Design of a 3D printed coronary artery model for CT optimization

INTRODUCTION

To design a custom phantom of the coronary arteries to optimize CT coronary angiography (CCTA) protocols.

METHODS

Characteristics of the left and right coronary arteries (mean Hounsfield Unit (HU) values and diameters) were collected from consecutive CCTA examinations (n = 43). Four different materials (two mixtures of glycerine, gelatine and water, pig hearts, Ecoflex™ silicone) were scanned inside a Lungman phantom using the CCTA protocol to find the closest model to in vivo data. A 3D printed model of the coronary artery tree was created using CCTA data by exporting a CT volume rendering into Autodesk Meshmixer™ software. The model was placed in an acid bath for 5 h, then covered in Ecoflex™, which was removed after drying. Both the Ecoflex™ and pig heart were later filled with a mixture of contrast (Visipaque 320 mg I/ml), NaCl and gelatin and scanned with different levels of tube current and iterative reconstruction (ASiR-V). Objective (HU, noise and size (vessel diameter) and subjective analysis were performed on all scans.

RESULTS

The gelatine mixtures had HU values of 130 and 129, Ecoflex™ 65 and the pig heart 56. At the different mA/ASiR-V levels the contrast filled Ecoflex™ had a mean HU 318 ± 4, noise 47±7HU and diameter of 4.4 mm. The pig heart had a mean HU of 209 ± 5, noise 38±4HU and a diameter of 4.4 mm. With increasing iterative reconstruction level the visualisation of the pig heart arteries decreased so no measurements could be performed.

CONCLUSION

The use of a 3D printed model of the arteries and casting with the Ecoflex™ silicone is the most suitable solution for a custom-designed phantom.

IMPLICATIONS FOR PRACTICE

Custom designed phantoms using 3D printing technology enable cost effective optimisation of CT protocols.