The presence and impact of diastolic dysfunction on physical function and body composition in hemodialysis patients

BACKGROUND

Cardiovascular (CV) diseases are the main cause of death in maintenance hemodialysis (MHD) patients. Muscle wasting and physical function decline are common in MHD patients, and significantly impair their quality of life. These can result from abnormalities in cardiac function, which can be further worsened by physical deconditioning. Left ventricular diastolic function parameters were recently shown to be a better predictor of exercise capacity than systolic measures in patients with CV complications. But little is known about the relationship between cardiac function and physical function in MHD patients.

METHODS

In 82 MHD patients, left ventricular systolic dysfunction (LVSD) was assessed by ejection fraction and fractional shortening with echocardiography, and left ventricular diastolic dysfunction (LVDD) was assessed by pulse wave and tissue Doppler indices. Physical function was assessed by gait speed, performance on a shuttle walk test, and leg muscle strength. Dual-emission X-ray absorptiometry (DXA) was used to measure whole body lean mass (WBLM).

RESULTS

The prevalence of LVDD and LVSD was 48.8 and 12.2%, respectively. Gait speed, shuttle walk time, leg strength, and WBLM% were significantly higher in the group without LVDD than with LVDD (p < 0.05 for all). However, there was no significant difference in any measure of physical function or body composition between patients with and without LVSD.

CONCLUSION

These data suggest that LVDD is more closely related to physical function and body composition than LVSD in MHD patients, and hence that LVDD may be an important therapeutic target.

Recommendations for natural bodybuilding contest preparation: resistance and cardiovascular training

The anabolic effect of resistance training can mitigate muscle loss during contest preparation. In reviewing relevant literature, we recommend a periodized approach be utilized. Block and undulating models show promise. Muscle groups should be trained 2 times weekly or more, although high volume training may benefit from higher frequencies to keep volume at any one session from becoming excessive. Low to high (~3-15) repetitions can be utilized but most repetitions should occur in the 6-12 range using 70-80% of 1 repetition maximum. Roughly 40-70 reps per muscle group per session should be performed, however higher volume may be appropriate for advanced bodybuilders. Traditional rest intervals of 1-3 minutes are adequate, but longer intervals can be used. Tempo should allow muscular control of the load; 1-2 s concentric and 2-3 s eccentric tempos. Training to failure should be limited when performing heavy loads on taxing exercises, and primarily relegated to single-joint exercises and higher repetitions. A core of multi-joint exercises with some single-joint exercises to address specific muscle groups as needed should be used, emphasizing full range of motion and proper form. Cardiovascular training can be used to enhance fat loss. Interference with strength training adaptations increases concomitantly with frequency and duration of cardiovascular training. Thus, the lowest frequency and duration possible while achieving sufficient fat loss should be used. Full-body modalities or cycling may reduce interference. High intensities may as well; however, require more recovery. Fasted cardiovascular training may not have benefits over fed-state and could be detrimental.