Use of a Partial-thickness Flap for Guided Bone Regeneration in the Upper Jaw

Effect of Membrane Fixation and the Graft Combinations on Horizontal Bone Regeneration: Radiographic and Histologic Outcomes in a Canine Model

The aim of this study was to determine the effect of membrane fixation and combinations of bone substitute materials and barrier membranes on horizontal bone regeneration in peri-implant defects. Eight mongrel dogs underwent chronic buccal peri-implant dehiscence defects creation and were randomized into 4 groups: (a) deproteinized bovine bone mineral 1 (DBBM1) with a native collagen membrane (CM) (BB group, positive control group), (b) DBBM1 with native CM and 2 fixation pins (BBP group), (c) DBBM2 with a cross-linked CM (XC group), and (d) DBBM2 with cross-linked CM and 2 fixation pins (XCP group). Following 16 weeks of healing, tissues were radiographically and histomorphometrically analyzed. The total augmented area was significantly larger in the BBP, XC, and XCP groups compared to the BB group (4.27 ± 3.21, 7.17 ± 7.23, and 6.91 ± 5.45 mm2 versus 1.35 ± 1.28 mm2, respectively; P = 0.022). No significant difference for the augmented tissue thickness was observed among the 4 groups. The augmented tissue thickness measured at 3 mm below the implant shoulder was higher in BBP, XC, and XCP than that in BB (2.43 ± 1.53, 2.62 ± 1.80, and 3.18 ± 1.96 mm versus 0.80 ± 0.90 mm, respectively), trending toward significance (P = 0.052). DBBM2 and a cross-linked CM were significantly more favorable for horizontal bone regeneration compared to DBBM1 and a native CM. However, when DBBM1 and a native CM were secured with fixation pins, outcomes were similar. The addition of pins did not lead to more favorable outcomes when a cross-linked CM was used.

Effect of collagen membrane fixation on ridge volume stability and new bone formation following guided bone regeneration

AIM

To test the effect of membrane fixation on ridge volume stability and new bone formation using guided bone regeneration.

MATERIALS AND METHODS

In eight beagle dogs, after bilateral extraction of the maxillary pre-molars, a box-shaped defect was created on each side. All defect sites were augmented with a particulate bone substitute material, covered with either one of two non-cross-linked collagen membranes (CM1 or CM2) with or without fixation (-F or -UF). Samples were collected after 8 weeks. Histomorphometric and micro-computed tomography analyses were performed.

RESULTS

Membrane fixation made no significant difference to the total augmented volume for both membranes (p > .05). Histological data indicated that at the ridge crest the augmented tissue width amounted to 2.4 ± 0.4 mm in the group CM1-F and 2.4 ± 0.5 mm in the group CM1-UF, with no significant difference between the groups. Conversely, in CM2-F the augmented tissue width was significantly larger than in CM2-UF (2.3 ± 0.1 vs. 1.57 ± 0.27, p < .05).

CONCLUSIONS

Membrane fixation in contained defects failed to improve ridge volume stability regardless of the membrane type. However, it may enhance the width of the augmented ridge at the coronal portion depending on the type of membrane.

Second Class Functional Treatment: Andreasen Activator vs Twin Block

Aim

The purpose of this research is to analyze and compare the dental and skeletal changes induced by two functional devices, Andreasen Activator and Clark's twin block, on the sagittal and vertical plane, by means of cephalometric analysis, of the lateral cephalograms prescribed at the beginning and at the end of the treatment for a second skeletal class, first division with normal or deep bite.

Materials and methods

Twenty patients, 8 females and 12 males, fulfilling criteria for inclusion, were divided randomly into two groups: group I was treated with Andreasen activator, the second group with Clark's twin block. The duration of the therapy was about 18 months plus less 2 months. Pretreatment and posttreatment cephalometric radiographs were analyzed using angular (SNA, SNB, ANB, SnaSnp–GoGn angles), linear (Sna–Snp, Co–Gn, Co–Go, Go–Gn) skeletal parameters and dental one (U1–SnaSnp angle, L1–GoGn angle, Overjet and Overbite). To evaluate the posttreatment changes in the single groups and between them, paired and unpaired t-test was used.

Results

In both of the two groups analyzed, all the sagittal and vertical, angular and linear, skeletal measurements appear to be increased in a statistically significant way, except SNA angle and the distance Sna–Snp. Regarding the dental parameters, in the group treated with Andreasen activator, only Overjet and Overbite showed statistically significant differences. On the other hand, twin block induced statistical changes about Overjet, Overbite and also U1/SnaSnp, but not about L1/GoGn. The advancement of the mandible determines a greater prominence of the chin and lower lip, an increment of the labial mental angle and a reduction of the convexity of the profile. Also, the decrease of the overjet and, consequently, of the dental exposure improve the esthetic appearance of the patient's face.

Conclusion

Both functional treatments showed a lower jaw advanced on the sagittal plane and increased in size. In the upper jaw no significant changes were observed. It was also evident a dental compensation both on sagittal and vertical planes.

Clinical significance

The functional devices studied, Andreasen activator and twin block, seem to obtain more skeletal than dental results when the patients were treated at the peak of pubertal growth.

How to cite this article

Baccaglione G, Rota E, Ferrari M, et al. Second Class Functional Treatment: Andreasen Activator vs Twin Block. Int J Clin Pediatr Dent 2020;13(2):144–149.

Relationship between the Position of the Incisors and the Thickness of the Soft Tissues in the Upper Jaw: Cephalometric Evaluation

Aim

The aim of this study is to verify if the thickness of soft tissues and inclination of the incisors have some relation with profile, to analyze its relevance considering these two parameters separately and to screen how the combination of different inclinations and different thickness can generate different facial patterns.

Materials and methods

The study was performed on 47 Caucasian patients aged between 6 years and 16 years of divided into 24 males and 23 females. None of the patients presented craniofacial changes of syndromic nature. All patients presented a value of SNA in between 80° and 84°. The inclination of the upper incisor related to the bispinal plane was between 104° and 116°. Each radiograph has been digitized or analyzed directly in digital format. To analyze the relationships between soft tissues and position of the incisors using various cephalometric measures and statistical methodology were used.

Results

Analysing the general correlation between all the cephalometric parameters considered, the results found show that the thickness of the tissues had an effect in modifying the aesthetic profile with respect to the position of the incisors. The cephalometric parameters related to the esthetic profile of the maxilla are all linked by strong correlations, especially correlation between SU, ULA and LS were very high. The differences between the means were statistically significant for different groups. Using the values of Mx1 and thickness of the lip as independent variables, while the LS, SU, ULA and NLA values as dependent variables all results are significant with respect to the prediction p < 0.05.

Conclusion

Thickness of the soft tissues showed a significant influence on the profile with respect to the position of the incisors.

Clinical significance

Data obtained highlighted that thickness of the soft tissues must be taken into account before starting an orthodontic treatment in order to obtain best aesthetic results.

How to cite this article

Maddalone M, Losi F, Rota E, et al. Relationship between the Position of the Incisors and the Thickness of the Soft Tissues in the Upper Jaw: Cephalometric Evaluation. Int J Clin Pediatr Dent 2019;12(5):391-397.