Tree Resin, a Macroergic Source of Energy, a Possible Tool to Lower the Rise in Atmospheric CO2 Levels

Carbon Sequestration in Resin-Tapped Slash Pine (Pinus elliottii Engelm.) Subtropical Plantations

Every year more than 150,000 tons of resin used in a myriad of industrial applications are produced by Brazilian plantations of Pinus elliottii Engelm. (slash pine), which are also used for timber. A pine tree can be tapped for resin over a period of several years. Resin is a complex mixture of terpenes, which are carbon-rich molecules, presumably influencing pine plantation carbon budgets. A total of 270 trees (overall mean DBH of 22.93 ± 0.11 cm) of 14-, 24-, and 26-year-old stands had their C content measured. Three different treatments (intact, wounded panels, and wounded + chemically stimulated panels, 30 trees each) were applied per site. Above- and belowground biomass, as well as resin yield, were quantified for two consecutive years. Data were statistically evaluated using normality distribution tests, analyses of variance, and mean comparison tests (p ≤ 0.05). The highest resin production per tree was recorded in the chemically stimulated 14-year-old stand. Tree dry wood biomass, a major stock of carbon retained in cell wall polysaccharides, ranged from 245.69 ± 11.73 to 349.99 ± 16.73 kg among the plantations. Variations in carbon concentration ranged from 43% to 50% with the lowest percentages in underground biomass. There was no significant difference in lignin concentrations. Soils were acidic (pH 4.3 ± 0.10-5.83 ± 0.06) with low C (from 0.05% to 1.4%). Significantly higher C stock values were recorded in pine biomass compared to those reported for temperate zones. Resin-tapping biomass yielded considerable annual increments in C stocks and should be included as a relevant component in C sequestration assessments of planted pine forests.

CuAPO-5 as a Multiphase Catalyst for Synthesis of Verbenone from α-Pinene

Copper(II)-containing aluminum phosphate material (CuAPO-5) was synthesized hydrothermally and used as a multiphase catalyst for the oxidation of α-pinene to verbenone. The catalysts were analyzed using X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET) surface area techniques, X-ray photoelectron spectroscopy (XPS), and ammonia temperature programmed reduction (NH₃-TPD). Scanning electron microscopy (SEM), X-ray energy spectrometry (EDS), inductively coupled plasma emission spectroscopy (ICP-OES), Fourier infrared spectroscopy (FT-IR), and ultraviolet-visible spectroscopy (UV-vis) were performed to characterize the material. The effects of reaction temperature, reaction time, n(α-pinene)/n(TBHP), and solvent on the catalytic performance of CuAPO-5 were investigated. The results show that all the prepared catalysts have AFI topology and a large specific surface area. Copper is evenly distributed in the skeleton in a bivalent form. The introduction of copper increases the acid content of the catalyst. Under the optimized reaction conditions, 96.8% conversion of α-pinene and 46.4% selectivity to verbenone were achieved by CuAPO-5(0.06) molecular sieve within a reaction time of 12 h. CuAPO-5(0.06) can be recycled for five cycles without losing the conversion of α-pinene and the selectivity to verbenone.