A comparative evaluation of retention of pit and fissure sealants placed with conventional acid etching and Er,Cr:YSGG laser etching: A randomised controlled trial

Topographical Analysis of Human Enamel after Phosphoric Acid Etching and Er,Cr:YSGG Laser Irradiation

Introduction: Dental hard and soft tissues have been successfully removed by using the Er,Cr:YSGG laser, but there is a controversy about using lasers over conventional tooth surface preparation for bonding aesthetic restoration. Surface roughness and wettability in response to Er,Cr:YSGG laser irradiation are essential properties for restoration longevity. Methods: Fifty-one intact human premolars removed in orthodontic treatment were included in this study and divided into three groups (n=17). The first group (G1) was the control without surface treatment, (G2) was treated with 37% phosphoric acid for 15 seconds, and (G3) was treated with the Er,Cr:YSGG laser using the following parameters: 2 W or 3 W at 20 Hz, 10% air and water ratio using the MZ6 laser tip. The standardization of laser irradiation was accomplished by a computerized numerical control unit. The surface of the samples was evaluated by using a light microscope, profilometer, atomic force microscopy (AFM), SEM, and wettability tests. Results: The SEM examination revealed that the lased enamel surface was clean, irregular, and devoid of a smear layer, while the acid etch surface was relatively smooth and covered with a smear layer. The surface roughness of the lased enamel surface was significantly higher than that of other groups, according to the results of the profilometer as well as the AFM tests. The wettability test showed that the lased enamel surface recorded a significant reduction in the contact angle in comparison to the other groups. Conclusion: It can be concluded that the Er,Cr:YSGG laser can be used as an alternative and safe method to the acid-etching technique for surface treatment.

The Use of Laser Energy for Etching Enamel Surfaces in Dentistry-A Scoping Review

BACKGROUND

In dental practice, different situations require etching the enamel layer. Acid etching, the present golden standard, may be replaced by other methods, such as laser etching. The main focus of our scoping review is to assess the existent literature regarding the effectiveness of different types of lasers, to identify the main aspects studied so far, and to understand where new search strategies are needed.

METHODS

The search was conducted in several databases focusing on the laser etching of human definitive enamel. We included English language articles published between January 2000 and December 2021.

RESULTS

The 34 articles reviewed showed that hard lasers, Er:YAG, Er,Cr:YAG, may represent an alternative etching method on enamel surfaces. They create a fractured, irregular surface and open dentin tubules, highly suitable for adhesion but with a lower risk of cavity formation. Nd:YAG, CO₂, and Diode lasers do not help in creating sufficient shear bond strength. There is, however, evidence suggesting that microcracks in the enamel layer may appear after thermomechanical ablation using laser energy.

CONCLUSIONS

While the use of acid etching is still successfully used for enamel conditioning, some researchers have emphasized the role played by saliva in the enamel-remineralization process a few days after the procedure. In this context, laser energy can be used, especially for bonding ceramic brackets in the case of orthodontic treatments. However, as thermomechanical ablation can generate microcracks, further research is required in order to establish clear findings concerning the use of laser energy on enamel etching.

Shear bond strength of acid and laser conditioned enamel and dentine to composite resin restorations: An in vitro study

Objective

To compare the shear bond strength of enamel or dentin conditioned with either Er,Cr:YSGG (erbium, chromium: yttrium–scandium–gallium–garnet) laser or phosphoric acid to composite resin restoration.

Material and methods

Forty posterior human extracted teeth were used. After mesiodistal sectioning of the teeth crowns, the samples were randomly divided into two groups—in the first group (E), bonding was performed on the enamel after roughening and in the second group (D), the enamel was removed and bonding was performed on the dentin. These groups were further randomly divided into two subgroups according to the type of etching (n = 20 each). In the acid‐etched groups (EA and DA), the surfaces were etched with 37% phosphoric acid. In the laser‐conditioned groups (EL and DL), the surfaces were conditioned with Er,Cr:YSGG laser. Total‐etch adhesive system was used to bond all the 80 specimens resin composite. The composite was vertically light‐cured, and the specimens were subjected to a shear bond strength test. Modes of bond failure were determined with a stereomicroscope.

Results

The highest shear bond strength was observed for the DA group (16.25 ± 1.10 MPa, p < 0.0001), whereas the lowest was observed for the DL group (8.56 ± 0.67 MPa). The adhesive failure mode was the most frequently observed in all groups.

Conclusions

The shear bond strength of composite resin bonded to enamel and dentin etched with phosphoric acid was higher than when conditioned with Er,Cr:YSGG laser. Thus, laser conditioning is not recommended.

Lasers to prevent dental caries: a systematic review

OBJECTIVE

To assess the effectiveness of lasers (at sub-ablative parameters) in reducing caries incidence compared with traditional prophylactic interventions (TPIs) when used alone or together with other TPIs such as pits and fissures sealant or fluoride gels or varnishes.

DESIGN

A systematic review. Data sources include Medline (via PubMed), Embase, Web of Science and the Cochrane Library (December 2019).

ELIGIBILITY CRITERIA

Only randomised trials (RCTs) and controlled clinical trials (CCTs) dealing with prophylactic lasers use (vs TPI or untreated teeth) were considered as eligible. We excluded in vitro and ex vivo studies.

DATA EXTRACTION

Eligible studies were selected and data extracted independently by two reviewers. Risk of bias was assessed adopting the Cochrane Risk of Bias tool. Data on caries incidence, sealant retention, fluoride uptake, adverse events, treatment duration, patients' discomfort and cost-effectiveness ratio was extracted.

DATA ANALYSIS

Extracted data were presented narratively due to the heterogeneity of included studies.

RESULTS

Seven RCTs and two CCTs, all with an evident risk of bias, met inclusion criteria, pooling together 269 individuals and 1628 teeth. CO₂, neodymium-doped yttrium aluminium garnet, erbium-doped yttrium aluminum garnet (Er:YAG), erbium, chromium: yttrium scandium gallium garnet (Er,Cr:YSGG) and Argon lasers were used. In the permanent dentition, lasers only when used in combination with TPIs were effective in reducing caries when compared with untreated teeth (risk ratio (RR)=0.44 (0.20-0.97); Er:YAG laser) or with TPIs used alone (RR=0.39 (0.22-0.71); CO₂ laser). Moreover, Argon laser significantly improved the fluoride uptake into the enamel surfaces (ANalysis Of VAriance (ANOVA) tests: 95%, p<0.0001). Likewise, sealant retention improved when acid etching was performed on previously irradiated enamel fissures by CO₂ laser (RR=0.63 (0.38-1.04)) or Er:YAG laser (RR=0.54 (95% CI: 0.34 to 0.87)). In addition, laser resulted safe and well tolerated by patients.

CONCLUSION

Despite some positive indications, an inadequate level of evidence was found in the included studies concerning the lasers' effectiveness in preventing caries. Further studies with a higher methodological quality level are required.

The clinical effects of laser preparation of tooth surfaces for fissure sealants placement: a systematic review and meta-analysis

BACKGROUND

This systematic review aimed to assess the clinical effects of laser preparation compared to other types of chemical or mechanical preparation of tooth surfaces used in fissure sealant placement.

METHODS

A systematic literature search was conducted up to January 2019, through Pubmed, Scopus, Medline/EMBASE via OVID and the Cochrane library. Only randomized clinical trials were included.

RESULTS

Five studies were included in the systematic review and three were included in the meta-analysis. All the studies used acid-etching as a comparator to lasers. All the included studies were rated as having an overall high risk of bias introduced by performance bias. Three studies assessed the clinical effects of fissure sealants placed by acid or laser etching, one compared acid etching versus laser combined with acid etching and one investigated the influence of lasers on the objective and subjective parameters of stress during sealant application in children. The meta-analysis showed no significant difference between laser preparation and conventional acid-etching preparation at 3- (P = 0.08), 6- (P = 0.49), and 12-month (P = 0.87) follow-ups. One study reported that laser preparation as an adjunct to acid-etching enhanced the retention rate. No significant difference in the incidence of caries was reported. And no significant differences were found in heart rates, oxygen saturation or degree of the patient dental anxiety between acid-etching and laser preparation.

CONCLUSION

The present limited evidence suggests that lasers could be an effective pretreatment method. The retention rate was similar to that of conventional acid etching. However, the included studies had an overall high risk of bias and more rigorously designed research is needed.

Knowledge Analysis of Pit and Fissure Sealants among the Dental Students of South India

AIM

This study aimed to assess the level of knowledge and attitudes for pit and fissure sealants among undergraduate Indian dental students.

MATERIALS AND METHODS

A modified questionnaire consisting of 24 items was distributed to 280 undergraduate dental students comprising males and females of different years at MNR Dental College, Sangareddy, India. Descriptive statistics and Chi-square/Fisher's exact tests were used for statistical analysis. The data were computationally tested using Statistical Package for the Social Sciences (SPSS) Version 20, IBM SPSS Statistics software for Windows, Armonk, NY, USA.

RESULTS

With the response rate at 100%, most of the respondents, i.e., 70.4%, were females and the remaining 29.6% were male. Regarding the level of study, 20.8% were in 3rd year, 43.8% in the 4th year, and 16.8% were in 5th year (internship). The respondents showed a reasonable level of knowledge about sealants, mostly being good with the theoretical concepts of the sealants. On the other hand, respondents showed insufficient knowledge about sealants in the clinical practice.

CONCLUSION

Although a high proportion of undergraduate dental students showed adequate knowledge about dental sealants, there is a lag in putting that knowledge into work during the clinical practice. These findings suggest an urgent need of dental schools to include and/or update their curriculum regarding fissure sealants to reflect modern dental education that concentrates on evidence-based practice in pediatric dentistry and improve the dental health among the future generations by reducing the incidence of caries.