Air Pollution Analysis during the Lockdown on the City of Milan

Seasonal and Spatial Variations of the Oxidative Properties of Ambient PM2.5 in the Po Valley, Italy, before and during COVID-19 Lockdown Restrictions

This study describes the chemical and toxicological characteristics of fine particulate matter (PM_2.5) in the Po Valley, one of the largest and most polluted areas in Europe. The investigated samples were collected in the metropolitan area of Milan during the epidemic lockdown and their toxicity was evaluated by the oxidative potential (OP), measured using ascorbic acid (OP^AA) and dithiothreitol (OP^DTT) acellular assays. The study was also extended to PM_2.5 samples collected at different sites in the Po Valley in 2019, to represent the baseline conditions in the area. Univariate correlations were applied to the whole dataset to link the OP responses with the concentrations of the major chemical markers of vehicular and biomass burning emissions. Of the two assays, OP^AA was found mainly sensitive towards transition metals released from vehicular traffic, while OP^DTT towards the PM carbonaceous components. The impact of the controlling lockdown restrictions on PM_2.5 oxidative properties was estimated by comparing the OP values in corresponding time spans in 2020 and 2019. We found that during the full lockdown the OP^AA values decreased to 80-86% with respect to the OP data in other urban sites in the area, while the OP^DTT values remained nearly constant.

Contributions of Traffic and Industrial Emission Reductions to the Air Quality Improvement after the Lockdown of Wuhan and Neighboring Cities Due to COVID-19

Wuhan was locked down from 23 January to 8 April 2020 to prevent the spread of the novel coronavirus disease 2019 (COVID-19). Both public and private transportation in Wuhan and its neighboring cities in Hubei Province were suspended or restricted, and the manufacturing industry was partially shut down. This study collected and investigated ground monitoring data to prove that the lockdowns of the cities had significant influences on the air quality in Wuhan. The WRF-CMAQ (Weather Research and Forecasting-Community Multiscale Air Quality) model was used to evaluate the emission reduction from transportation and industry sectors and associated air quality impact. The results indicate that the reduction in traffic emission was nearly 100% immediately after the lockdown between 23 January and 8 February and that the industrial emission tended to decrease by about 50% during the same period. The industrial emission further deceased after 9 February. Emission reduction from transportation and that from industry was not simultaneous. The results imply that the shutdown of industry contributed significantly more to the pollutant reduction than the restricted transportation.

Overview of Vehicle Exhaust Particle Number Regulations

Vehicle emissions are a significant source of air pollution in cities. Particulate matter (PM) is a pollutant with adverse health effects. Regulations worldwide determine the PM exhaust emissions of vehicles by gravimetric quantification of the mass deposited on a filter over a test cycle. The introduction of particulate filters as vehicle exhaust gas aftertreatment devices led to low PM emissions. A particle number methodology (counting solid particles > 23 nm), complementary to the PM mass measurement, was developed by the PMP (Particle Measurement Programme) group of the GRPE (Working Party on Pollution and Energy) of the UNECE (United Nations Economic Commission for Europe) during the first decade of the 21st century. The methodology was then introduced in the EU (European Union) regulations for light-duty (2011), heavy-duty (2013), and non-road mobile machinery (2019). In parallel, during the last 15 years, UN (United Nations) regulations and GTRs (Global Technical Regulations) including this methodology were also developed. To address the on-road emissions, the EU introduced RDE (real-driving emissions) testing with PEMS (portable emissions measurement systems) in 2017. Other countries (e.g., China, India) have also started adopting the number methodology. The PMP group recently improved the current laboratory and on-board methodologies and also extended them to a lower particle size (counting solid particles > 10 nm). Due to the rapid evolution of the vehicle exhaust particle number regulations and the lack of a summary in the literature, this paper gives an overview of current and near future regulations. Emphasis is given on the technical specifications and the changes that have taken place over the years.