as Cosmetic Ingredient

This study explores the characteristics of a micronized natural zeolitic volcanic tuff (MZ) as ingredient in cosmetic formulations. In particular, the purpose was to prepare and investigate the organoleptic and physicochemical properties of two representative cosmetic formulations containing MZ. The MZ samples were characterized using X-ray fluorescence (XRF), X-ray diffraction (XRD) and Fourier transform infrared (FT-IR) spectroscopy. pH, cation exchange capacity (CEC), apparent density, chemical composition and particle size distribution of MZ samples were also determined. The micronization treatment applied did not produce significant structural and physicochemical changes with respect to the raw zeolitic volcanic tuff. The prepared formulations containing 5% MZ with different particle sizes (100-125 µm and 125-250 µm) were subjected to preliminary and accelerated stability tests, and the pH and organoleptic properties were also evaluated. The cosmetic formulations presented a pH of 4.3, a pleasant touch, good spreadability, easy application on skin, no color alteration and a good stability after 15, 30 and 60 days of storage at room temperature, low temperature and freezer during the accelerated stability tests. The obtained results endorse the MZ as suitable for the development of formulations exploiting the clinoptilolite properties as a cosmetic ingredient.