Effect of protective coating agents on microleakage and flexural strength of glass ionomer cement and zirconomer. an in vitro study

PURPOSE

The objective of this study was to assess the microleakage and flexural strength of glass ionomer cement (GIC) and modified GIC (Zirconomer) when coated with protective coating agents such as COAT-IT and G-COAT plus.

METHODS

Sixty tooth specimens were grouped into two groups based on the type of restorations (GIC (n = 30) and Zirconomer (n = 30)). The samples were further divided into three subgroups (n = 10) based on the protective coating agent (Petroleum jelly, G-COAT Plus, or COAT IT) applied. This study evaluated the microleakage at the occlusal and cervical margins of class V restoration after being subjected to dye penetration and sectioning. Each specimen was viewed under a 40 × microscope and was given scores based on the depth of dye penetration. They were statistically analyzed using the Kruskal-Wallis test and compared within the groups using the Mann- Whitney Test. In addition, flexural strength was assessed using standardized cuboid (25 × 2 × 2 mm) specimens of restorative materials with and without protective coating agents. The mean flexural strength data of all the subgroups were statistically evaluated using a one-way analysis of variance (ANOVA) and compared within the subgroups using the student t test.

RESULTS

A statistically significant difference was found when occlusal margin microleakage scores were evaluated with G-COAT Plus demonstrating the lowest occlusal margin microleakage when applied over GIC restoration. The increasing order of occlusal margin microleakage scores is as follows: GIC with G-COAT Plus, Zirconomer with COAT-IT, GIC with COAT-IT, GIC, Zirconomer with G-COAT Plus, and Zirconomer. However, the cervical margin microleakage scores revealed no significant difference. While flexural strength was found to be highest for the GIC group coated with G-COAT Plus, it was observed that there was a significant improvement in the flexural strength of both GIC and Zirconomer when coated with either of the protective coating agents.

CONCLUSION

Within the limitations of this in vitro study, it was observed that the application of protective coating agents can significantly reduce the potential microleakage and improve the flexural strength of the restorative material especially when zirconia-reinforced GIC is the restorative material.

Kidney stones in renal transplant recipients: A systematic review

INTRODUCTION

Lithiasis in renal graft recipients might be a dangerous condition with a potential risk of organ function impairment.

EVIDENCE ACQUISITION

A systematic literature search was conducted through February 2023. The primary objective was to assess the incidence of lithiasis in kidney transplant (KT) recipients. The secondary objective was to assess the timing of stone formation, localization and composition of stones, possible treatment options, and the incidence of graft loss.

EVIDENCE SYNTHESIS

A total of 41 non-randomized studies comprising 699 patients met our inclusion criteria. The age at lithiasis diagnosis ranged between 29-53 years. Incidence of urolithiasis ranged from 0.1-6.3%, usually diagnosed after 12 months from KT. Most of the stones were diagnosed in the calyces or in the pelvis. Calcium oxalate composition was the most frequent. Different treatment strategies were considered, namely active surveillance, ureteroscopy, percutaneous/combined approach, or open surgery. 15.73% of patients were submitted to extracorporeal shock wave lithotripsy (ESWL), while 26.75% underwent endoscopic lithotripsy or stone extraction. 18.03% of patients underwent percutaneous nephrolithotomy whilst 3.14% to a combined approach. Surgical lithotomy was performed in 5.01% of the cases. Global stone-free rate was around 80%.

CONCLUSIONS

Lithiasis in kidney transplant is a rare condition usually diagnosed after one year after surgery and mostly located in the calyces and renal pelvis, more frequently of calcium oxalate composition. Each of the active treatments is associated with good results in terms of stone-free rate, thus the surgical technique should be chosen according to the patient's characteristics and surgeon preferences.

An in-vitro assessment of erosive potential of a calcium-fortified fruit juice

AIM

To evaluate and compare the in vitro pH, buffer capacity and calcium loss from tooth enamel before and after calcium fortification of a packaged fruit juice.

METHODS

An approved brand of packaged mixed fruit juice was selected as a test drink on the basis of a pilot questionnaire. The test drink was fortified with 1,000 mg/l (0.1% w/v) of calcium citrate malate to obtain two test groups: Group 1: original beverage (serving as control) and Group 2: calcium-fortified drink. The pH and buffering capacity for the test drinks were measured before and after calcium fortification; 90 prepared enamel samples were divided and immersed into three test subgroups: (1) buffer solution pH 7 (positive control), (2) original fruit juice (negative control) and (3) calcium-fortified fruit juice for 3 min. Calcium loss from the enamel of immersed teeth was measured as a quantitative estimate of tooth mineral loss.

RESULTS

After calcium fortification of the fruit juice the mean pH raised from 3.4 to 4.0 (p = 0.029), the mean buffer capacity decreased from 9.73 to 9.16 (p < 0.001) and the mean calcium loss from enamel specimens decreased from 3.5 to 0.26 mg/dl (p < 0.001).

STATISTICS

To compare the change in mean pH and buffering capacity between the subject groups, t test was used, and to compare the calcium loss from enamel specimens, among the three subgroups, ANOVA was used.

CONCLUSION

Calcium fortification of packaged fruit juice in vitro, improves its pH and buffering capacity. Consequently, the fortified juice causes significantly less mineral loss from human enamel. Fortifying juice with calcium may exert a significant protective potential against dental erosion particularly due to frequent exposure of acidic drinks.

Differential expressions of bilaterally unerupted supernumerary teeth

This article presents a case of bilateral unerupted supernumerary teeth in the mandibular premolar region. Surgical removal of the right-sided supernumerary tooth had to be carried out as it was impeding the eruption of the mandibular first premolar. However, its supernumerary antimere, lay dormant.

Atypical adult non-calcified pilomatricoma

We present a rare case of a non-calcified pilomatricoma in a 67-year-old man. This tumor was extremely large in size, and its location, in the lower extremity, was very unusual. The clinical, radiographic, and histopathological features are described in detail. The role of magnetic resonance imaging (MRI) in the diagnosis of this entity is discussed. Definite internal reticulations and septations were observed. A possible explanation for this observation is that the high signal intensity reticulations may represent edematous stroma surrounding basaloid cells.

Pictorial review: foot axes and angles

Using radiographs and diagrams, this article reviews the most commonly used axes and angles of the foot, including: longitudinal axis of the rearfoot, collum tali axis, talocalcaneal angle, cuboid abduction angle, longitudinal axis of the lesser tarsus, lesser tarsus angle, talonavicular angle, longitudinal axis of the metatarsus, forefoot adductus angle, metatarsus adductus angle, first intermetatarsal angle, hallux valgus angle, proximal and distal articular set angles, and hallux interphalangeal angle, plane of support, collum tali axis, talar declination angle, calcaneal inclination axis, lateral talocalcaneal angle, first metatarsal declination axis and calcaneal inclination angle.

Pelvic fused kidneys: magnetic resonance imaging and intravenous pyelogram correlation

This is a case presentation of pelvic fused kidneys as demonstrated by intravenous pyelogram and magnetic resonance imaging (MRI). The authors wish to stress the importance of anatomical imaging with MRI in the coronal plane. No reconstruction is required as with computerized tomography.