Achieving zero fouling in the ultrafiltration for secondary water supply systems in the absence of residual chlorine

Ultrafiltration (UF) technology is widely used in secondary water supply systems (SWSS) to provide high-quality drinking water. However, the challenge of severe membrane fouling, which leads to frequent cleaning requirements, makes UF maintenance intensive. In this study, we tried to validate the feasibility of achieving zero fouling without the need for cleaning in the UF for SWSS, i.e., the fouling resistance can be maintained for a very long time without any increase. We operated dead-end UF systems at different fluxes, both with and without residual chlorine, and monitored the formation of fouling layers during filtration. The results demonstrated the successful achievement of zero fouling under a flux of 10 L/(m2 h) in the absence of chlorine, evidenced by no increase in transmembrane pressure for three months. This zero-fouling phenomenon was attributed to the formation of a self-regulating biofouling layer. This biofouling layer could degrade the deposited foulants and featured a loose morphology, facilitated by microbial activities in the cake layer. Although residual chlorine reduced the fouling rate by half at a flux of 30 L/(m2 h), it hindered the achievement of zero fouling at the lower flux of 10 L/(m2 h), due to its inhibitory effect on microbial activity. Intermittent operation of UF was effective in achieving zero fouling at higher fluxes (e.g., 30 L/(m2 h)). This benefit was primarily ascribed to the biodegradation of accumulated foulants and the expansion of biofouling layer during the pause of the intermittent filtration, which prompted the formation of biofouling layers with loose structure and balanced composition. To the best of our knowledge, this study is the first attempt to achieve zero fouling in UF for SWSS, and the findings may offer valuable insights for the development of cleaning-free and low-maintenance membrane processes.

Development of a low-maintenance measurement approach to continuously estimate methane emissions: A case study

The chemical breakdown of organic matter in landfills represents a significant source of methane gas (CH₄). Current estimates suggest that landfills are responsible for between 3% and 19% of global anthropogenic emissions. The net CH₄ emissions resulting from biogeochemical processes and their modulation by microbes in landfills are poorly constrained by imprecise knowledge of environmental constraints. The uncertainty in absolute CH₄ emissions from landfills is therefore considerable. This study investigates a new method to estimate the temporal variability of CH₄ emissions using meteorological and CH₄ concentration measurements downwind of a landfill site in Suffolk, UK from July to September 2014, taking advantage of the statistics that such a measurement approach offers versus shorter-term, but more complex and instantaneously accurate, flux snapshots. Methane emissions were calculated from CH₄ concentrations measured 700m from the perimeter of the landfill with observed concentrations ranging from background to 46.4ppm. Using an atmospheric dispersion model, we estimate a mean emission flux of 709μgm^-2s^-1 over this period, with a maximum value of 6.21mgm^-2s^-1, reflecting the wide natural variability in biogeochemical and other environmental controls on net site emission. The emissions calculated suggest that meteorological conditions have an influence on the magnitude of CH₄ emissions. We also investigate the factors responsible for the large variability observed in the estimated CH₄ emissions, and suggest that the largest component arises from uncertainty in the spatial distribution of CH₄ emissions within the landfill area. The results determined using the low-maintenance approach discussed in this paper suggest that a network of cheaper, less precise CH₄ sensors could be used to measure a continuous CH₄ emission time series from a landfill site, something that is not practical using far-field approaches such as tracer release methods. Even though there are limitations to the approach described here, this easy, low-maintenance, low-cost method could be used by landfill operators to estimate time-averaged CH₄ emissions and their impact downwind by simultaneously monitoring plume advection and CH₄ concentrations.