Activity of zinc oxide and zinc borate nanoparticles against resistant bacteria in an experimental lung cancer model

BACKGROUND

Recent research indicates a prevalence of typical lung infections, such as pneumonia, in lung cancer patients. Klebsiella pneumoniae, Pseudomonas aeruginosa, and Acinetobacter baumannii stand out as antibiotic-resistant pathogens. Given this, there is a growing interest in alternative therapeutic avenues. Boron and zinc derivatives exhibit antimicrobial, antiviral, and antifungal properties.

OBJECTIVES

This research aimed to establish the effectiveness of ZnO and ZB NPs in combating bacterial infections in lung cancer cell lines.

METHODS

Initially, this study determined the minimal inhibitory concentration (MIC) and fractional inhibitory concentration (FIC) of zinc oxide nanoparticles (ZnO NPs) and zinc borate (ZB) on chosen benchmark strains. Subsequent steps involved gauging treatment success through a lung cancer-bacteria combined culture and immunohistochemical analysis.

RESULTS

The inhibitory impact of ZnO NPs on bacteria was charted as follows: 0.97 µg/mL for K. pneumoniae 700603, 1.95 µg/mL for P. aeruginosa 27853, and 7.81 µg/mL for Acinetobacter baumannii 19,606. In comparison, the antibacterial influence of zinc borate was measured as 7.81 µg/mL for Klebsiella pneumoniae 700603 and 500 µg/mL for both P. aeruginosa 27853 and A.baumannii 19606. After 24 h, the cytotoxicity of ZnO NPs and ZB was analyzed using the MTT technique. The lowest cell viability was marked in the 500 µg/mL ZB NPs group, with a viability rate of 48.83% (P < 0.001). However, marked deviations appeared at ZB concentrations of 61.5 µg/mL (P < 0.05) and ZnO NPs at 125 µg/mL.

CONCLUSION

A synergistic microbial inhibitory effect was observed when ZnO NP and ZB were combined against the bacteria under investigation.

Management of ground tire rubber waste by incorporation into polyurethane-based composite foams

Rapid economic growth implicated the developing multiple industry sectors, including the automotive branch, increasing waste generation since recycling and utilization methods have not been established simultaneously. A very severe threat is the generation of enormous amounts of post-consumer tires considered burdensome waste, e.g., due to the substantial emissions of volatile organic compounds (VOCs). Therefore, it is essential to develop novel, environmentally friendly methods for their utilization, which would hinder their environmental impacts. One of the most promising approaches is shredding, resulting in the generation of ground tire rubber (GTR), which can be introduced into polymeric materials as filler. The presented work is related to the thermomechanical treatment of GTR in a twin-screw extruder with zinc borate, whose incorporation is aimed to enhance shear forces within the extruder barrel. Modified GTR was introduced into flexible polyurethane (PU) foams, and the impact of modification parameters on the cellular structure, static and dynamic mechanical performance, thermal stability, as well as thermal insulation, and acoustic properties was investigated. Emissions of VOCs from applied fillers and prepared composites were monitored and evaluated. Depending on the treatment parameters, beneficial changes in foams' cellular structure were noted, which enhanced their thermal insulation performance, mechanical strength, and thermal stability. It was proven that the proposed method of GTR thermomechanical treatment assisted by zinc borate particles might benefit the performance of flexible PU foamed composites and hinder VOC emissions, which could broaden the application range of GTR and provide novel ways for its efficient utilization.

Boron Compound-Based Treatments Against Multidrug-Resistant Bacterial Infections in Lung Cancer In Vitro Model

Multidrug-resistant bacteria is one of the most important public health problems. Increasing rates of antibacterial resistance also affect the outcomes of medical approaches. Cancer treatment because of immune system deficiency (chemotherapy or steroids usage) commonly can cause infection. Lung cancer is the dominant cause of cancer-related deaths, and infection is the most common cause of death among those patients. In this study, it was aimed to determine the antimicrobial, antibiofilm, and anticancer activity of boron compounds. A549 lung cancer cell line was infected with Acinetobacter baumannii (ATCC 19606), Klebsiella pneumoniae (ATCC 700603), and Pseudomonas aeruginosa (ATCC 27853). In order to determine the fractional inhibitory concentration (FIC) index, antibiotics and boron compound concentrations prepared according to the minimum inhibitory concentration (MIC) values were determined by the checkerboard method. In our study results, the antibiofilm activity was an average of 46% in A. baumannii+boron compounds, 45% in P. aeruginosa+boron compounds, and 43% in K. pneumoniae. Cell culture analysis results show a decrease in viability and antioxidant capacity and an increase in total oxidant status after adding boron compounds to the culture. Immunofluorescence results show a correlation with MTT, and boron compounds increased 8-OHdG expression in comparison to antibiotic administration. In conclusion, boron compounds have promising effects on bacteria, especially in resistant bacteria spp.

Effect of surfactant types on particle size and morphology of flame-retardant zinc borate powder

Zinc borate is a boron-containing chemical material that is used to increase the flame retardancy of polymeric materials, dyes, cables, fabrics, carpets, and the internal parts of automobiles and planes. Commercially used zinc borate, which has the formula of 2ZnO·3B ₂ O ₃ ·7H ₂ O, has a particle size between 10 and 20 μm. However, recent studies have shown that nanosized flame retardants have more superior flame retardancy and less negative effects on mechanical properties than microsized flame retardants. Nanosized flame retardants disperse more homogeneously and even low quantities are sufficient to provide high flame resistance. In this study, nano zinc borate powder was synthesized by a wet chemical method and the effects of nonionic, anionic, and cationic surfactants on the particle size and morphology of the zinc borate particles were investigated. Chemical purity and physical structures of the synthesized zinc borate powder were analyzed by XRD, FTIR, TG-DTA, TEM, and Zetasizer. The analysis results showed that the zinc borate powder had a chemical formula of 2ZnO·3B ₂ O ₃ ·7H ₂ O. TEM and Zetasizer results indicated that the nano zinc borate powder, which had nanoscale particle size distribution with needle- and flake-like structures, was synthesized using nonionic, anionic, and cationic surfactants.

Hydrothermal synthesis of 4ZnO·B2O3·H2O:Ln3+ (Ln=Eu, Tb) phosphors: Morphology-tunable and luminescence properties

4ZnO·B₂O₃·H₂O:Ln³⁺ (Ln=Eu, Tb) phosphors with different morphologies have been successfully synthesized via one-step hydrothermal method through regulating the molar amount of Eu³⁺ and Tb³⁺. Comprehensive scanning electron microscopy (SEM), X-ray diffraction (XRD) Fourier transform infrared spectrum (FT-IR) and inductively coupled plasma atomic emission spectrometer (ICP-AES) characterizations all confirm that obtained products are 4ZnO·B₂O₃·H₂O:Ln³⁺ (Ln=Eu, Tb). The experimental results displayed that the morphology and photoluminescence of compounds is regularly changed with increased the molar amount of rare earth ions. For the Eu³⁺-doped, Tb³⁺-doped and Eu³⁺/Tb³⁺ co-doped 4ZnO·B₂O₃·H₂O phosphors of morphologies, the rod-like structures gradually changed to flower-like structures, fine wire-like structure and hybrid structure, respectively. To their photoluminescence, the Eu³⁺ shows a red emission (615nm); the Tb³⁺ shows a green emission (545nm); for the Eu³⁺/Tb³⁺ co-doped 4ZnO·B₂O₃·H₂O phosphors, a combination of blue (5d-4f of Eu²⁺), green (⁵D₄-⁷F₅ of Tb³⁺) and red (⁵D₀-⁷F₂ of Eu³⁺) emissions emerges to achieve white emission. In addition, the energy transfer among Eu³⁺, Eu²⁺ and Tb³⁺ ions was also discussed.