Biomechanics of the medial meniscus in the osteoarthritic knee joint

Anterior cruciate ligament injury should not be considered a contraindication for medial unicompartmental knee arthroplasty: Finite element analysis

PURPOSE

The research objective of this study is to use finite element analysis to investigate the impact of anterior cruciate ligament (ACL) injury on medial unicompartmental knee arthroplasty (UKA) and explore whether patients with ACL injuries can undergo UKA.

METHODS

Based on the morphology of the ACL, models of ACL with diameters ranging from 1 to 10mm are created. Finite element models of UKA include ACL absence and ACLs with different diameters. After creating a complete finite element model and validating it, four different types of loads are applied to the knee joint. Statistical analysis is conducted to assess the stress variations in the knee joint structure.

RESULTS

A total of 11 finite element models of UKA were established. Regarding the stress on the ACL, as the diameter of the ACL increased, when a vertical load of 750N was applied to the femur, combined with an anterior tibial load of 105N, the stress on the ACL increased from 2.61 MPa to 4.62 MPa, representing a 77.05% increase. Regarding the equivalent stress on the polyethylene gasket, a notable high stress change was observed. The stress on the gasket remained between 12.68 MPa and 14.33 MPa in all models. the stress on the gasket demonstrated a decreasing trend. The equivalent stress in the lateral meniscus and lateral femoral cartilage decreases, reducing from the maximum stress of 4.71 MPa to 2.61 MPa, with a mean value of 3.73 MPa. This represents a reduction of 44.72%, and the statistical significance is (P < 0.05). However, under the other three loads, there was no significant statistical significance (P > 0.05).

CONCLUSION

This study suggests that the integrity of the ACL plays a protective role in performing medial UKA. However, this protective effect is limited when performing medial UKA. When the knee joint only has varying degrees of ACL injury, even ACL rupture, and the remaining structures of the knee joint are intact with anterior-posterior stability in the knee joint, it should not be considered a contraindication for medial UKA.

Extrusion and meniscal mobility evaluation in case of ramp lesion injury: a biomechanical feasibility study by 7T magnetic resonance imaging and digital volume correlation

Introduction: The existing body of literature on the biomechanical implications of ramp lesions is limited, leaving a significant gap in our understanding of how these lesions impact joint kinematics and loading in the medial compartment. This cadaveric biomechanical study aims to address this gap by employing an innovative Digital Volume Correlation (DVC) method, utilizing 7 Tesla Magnetic Resonance Imaging (MRI) images under various loading conditions. The primary objective is to conduct a comprehensive comparison of medial meniscal mobility between native knees and knees affected by grade 4 ramp lesions. By focusing on the intricate dynamics of meniscal mobility and extrusion, this work seeks to contribute valuable insights into the biomechanical consequences of medial meniscus ramp lesions. Materials and methods: An initial set of 7T MRI imaging sessions was conducted on two intact native knees, applying load values up to 1500N. Subsequently, a second series of images was captured on these identical knees, with the same loads applied, following the creation through arthroscopy of medial meniscus ramp lesions. The application of DVC enabled the precise determination of the three components of displacement and spatial variations in the medial menisci, both with and without ramp lesions. Results: The measured directional displacements between native knees and injured knees indicate that, following the application of axial compression load, menisci exhibit increased extrusion and posterior mobility as observed through DVC. Discussion: Injuries associated with Subtype 4 medial meniscus ramp lesions appear to elevate meniscal extrusion and posterior mobility during axial compression in the anterior cruciate ligament of intact knees. Following these preliminary results, we plan to expand our experimental approach to encompass individuals undergoing weight-bearing MRI. This expansion aims to identify meniscocapsular and/or meniscotibial insufficiency or rupture in patients, enabling us to proactively reduce the risk of osteoarthritic progression.

Unique patterns of medial meniscus extrusion during walking and its association with limb kinematics in patients with knee osteoarthritis

Medial meniscus extrusion (MME) is exacerbated by repeated mechanical stress. Various factors would affect MME; however, there is limited information about the behaviour of the medial meniscus during walking in patients with knee osteoarthritis (KOA). This study aimed to investigate the pattern of MME during walking and its association with limb biomechanics in patients with KOA. Fifty-five patients with KOA and ten older adult volunteers as a control group were involved in this study. The MME and limb biomechanics during walking were evaluated simultaneously by ultrasound and a motion analysis system, respectively. The waveform was constructed from the values of MME, and the point showing the highest value of MME was identified during the gait cycle. According to the peak timing of MME in the waveform, the pattern of the waveform was evaluated and compared to the control group. Lateral thrust, knee adduction moment (KAM), and flexion moment were obtained from motion analysis, and their association with the MME was evaluated. The patients with KOA demonstrated unique peak timing during walking. Compared to the control group, there were three groups of MME waveforms, early (< 59%), normal (60-83%), and late (> 84%) from the peak timing in the gait cycle. The pattern of MME waveform in early, normal, and late groups was correlated with the first KAM and lateral thrust, second KAM, and knee flexion moment, respectively. A unique MME pattern during walking was demonstrated, and these patterns were associated with limb biomechanics in patients with KOA.

Tensile energy dissipation and mechanical properties of the knee meniscus: relationship with fiber orientation, tissue layer, and water content

Introduction: The knee meniscus distributes and dampens mechanical loads. It is composed of water (∼70%) and a porous fibrous matrix (∼30%) with a central core that is reinforced by circumferential collagen fibers enclosed by mesh-like superficial tibial and femoral layers. Daily loading activities produce mechanical tensile loads which are transferred through and dissipated by the meniscus. Therefore, the objective of this study was to measure how tensile mechanical properties and extent of energy dissipation vary by tension direction, meniscal layer, and water content. Methods: The central regions of porcine meniscal pairs (n = 8) were cut into tensile samples (4.7 mm length, 2.1 mm width, and 0.356 mm thickness) from core, femoral and tibial components. Core samples were prepared parallel (circumferential) and perpendicular (radial) to the fibers. Tensile testing consisted of frequency sweeps (0.01-1Hz) followed by quasi-static loading to failure. Dynamic testing yielded energy dissipation (ED), complex modulus (E*), and phase shift (δ) while quasi-static tests yielded Young's Modulus (E), ultimate tensile strength (UTS), and strain at UTS (ε_UTS). To investigate how ED is influenced by the specific mechanical parameters, linear regressions were performed. Correlations between sample water content (φ_w) and mechanical properties were investigated. A total of 64 samples were evaluated. Results: Dynamic tests showed that increasing loading frequency significantly reduced ED (p < 0.05). Circumferential samples had higher ED, E*, E, and UTS than radial ones (p < 0.001). Stiffness was highly correlated with ED (R² > 0.75, p < 0.01). No differences were found between superficial and circumferential core layers. ED, E*, E, and UTS trended negatively with φ_w (p < 0.05). Discussion: Energy dissipation, stiffness, and strength are highly dependent on loading direction. A significant amount of energy dissipation may be associated with time-dependent reorganization of matrix fibers. This is the first study to analyze the tensile dynamic properties and energy dissipation of the meniscus surface layers. Results provide new insights on the mechanics and function of meniscal tissue.

The Interplay of Biomechanical and Biological Changes Following Meniscus Injury

PURPOSE OF REVIEW

Meniscus injury often leads to joint degeneration and post-traumatic osteoarthritis (PTOA) development. Therefore, the purpose of this review is to outline the current understanding of biomechanical and biological repercussions following meniscus injury and how these changes impact meniscus repair and PTOA development. Moreover, we identify key gaps in knowledge that must be further investigated to improve meniscus healing and prevent PTOA.

RECENT FINDINGS

Following meniscus injury, both biomechanical and biological alterations frequently occur in multiple tissues in the joint. Biomechanically, meniscus tears compromise the ability of the meniscus to transfer load in the joint, making the cartilage more vulnerable to increased strain. Biologically, the post-injury environment is often characterized by an increase in pro-inflammatory cytokines, catabolic enzymes, and immune cells. These multi-faceted changes have a significant interplay and result in an environment that opposes tissue repair and contributes to PTOA development. Additionally, degenerative changes associated with OA may cause a feedback cycle, negatively impacting the healing capacity of the meniscus. Strides have been made towards understanding post-injury biological and biomechanical changes in the joint, their interplay, and how they affect healing and PTOA development. However, in order to improve clinical treatments to promote meniscus healing and prevent PTOA development, there is an urgent need to understand the physiologic changes in the joint following injury. In particular, work is needed on the in vivo characterization of the temporal biomechanical and biological changes that occur in patients following meniscus injury and how these changes contribute to PTOA development.