Evaluation of the Diode laser (810nm,980nm) on dentin tubule diameter following internal bleaching

Utilizing Laser-Induced Fluorescence to Evaluate the Efficiency of Carbon Dioxide and Diode Lasers in Dentin Sealing after Tooth Preparation: An in-vitro Study

Adhesive dentistry has made it feasible to design restorations with high aesthetic qualities and little invasiveness. However, the freshly cut dentin after the tooth preparation needs to be sealed to prevent its contaminations, bacterial leakage, and hypersensitivity. Consequently, the immediate dentin sealing (IDS) method has been advised. This study examines different dentinal tubule sealing methods via CO2 laser, diode laser (980-nm) and a two-step self-etch adhesive system applied directly to the fresh cut dentin preceding the placement of the provisional phase. The sealing efficiency of each laser and bond system was evaluated based on the laser-induced fluorescence (LIF) properties and image analysis by scanning electron microscopy. Moreover, the obtained LIF spectra were evaluated using partial least square progression. A two-step adhesive containing a high concentration of S-PRG fillers produced a thick layer that was not perfectly uniform at all sites due to uneven filler distribution in the bond with totally and partially closed dentinal tubules. However, the peaks of the LIF spectra dropped after applying laser because of its sealing effectiveness. Accordingly, CO2 and diode lasers have strong evidence in dentinal tubule sealing and a definitive treatment modality for dentinal hypersensitivity. Moreover, IDS with an adhesive system is superior in occluding dentinal tubules in a biomimetic manner based on its filler content and bioactive properties.

Evaluation of tooth color change after a bleaching process with different lasers

The aim of this in vitro study was to evaluate the efficiency of diode laser-activated bleaching systems for color change of teeth. 75 extracted teeth were studied in five different bleaching protocols. Group 1: diode laser 445 nm, 320 µm fiber, 0.5W, continuous wave mode, dose 53 J/cm2. Group 2: diode laser 970 nm, 320 µm fiber, 1W, continuous wave mode, dose 106.10 J/cm2. Group 3: diode laser 940 nm, bleaching handpiece, 7W, continuous wave mode, dose 105 J/cm2. Group 4: diode laser 940 nm, 300 µm fiber, 2W, continuous wave mode, dose 47.16 J/cm2. Group 5: bleaching process without laser activation. In groups 1, 2 and 5, teeth were bleached with Perfect Bleach Office + and in groups 3 and 4, LaserWhite20 bleaching gel was used. Tooth color was determined immediately after the bleaching process using a spectrophotometer. Color change data on the CIE L * a * b* system was analyzed statistically by the one-way ANOVA and Tukey's HSD test. All bleaching procedures resulted in a change of color. All laser groups (∆E * ab > 3) have statistically larger ∆E * ab values than the control group (∆E * ab = 0.73) (p < 0.05). The diode laser 445 nm has the largest ∆E * ab value (∆E * ab = 4.65) and results in a significantly higher color difference than all other groups. In terms of color score difference in VITA Shades, all laser-activated groups lead to a lightening effect while the control group leads to only a slight lightening effect. The diode laser 445 nm produced the greatest color difference. Laser-activated bleaching is more effective than conventional bleaching without light activation. The diode laser 445 nm performs best in this in vitro study.

Evaluation of the Efficacy of LASER, Desensitizing Agents, and their Combined Effect on Dentinal Hypersensitivity in Bicuspids: In Vitro Study

Aim

This study aimed to know the potential of diode light amplification by stimulated emission of radiation (LASER) and desensitizing agents on blocking the dentinal tubules, which may further help in reducing the most common dental problem named dentinal hypersensitivity (DH).

Materials and Methods

Sixty human permanent bicuspids were selected, and preparation was performed in the cervical region measuring 2.5 mm × 2.5 mm × 2.5 mm, followed by acid etching for 15 seconds. These are then divided according to the groups mentioned: group 1-nano-hydroxyapatite (HA) was applied for 15 minutes; group 2-biosilicate was applied for 15 minutes; group 3-diode LASER application was performed twice for 60 seconds in noncontact mode; group 4-nano-HA plus diode LASER application; and group 5-biosilicate plus diode LASER application. The same procedure was followed on the 1st, 7th, and 14th days and then rinsed and stored in artificial saliva, and the saliva was changed every 24 hours. The dentinal tubular occlusion was observed under a scanning electron microscope (SEM) after the 14th day.

Result

The maximum dentinal tubular occlusion was observed in group 4, where nano-HA and diode LASER application was performed.

Conclusion

All the investigated treatment groups have promising occluding potential, but the maximum was found in group 4 >group 5 >group 3 >group 1 >group 2. LASER plus desensitizing together prove to be potent and effective in reducing dentinal tubular diameter.

Chemical and morphological analysis of dentin irradiated by different high-power lasers: a systematic review

PURPOSE

This systematic review provides an overview of the main chemical and morphological alterations generated on dentin by different high-power lasers' irradiation.

METHODS

The review was registered in PROSPERO (CRD42023394164) and PRISMA guidelines were followed. The search strategy was conducted on MEDLINE (PubMed), Embase (Elsevier), and Web of Science (Clarivate) databases. The eligibility criteria were established according to the PICOS strategy, focusing on in vitro and ex vivo studies that assessed the chemical and morphological changes in dentin using five high-power lasers: Nd:YAG (1064 nm), Er:YAG (2940 nm), Er, Cr:YSGG (2780 nm), diode (980 nm), and CO2 (10,600 nm). Publication range was from 2010 to 2022. Data was summarized in tables and risk of bias was assessed by QUIN tool.

RESULTS

The search resulted in 2255 matches and 57 studies composed the sample. The methods most used to assess the outcomes were scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS), and Raman. The studies presented "medium" and "low" risk of bias. The laser prevalently identified was the Er:YAG laser, associated with dentin ablation, absence of smear layer, and exposed tubules. The Nd:YAG laser generated vitreous surface and thermal damage, such as carbonization and cracks. The other lasers caused an irregular surface and no adverse thermal effects. Regarding the chemical structure, only the Er,Cr:YSGG laser caused collagen matrix reduction. The effects found were more intense with higher dosimetry.

CONCLUSION

Evidence available indicates that the irradiation of dentin with high-power lasers are related to morphological outcomes favorable to adhesive restorative procedures, with minimal changes in collagen matrix and mineral content. However, those observations should be carried carefully by clinicians and more clinical trials regarding the association of high-power laser irradiation and restorative procedure longevity are needed.

Effect of Three Wavelengths of Diode Laser on the Efficacy of Bleaching of Stained Teeth

Objectives:

Light irradiation and heat have been used to accelerate the process of tooth bleaching. This study aimed to assess the efficacy of conventional bleaching compared to laser-bleaching using three different wavelengths of diode lasers.

Materials and Methods:

In this in-vitro experimental study, 40 extracted human central incisors were immersed in a coloring solution made of tea, coffee, and cola for 21 days. The L*, a*, and b* color parameters were measured before and after the immersion using spectrophotometry. The teeth were then randomly divided into four groups (n=10) as follows: group 1: 810-nm diode laser + Biolase Laser White 20, group 2: 940-nm diode laser + Biolase Laser White 20, group 3: 980-nm diode laser + Biolase Laser White 20, and group 4: conventional bleaching with Opalescence Boost without laser irradiation. One-way analysis of variance (ANOVA) was used to assess the effect of laser type and bleaching technique on color parameters.

Results:

The 940-nm (ΔE=28.5896) and 810-nm laser groups (ΔE=21.2382) showed the highest and the lowest bleaching efficacy, respectively; however, the groups were not significantly different in terms of bleaching efficacy (P>0.05).

Conclusion:

Laser-bleaching with 810-, 940- and 980-nm wavelengths of diode laser has an efficacy similar to that of conventional bleaching but in a shorter period. No difference was noted between different laser wavelengths in terms of bleaching efficacy.

Effect of diode laser irradiation on the bond strength of polymerized non-simplified adhesive systems after 12 months of water storage

Objectives:

The aim of this in vitro study was to evaluate the bonding strength of non-simplified dentin bonding systems (DBS) to dentin irradiated with a diode laser (970 nm) immediately and after 12 months of water storage following either primer or bond application.

Material and methods:

The experimental design included three different factors: DBS type [Adper^TM Scotchbond Multipurpose (MP) and Clearfil™ SE Bond (CSE)], irradiation [without irradiation - control (C), irradiation after primer application (AP), and irradiation after bond application (AB)], and time [initial (I) and after 12 months of water storage (12 m)]. Sixty sound human third molars (n = 10) were obtained, and their flat occlusal dentin areas were prepared and standardized. Laser irradiation was performed in the contact mode perpendicular to the dental surface over an automatically selected scanning area at a pulse energy of 0.8 W, frequency of 10 Hz, and energy density of 66.67 J/cm². After 7 days of treatment, the specimens were cut, and half of them were subjected to microtensile testing (500 N/0.05 mm/min), whereas the remaining sticks were examined after 12 months of water storage. The obtained data were analyzed by three-way analysis of variance (ANOVA) followed by a Tukey test (p<0.05). The observed fracture modes were investigated using a portable digital microscope with a magnification of 40x.

Results:

Among the utilized DBS, MP generally exhibited higher bond strengths, but did not always differ from CSE under similar conditions. The irradiation factor was statistically significant only for the MP/AB groups. After 12 months of storage, all groups demonstrated a significant reduction in the bond strength, whereas the results of fracture analysis showed a predominance of the adhesive type.

Conclusions:

The laser treatment of non-simplified DBS was not able to stabilize their bonding characteristics after 12 months.

Evaluation of the Effect of Different Laser Activated Bleaching Methods on Enamel Susceptibility to Caries; An In Vitro Mode

Introduction: Today, bleaching is a routine noninvasive alternative for treatment of discolored teeth. The aim of this study was to determine whether conventional or laser activated bleaching predispose teeth to develop caries or not. Methods: Sixty human molars were mounted on acrylic cylinders and their Knoop microhardness (KHN) as well as DIAGNOdent (DD) values were recorded. They were divided into 4 experimental groups; G1) conventional bleaching with 40% hydrogen peroxide gel, G2) Diode laser assisted bleaching with same gel, G3) Nd:YAG laser assisted bleaching with the same gel, G4) control group. After bleaching, all samples were subjected to a three day pH cycling regimen and then, KHN and DD values were measured. Results: All groups had significant reduction in KHN values. It seems that there is no statistically meaningful difference between changes in enamel microhardness of the sample groups and all groups have changed in a similar amount. Reduction of DD scores were significant in Diode laser and conventional groups, however changes in Nd:YAG laser and control groups were not significant. Changes in DD values have followed a similar pattern among groups, except in G1- G4 and G2-G4 couples. Conventional and diode laser groups had a meaningful difference in reduction of DD values in comparison with the control group. Conclusion: It can be concluded that bleaching whether conventional or laser activated, does not make teeth vulnerable to develop carious lesions.