In-line phase-contrast breast tomosynthesis: a phantom feasibility study at a synchrotron radiation facility

The major objective is to adopt, apply and test developed in-house algorithms for volumetric breast reconstructions from projection images, obtained in in-line phase-contrast mode. Four angular sets, each consisting of 17 projection images obtained from four physical phantoms, were acquired at beamline ID17, European Synchroton Radiation Facility, Grenoble, France. The tomosynthesis arc was  ±32°. The physical phantoms differed in complexity of texture and introduced features of interest. Three of the used phantoms were in-house developed, and made of epoxy resin, polymethyl-methacrylate and paraffin wax, while the fourth phantom was the CIRS BR3D. The projection images had a pixel size of 47 µm  ×  47 µm. Tomosynthesis images were reconstructed with standard shift-and-add (SAA) and filtered backprojection (FBP) algorithms. It was found that the edge enhancement observed in planar x-ray images is preserved in tomosynthesis images from both phantoms with homogeneous and highly heterogeneous backgrounds. In case of BR3D, it was found that features not visible in the planar case were well outlined in the tomosynthesis slices. In addition, the edge enhancement index calculated for features of interest was found to be much higher in tomosynthesis images reconstructed with FBP than in planar images and tomosynthesis images reconstructed with SAA. The comparison between images reconstructed by the two reconstruction algorithms shows an advantage for the FBP method in terms of better edge enhancement. Phase-contrast breast tomosynthesis realized in in-line mode benefits the detection of suspicious areas in mammography images by adding the edge enhancement effect to the reconstructed slices.

Comparison of algorithms for out-of-plane artifacts removal in digital tomosynthesis reconstructions

Digital tomosynthesis is a method of limited angle reconstruction of tomographic images produced at variable heights, on the basis of a set of angular projections taken in an arc around human anatomy. Reconstructed tomograms from unprocessed original projection images, however, are invariably affected by tomographic noise such as blurred images of objects lying outside the plane of interest and superimposed on the focused image of the fulcrum plane. The present work investigates the performance of two approaches for generation of tomograms with a reduced noise: a generalised post-processing method, based on constructing a noise mask from all planes in the reconstructed volume, and its subsequent subtraction from the in-focus plane and a filtered Multiple Projection Algorithm. The comparison between the two algorithms shows that the first method provides reconstructions with very good quality in case of high contrast features, especially for those embedded into a heterogeneous background.

Logarithmic amplifier for computed tomography tasks using fluoroscopic projections

The image intensifier (II)-based imaging systems, as radiotherapy simulators or C-arm X-ray units, have also been used for image acquisition in computed tomography. When analogue-to-digital conversion is performed on the output signal of the television camera, the accuracy for low-amplitude video signals, corresponding to X-ray pathways crossing high attenuation structures, is limited. To deal with this lack of accuracy, we investigated the benefits of using a logarithmic amplifier (LOGAMP) inserted between the television camera output and the analogue-to-digital converter (ADC) in the image acquisition chain. Such a device was intended to provide better use of the available ADCs of a given resolution and actually to reduce the quantization noise. Simulated data were used in this study, and cases with and without logarithmic amplifier were compared. Based on the simulation results, we formulate requirements for several signal and acquisition system parameters where the use of such a circuit is recommended.