1
|
Gómez-Astorga MJ, Villagra-Mendoza K, Masís-Meléndez F, Ruíz-Barquero A, Rimolo-Donadio R. Calibration of Low-Cost Moisture Sensors in a Biochar-Amended Sandy Loam Soil with Different Salinity Levels. SENSORS (BASEL, SWITZERLAND) 2024; 24:5958. [PMID: 39338703 PMCID: PMC11436195 DOI: 10.3390/s24185958] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Grants] [Track Full Text] [Subscribe] [Scholar Register] [Received: 08/03/2024] [Revised: 09/08/2024] [Accepted: 09/09/2024] [Indexed: 09/30/2024]
Abstract
With the increasing focus on irrigation management, it is crucial to consider cost-effective alternatives for soil water monitoring, such as multi-point monitoring with low-cost soil moisture sensors. This study assesses the accuracy and functionality of low-cost sensors in a sandy loam (SL) soil amended with biochar at rates of 15.6 and 31.2 tons/ha by calibrating the sensors in the presence of two nitrogen (N) and potassium (K) commercial fertilizers at three salinity levels (non/slightly/moderately) and six soil water contents. Sensors were calibrated across nine SL-soil combinations with biochar and N and K fertilizers, counting for 21 treatments. The best fit for soil water content calibration was obtained using polynomial equations, demonstrating reliability with R2 values greater than 0.98 for each case. After a second calibration, low-cost soil moisture sensors provide acceptable results concerning previous calibration, especially for non- and slightly saline treatments and at soil moisture levels lower than 0.17 cm3cm-3. The results showed that at low frequencies, biochar and salinity increase the capacitance detected by the sensors, with calibration curves deviating up to 30% from the control sandy loam soil. Due to changes in the physical and chemical properties of soil resulting from biochar amendments and the conductive properties influenced by fertilization practices, it is required to conduct specific and continuous calibrations of soil water content sensor, leading to better agricultural management decisions.
Collapse
Affiliation(s)
- María José Gómez-Astorga
- Agricultural Engineering, CETIA Centro de Investigación y Extensión en Tecnología e Ingeniería Agrícola, Instituto Tecnológico de Costa Rica, Cartago P.O. Box 159-7050, Costa Rica
| | - Karolina Villagra-Mendoza
- Agricultural Engineering, CETIA Centro de Investigación y Extensión en Tecnología e Ingeniería Agrícola, Instituto Tecnológico de Costa Rica, Cartago P.O. Box 159-7050, Costa Rica
| | - Federico Masís-Meléndez
- Chemistry, CEQIATEC, Centro de Investigación y de Servicios Químicos y Microbiológicos, Instituto Tecnológico de Costa Rica, Cartago P.O. Box 159-7050, Costa Rica
| | - Aníbal Ruíz-Barquero
- Electronic Engineering, Instituto Tecnológico de Costa Rica, Cartago P.O. Box 159-7050, Costa Rica
| | - Renato Rimolo-Donadio
- Electronic Engineering, Instituto Tecnológico de Costa Rica, Cartago P.O. Box 159-7050, Costa Rica
| |
Collapse
|
2
|
Comegna A, Hassan SBM, Coppola A. Development and Application of an IoT-Based System for Soil Water Status Monitoring in a Soil Profile. SENSORS (BASEL, SWITZERLAND) 2024; 24:2725. [PMID: 38732831 PMCID: PMC11086235 DOI: 10.3390/s24092725] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Subscribe] [Scholar Register] [Received: 03/07/2024] [Revised: 04/08/2024] [Accepted: 04/23/2024] [Indexed: 05/13/2024]
Abstract
Soil water content (θ), matric potential (h) and hydraulic conductivity (K) are key parameters for hydrological and environmental processes. Several sensors have been developed for measuring soil θ-h-K relationships. The cost of such commercially available sensors may vary over several orders of magnitude. In recent years, some sensors have been designed in the framework of Internet of Things (i.e., IoT) systems to make remote real-time soil data acquisition more straightforward, enabling low-cost field-scale monitoring at high spatio-temporal scales. In this paper, we introduce a new multi-parameter sensor designed for the simultaneous estimation of θ and h at different soil depths and, due to the sensor's specific layout, the soil hydraulic conductivity function via the instantaneous profile method (IPM). Our findings indicate that a second-order polynomial function is the most suitable model (R2 = 0.99) for capturing the behavior of the capacitive-based sensor in estimating θ in the examined soil, which has a silty-loam texture. The effectiveness of low-cost capacitive sensors, coupled with the IPM method, was confirmed as a viable alternative to time domain reflectometry (TDR) probes. Notably, the layout of the sensor makes the IPM method less labor-intensive to implement. The proposed monitoring system consistently demonstrated robust performance throughout extended periods of data acquisition and is highly suitable for ongoing monitoring of soil water status.
Collapse
Affiliation(s)
- Alessandro Comegna
- School of Agricultural Forestry Food and Environmental Sciences (SAFE), University of Basilicata, 85100 Potenza, Italy; (S.B.M.H.); (A.C.)
| | - Shawcat Basel Mostafa Hassan
- School of Agricultural Forestry Food and Environmental Sciences (SAFE), University of Basilicata, 85100 Potenza, Italy; (S.B.M.H.); (A.C.)
| | - Antonio Coppola
- School of Agricultural Forestry Food and Environmental Sciences (SAFE), University of Basilicata, 85100 Potenza, Italy; (S.B.M.H.); (A.C.)
- Department of Chemical and Geological Sciences, University of Cagliari, 09042 Cagliari, Italy
| |
Collapse
|
3
|
Adla S, Bruckmaier F, Arias-Rodriguez LF, Tripathi S, Pande S, Disse M. Impact of calibrating a low-cost capacitance-based soil moisture sensor on AquaCrop model performance. JOURNAL OF ENVIRONMENTAL MANAGEMENT 2024; 353:120248. [PMID: 38325280 DOI: 10.1016/j.jenvman.2024.120248] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Subscribe] [Scholar Register] [Received: 11/13/2023] [Revised: 01/08/2024] [Accepted: 01/27/2024] [Indexed: 02/09/2024]
Abstract
Sensor data and agro-hydrological modeling have been combined to improve irrigation management. Crop water models simulating crop growth and production in response to the soil-water environment need to be parsimonious in terms of structure, inputs and parameters to be applied in data scarce regions. Irrigation management using soil moisture sensors requires them to be site-calibrated, low-cost, and maintainable. Therefore, there is a need for parsimonious crop modeling combined with low-cost soil moisture sensing without losing predictive capability. This study calibrated the low-cost capacitance-based Spectrum Inc. SM100 soil moisture sensor using multiple least squares and machine learning models, with both laboratory and field data. The best calibration technique, field-based piece-wise linear regression (calibration r2 = 0.76, RMSE = 3.13 %, validation r2 = 0.67, RMSE = 4.57 %), was used to study the effect of sensor calibration on the performance of the FAO AquaCrop Open Source (AquaCrop-OS) model by calibrating its soil hydraulic parameters. This approach was tested during the wheat cropping season in 2018, in Kanpur (India), in the Indo-Gangetic plains, resulting in some best practices regarding sensor calibration being recommended. The soil moisture sensor was calibrated best in field conditions against a secondary standard sensor (UGT GmbH. SMT100) taken as a reference (r2 = 0.67, RMSE = 4.57 %), followed by laboratory calibration against gravimetric soil moisture using the dry-down (r2 = 0.66, RMSE = 5.26 %) and wet-up curves respectively (r2 = 0.62, RMSE = 6.29 %). Moreover, model overfitting with machine learning algorithms led to poor field validation performance. The soil moisture simulation of AquaCrop-OS improved significantly by incorporating raw reference sensor and calibrated low-cost sensor data. There were non-significant impacts on biomass simulation, but water productivity improved significantly. Notably, using raw low-cost sensor data to calibrate AquaCrop led to poorer performances than using the literature. Hence using literature values could save sensor costs without compromising model performance if sensor calibration was not possible. The results suggest the essentiality of calibrating low-cost soil moisture sensors for crop modeling calibration to improve crop water productivity.
Collapse
Affiliation(s)
- Soham Adla
- Chair of Hydrology and River Basin Management, Technical University of Munich, Arcisstrasse 21, 80333, Munich, Germany.
| | - Felix Bruckmaier
- Chair of Hydrology and River Basin Management, Technical University of Munich, Arcisstrasse 21, 80333, Munich, Germany.
| | - Leonardo F Arias-Rodriguez
- Chair of Hydrology and River Basin Management, Technical University of Munich, Arcisstrasse 21, 80333, Munich, Germany.
| | - Shivam Tripathi
- Department of Civil Engineering, Indian Institute of Technology Kanpur, Kanpur, 208016, Uttar Pradesh, India.
| | - Saket Pande
- Department of Water Management, Delft University of Technology, 2628, CN Delft, the Netherlands.
| | - Markus Disse
- Chair of Hydrology and River Basin Management, Technical University of Munich, Arcisstrasse 21, 80333, Munich, Germany.
| |
Collapse
|
4
|
Saito T, Oishi T, Inoue M, Iida S, Mihota N, Yamada A, Shimizu K, Inumochi S, Inosako K. Low-Error Soil Moisture Sensor Employing Spatial Frequency Domain Transmissometry. SENSORS (BASEL, SWITZERLAND) 2022; 22:8658. [PMID: 36433254 PMCID: PMC9696516 DOI: 10.3390/s22228658] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Figures] [Subscribe] [Scholar Register] [Received: 08/10/2022] [Revised: 10/30/2022] [Accepted: 11/07/2022] [Indexed: 06/16/2023]
Abstract
A new type of soil moisture sensor using spatial frequency domain transmissometry (SFDT) was evaluated. This sensor transmits and receives ultrawideband (1 to 6 GHz) radio waves between two separated antennas and measures the propagation delay time in the soil related to the dielectric constant. This method is expected to be less affected by air gaps between the probes and the soil, as well as being less affected by soil electrical conductivity (EC), than typical commercial sensors. The relationship between output and volumetric water content (θ), and the effects of air gaps and EC were evaluated through experiments using sand samples and the prototype SFDT sensor. The output of the SFDT sensor increased linearly with θ and was not affected by even a high salt concentration for irrigation water, such that the EC of the pore water was 9.2 dS·m-1. The SFDT sensor was almost unaffected by polyethylene tapes wrapped around the sensor to simulate air gaps, whereas a commercially available capacitance sensor significantly underestimated θ. Theoretical models of the SFDT sensor were also developed for the calibration equation and the air gaps. The calculation results agreed well with the experimental results, indicating that analytical approaches are possible for the evaluation of the SFDT sensor.
Collapse
Affiliation(s)
- Tadaomi Saito
- Faculty of Agriculture, Tottori University, 4-101 Koyama-Minami, Tottori 680-8553, Japan
| | - Takahiro Oishi
- Sony Group Corporation, 1-7-1 Konan Minato-ku, Tokyo 108-0075, Japan
| | - Mitsuhiro Inoue
- Faculty of Agriculture, Tottori University, 4-101 Koyama-Minami, Tottori 680-8553, Japan
| | - Sachio Iida
- Sony Group Corporation, 1-7-1 Konan Minato-ku, Tokyo 108-0075, Japan
| | - Norihito Mihota
- Sony Group Corporation, 1-7-1 Konan Minato-ku, Tokyo 108-0075, Japan
| | - Atsushi Yamada
- Sony Group Corporation, 1-7-1 Konan Minato-ku, Tokyo 108-0075, Japan
| | - Kohei Shimizu
- Department of Dryland Science, Graduate School of Sustainability Science, Tottori University, 4-101 Koyama-Minami, Tottori 680-8550, Japan
| | - Satoru Inumochi
- United Graduate School of Agricultural Sciences, Tottori University, 4-101 Koyama-Minami, Tottori 680-8553, Japan
| | - Koji Inosako
- Faculty of Agriculture, Tottori University, 4-101 Koyama-Minami, Tottori 680-8553, Japan
| |
Collapse
|