Enhancing the coagulation process for the removal of microplastics from water by anionic polyacrylamide and natural-based Moringaoleifera

The existence of microplastics (MPs) in water is a significant global concern since they have the potential to pose a threat to human health. Therefore, there is a need to develop a sustainable treatment technology for MPs removal, as the conventional methods are inadequate to address this problem. Coagulation is a typical process in treatment plants that can capture MPs before releasing them into the environment. In this work, the removal behaviors of polyamide (PA), polystyrene (PS), and polyethylene (PE) MPs were systematically investigated through coagulation processes using aluminum sulfate (Al2(SO4)3) and Moringa oleifera (MO) seeds extract. Subsequently, the coagulation performance of Al2(SO4)3 was improved by the separate addition of anionic polyacrylamide (APAM) and naturally derived MO. Results showed that Al2(SO4)3 in combination with APAM had better performance than Al2(SO4)3 or MO alone. In the Al2(SO4)3+APAM system, the removal efficiencies were 93.47%, 81.25%, and 29.48% for PA, PS, and PE MPs, respectively. Furthermore, the effectiveness of the Al2(SO4)3 and MO blended system was approximately similar to the Al2(SO4)3+APAM system. However, the required amount of Al2(SO4)3 was decreased to 50% in the Al2(SO4)3+MO system compared to the optimal dosage in the Al2(SO4)3 system alone. The combination of 40 mg/L of Al2(SO4)3 and 60 mg/L of MO resulted in removal efficiencies of 92.99%, 80.48%, and 28.94% for PA, PS, and PE MPs, respectively. The high efficacy of these enhanced methods was due to the synergic effects of charge neutralization and agglomeration adsorption, which were validated through zeta potential assessments and visual analysis using scanning electron microscopy (SEM) images. In the case of experimental conditions, initial pH had little impact on removal efficiency, while NaCl salinity and stirring speed directly affected MPs removal. Consequently, this research took a step toward finding a green strategy to remove MPs from water systems.

Role of polyamide microplastic in altering microbial consortium and carbon and nitrogen cycles in a simulated agricultural soil microcosm

Microplastics (MPs) are persistent organic pollutants globally, with a continuous increase in MP wastes near and away from the regions of human activities. Studies to date aimed to explore the impact of MPs on ecosystems, but the area of research could not go beyond environmental pollution caused by MPs. To address the menace of MPs, scientists need to pay enough attention to the biogeochemical cycles, microbial communities, and functional microorganisms. Hence, this study aimed to evaluate the impact of adding 0.3% (mass ratio) [low-concentration (LC) group] and 1% [high-concentration (HC) group] of polyamide (PA) MP to the soil microenvironment with regard to the aforementioned parameters. PA MP decreased the soil microbial diversity (Shannon and Simpson indices, P < 0.05). At the phylum level, PA MP increased the abundance of Acidobacteria, Firmicutes, and Crenarchaeota (P < 0.05); at the genus level, it enhanced that of Geobacter, Thiobacillus, Pseudomonas, and Bradyrhizobium (P < 0.01) while decreased that of Bacillus, Flavisolibacter, Geothrix, and Pseudarthrobacter (P < 0.05). PA MP affected the carbon (C) cycle. PA MP accelerated the soil C fixation by enhancing the abundance of the genes accA and pccA. The LC PA MP accelerated organic C degradation and methane metabolism by changing the abundance of mnp, chiA, mcrA, pmoA, and mmoX genes, while the HC PA MP inhibited them with increasing the experimental time. Regarding the effects of PA on the nitrogen (N) cycle, the PA MP promoted N assimilation and ammonification by increasing the abundance of the genes gdh and ureC, the impact of PA MP on N fixation and denitrification depended on its concentration and treating time. This study showed that PA MP impacted the microbial consortium, it also affected the C and N cycles and its effect depended on its concentration and the treating time.