Evaluating the Performance of Household Liquefied Petroleum Gas Cookstoves

Liquefied petroleum gas (LPG) cookstoves are considered to be an important solution for mitigating household air pollution; however, their performance has rarely been evaluated. To fill the data and knowledge gaps in this important area, 89 laboratory tests were conducted to quantify efficiencies and pollutant emissions from five commercially available household LPG stoves under different burning conditions. The mean thermal efficiency (±standard deviation) for the tested LPG cookstoves was 51 ± 6%, meeting guidelines for the highest tier level (Tier 4) under the International Organization for Standardization, International Workshop Agreement 11. Emission factors of CO₂, CO, THC, CH₄, and NO_x on the basis of useful energy delivered (MJ_d) were 142 ± 17, 0.77 ± 0.55, 130 ± 196, 5.6 ± 8.2, and 46 ± 9 mg/MJ_d, respectively. Approximately 90% of the PM_2.5 data were below the detection limit, corresponding to an emission rate below 0.11 mg/min. For those data above the detection limit, the average emission factor was 2.4 ± 1.6 mg/MJ_d, with a mean emission rate of 0.20 ± 0.16 mg/min. Under the specified gas pressure (2.8 kPa), but with the burner control set to minimum air flow rate, less complete combustion resulted in a visually yellow flame, and CO, PM_2.5, EC, and BC emissions all increased. LPG cookstoves met guidelines for Tier 4 for both CO and PM_2.5 emissions and mostly met the World Health Organization Emission Rate Targets set to protect human health.

A Laboratory Comparison of Emission Factors, Number Size Distributions, and Morphology of Ultrafine Particles from 11 Different Household Cookstove-Fuel Systems

Ultrafine particle (UFP) emissions and particle number size distributions (PNSD) are critical in the evaluation of air pollution impacts; however, data on UFP number emissions from cookstoves, which are a major source of many pollutants, are limited. In this study, 11 fuel-stove combinations covering a variety of fuels and different stoves are investigated for UFP emissions and PNSD. The combustion of LPG and alcohol (∼10¹¹ particles per useful energy delivered, particles/MJ_d), and kerosene (∼10¹³ particles/MJ_d), produced emissions that were lower by 2-3 orders of magnitude than solid fuels (10¹⁴-10¹⁵ particles/MJ_d). Three different PNSD types-unimodal distributions with peaks ∼30-40 nm, unimodal distributions with peaks <30 nm, and bimodal distributions-were observed as the result of both fuel and stove effects. The fractions of particles smaller than 30 nm (F₃₀) varied among the tested systems, ranging from 13% to 88%. The burning of LPG and alcohol had the lowest PM_2.5 mass emissions, UFP number emissions, and F₃₀ (13-21% for LPG and 35-41% for alcohol). Emissions of PM_2.5 and UFP from kerosene were also low compared with solid fuel burning but had a relatively high F₃₀ value of approximately 73-80%.

Polycyclic Aromatic Hydrocarbons in Fine Particulate Matter Emitted from Burning Kerosene, Liquid Petroleum Gas, and Wood Fuels in Household Cookstoves

This study measures polycyclic aromatic hydrocarbon (PAH) compositions in particulate matter emissions from residential cookstoves. A variety of fuel and cookstove combinations are investigated, including: (i) liquid petroleum gas (LPG), (ii) kerosene in a wick stove, (iii) wood (10 and 30% moisture content on a wet basis) in a forced-draft fan stove, and (iv) wood in a natural-draft rocket cookstove. The wood burning in the natural-draft stove had the highest PAH emissions followed by the wood combustion in the forced-draft stove and kerosene burning. LPG combustion has the highest thermal efficiency (∼57%) and the lowest PAH emissions per unit fuel energy, resulting in the lowest PAH emissions per useful energy delivered (in the unit of megajoule delivered, MJd). Compared with the wood combustion emissions, LPG burning also emits a lower fraction of higher molecular weight PAHs. In rural regions where LPG and kerosene are unavailable or unaffordable, the forced-draft fan stove is expected to be an alternative because its benzo[a]pyrene (B[a]P) emission factor (5.17-8.24 μg B[a]P/MJd) and emission rate (0.522-0.583 μg B[a]P/min) are similar to those of kerosene burning (5.36 μg B[a]P/MJd and 0.452 μg B[a]P/min). Relatively large PAH emission variability for LPG suggests a need for additional future tests to identify the major factors influencing these combustion emissions. These future tests should also account for different LPG fuel formulations and stove burner types.