Refractive Lenticule Implantation for Correction of Ametropia: Case Reports and Literature Review

The ReLEx® technique allows correction of refractive errors through the creation and extraction of refractive stromal lenticules. Contrary to excimer laser corneal refractive procedures, where the stromal tissue is photoablated, the extracted lenticules obtained with ReLEx® can be preserved. Recent studies and case reports have described autologous re-implantation and allogeneic implantation of refractive lenticules into femtosecond-laser created stromal pockets in order to reverse the refractive outcome of a myopic corneal refractive procedure, correct hyperopia, aphakia, presbyopia and treat keratoconus. The use of stromal lenticules has also been described for therapeutic purposes, with an allogenic lenticule being transplanted under a LASIK flap in order to restore corneal volume and reduce the refractive error in a case of excessive stromal tissue removal after LASIK. This review summarises the results of the latest case reports and studies that describe the implantation of cryopreserved or fresh refractive stromal lenticules and discusses the feasibility, safety and refractive outcomes of the procedure, on the basis of published literature as well as our own experience.

Metal-Free CVD Graphene Synthesis on 200 mm Ge/Si(001) Substrates

Good quality, complementary-metal-oxide-semiconductor (CMOS) technology compatible, 200 mm graphene was obtained on Ge(001)/Si(001) wafers in this work. Chemical vapor depositions were carried out at the deposition temperatures of 885 °C using CH₄ as carbon source on epitaxial Ge(100) layers, which were grown on Si(100), prior to the graphene synthesis. Graphene layer with the 2D/G ratio ∼3 and low D mode (i.e., low concentration of defects) was measured over the entire 200 mm wafer by Raman spectroscopy. A typical full-width-at-half-maximum value of 39 cm^-1 was extracted for the 2D mode, further indicating that graphene of good structural quality was produced. The study also revealed that the lack of interfacial oxide correlates with superior properties of graphene. In order to evaluate electrical properties of graphene, its 2 × 2 cm² pieces were transferred onto SiO₂/Si substrates from Ge/Si wafers. The extracted sheet resistance and mobility values of transferred graphene layers were ∼1500 ± 100 Ω/sq and μ ≈ 400 ± 20 cm²/V s, respectively. The transferred graphene was free of metallic contaminations or mechanical damage. On the basis of results of DFT calculations, we attribute the high structural quality of graphene grown by CVD on Ge to hydrogen-induced reduction of nucleation probability, explain the appearance of graphene-induced facets on Ge(001) as a kinetic effect caused by surface step pinning at linear graphene nuclei, and clarify the orientation of graphene domains on Ge(001) as resulting from good lattice matching between Ge(001) and graphene nucleated on such nuclei.

[Three Years Follow-up Study after Refractive Small Incision Lenticule Extraction (SMILE) Using 500 kHz Femtosecond Laser in "Fast Mode"]

Background  The aim of this clinical trial was to check the results of laser built-in settings 3 years after ReLEx SMILE for moderate and high myopia in unselected "real life" patients. Patients and Methods  50 myopic eyes of 27 patients were called in for examination after 3 years. 25 of these eyes with a preoperative myopia under - 6D comprised the "moderate myopia subgroup". All surgeries were performed with the 500 kHz VisuMax® femtosecond laser (Carl Zeiss Meditec AG, Jena) in the "fast mode" setting. Results  The spherical equivalent (SE) of the entire group changed from - 6.18 D (± 1.91) prior to surgery to - 0.18 D (± 0.39) 3 years later. The preoperative SE in the moderate myopia subgroup changed from - 4.71 D (± 0.94) to - 0.04 D (± 0.23). 14 % of 50 eyes gained one line and 22 % lost one line of CDVA. The regression between month 3 and 36 was 0.07D for the entire group and 0.06 D for the moderate myopia subgroup. There were no late side effects. Primary undercorrection was predominantly seen in eyes over - 6 D. Conclusion  ReLEx SMILE shows remarkable stability over the entire range of myopias after 3 years, however primary undercorrection occurs predominantly in eyes of - 6.0 D, which necessitates nomogram adjustment.

Integrated on-chip mass spectrometry reaction monitoring in microfluidic devices containing porous polymer monolithic columns

Chip-based microfluidics enable the seamless integration of different functions into single devices. Here, we present microfluidic chips containing porous polymer monolithic columns as a means to facilitate chemical transformations as well as both downstream chromatographic separation and mass spectrometric analysis. Rapid liquid phase lithography prototyping creates the multifunctional device economically.

Transformation of epitaxial NiMnGa/InGaAs nanomembranes grown on GaAs substrates into freestanding microtubes

NiMnGa/InGaAs nanomembranes grown by epitaxy on semiconductor substrates are transformed into freestanding microtubes using self assembly techniques and are investigated.

[Central pattern generators in the spinal cord of the cat and their relevance in rehabilitation after spinal lesion]

The ability of the spinal cord to recover after partial or complete transection, and even reinitiate motor function, was investigated in several studies in cats. It has been shown that even after a complete spinalisation at the level of T12/T13, the possibility of restoration of hind-limb function is good. Central pattern generators (CPGs), located in the spinal cord, play an important role in this situation. Although CPGs alone are unable to restore function, the combination of CPGs with targeted and consistent mobility training and, in some cases, hind-limb sensory stimulation is essential to improve function. These result in a reorganisation of the CPGs and neuronal networks in the spinal cord. The age of the animal at the time of injury and the extent and localisation of lesions, play a crucial role in recovery. A new focus of research is the influence of neurotransmitters/neuromodulators on spinal-cord regeneration. How and to what extent these factors support locomotor training remains for further clinical investigation.

[Retropupillary iris claw intraocular lens implantation technique for aphakia]

BACKGROUND

Overview of the retropupillary implantation of iris claw intraocular lenses (Artisan®,Ophtec, Groningen, Niederlande and Verisyse(TM),AMO, Santa Ana CA).

MATERIAL AND METHODS

A literature search and review of implantation techniques, patient selection, potential complications and management strategies.

RESULTS

This approach has the advantage of a simple implantation technique, an anatomically correct implantation site (as compared to endocapsular implantation) and a relatively low complication rate. An intact iris is, however, a prerequisite for this technique. Ischemic vitreoretinopathies, such as diabetes or vascular occlusive entities, as well as uveitis might be considered as contraindications.

CONCLUSIONS

The retropupillary implantation of iris claw intraocular lenses is an interesting and especially time-effective rehabilitation technique for aphakia.

[Combination of different techniques for secondary anchoring of intraocular lenses]

BACKGROUND

The four fundamental techniques of secondary intraocular lens (IOL) fixation, namely sulcus placement, scleral or iris suture fixation and scleral haptic fixation can be combined in special situations.

AIM

When is a combination of different techniques advisable?

METHODS

This article describes our experiences and gives an example of combined technique use.

RESULTS

These situations arise in cases when neighboring ocular structures are only partially preserved or show particular distinctive defects that can be repaired at the time of secondary IOL anchoring. This article presents a case of IOL-induced iris chafing and traumatic iridodialysis which was closed by a combined technique of iris suture and scleral suture fixation.

CONCLUSION

A combination of different anchoring techniques for secondary IOL implantation can achieve a simultaneous repair of perilenticular structures and reduce the amount of suture material used.

[Implantation of intraocular lenses in the ciliary sulcus]

Implantation of an intraocular lens (IOL) into the ciliary sulcus is the second most common implantation site after the regular capsular bag (in the bag) placement of an IOL. Although mainly not primarily intended, it is very often used in both complicated cataract surgery and secondary implantation due to IOL dislocation or aphakia. In most cases stable positioning is possible, especially when using optic capture techniques. A variety of difficulties can occur with sulcus implantation depending on the anatomical and surgical conditions present at the time of implantation. The most anterior position of the sulcus lense has to be considered for calculation of the refractive power of the IOL.

Compact metal probes: a solution for atomic force microscopy based tip-enhanced Raman spectroscopy

There are many challenges in accomplishing tip-enhanced Raman spectroscopy (TERS) and obtaining a proper tip is probably the greatest one. Since tip size, composition, and geometry are the ultimate parameters that determine enhancement of intensity and lateral resolution, the tip becomes the most critical component in a TERS experiment. However, since the discovery of TERS the cantilevers used in atomic force microscopy (AFM) have remained basically the same: commercial silicon (or silicon nitride) tips covered by a metallic coating. The main issues of using metal-coated silicon cantilevers, such as wearing off of the metal layer or increased tip radius, can be completely overcome by using all-metal cantilevers. Until now in TERS experiments such probes have only been used in a scanning tunneling microscope or in a tuning fork-based shear force microscope but not in AFM. In this work for the first time, we show the use of compact silver cantilevers that are fully compatible with contact and tapping modes in AFM demonstrating their superb performance in TERS experiments.

Effects of phytoestrogen extracts isolated from flax on hormone production of trophoblast tumour cells Jeg 3 and BeWo

AIM AND SETTING: To test the effects of crude extracts from flax (Linum usitatissimum) on progesterone and estradiol and ERα and β/PR production in choriocarcinoma cell lines Jeg 3 and BeWo. Tumor trophoblast cells (Jeg 3 and BeWo) were incubated in the presence of different concentrations of the flax crude extracts. Estradiol and progesterone production was measured. Estrogen receptor α and β as well as progesterone receptor expressions were also assessed.

RESULTS

In Jeg 3 cells, progesterone production was downregulated by flax root and leaves extract, while in BeWo cells only flax root extract did manage to downregulate progesterone production. ERβ expression was significantly downregulated by flax root and flax leaves extract in both cell lines; on the contrary, ERα expression was increased by flax leaves extract in BeWo cells. PR expression was downregulated by flax leaves extract in Jeg 3 and by flax root extract in BeWo cells.

CONCLUSION

Flax extracts derived from leaves and especially from roots can modify progesterone and possibly estradiol production, while at the same time they seem to alter ERβ expression. Further studies on animal models and adequately designed retrospective epidemiological studies are imperative to clarify this role upon progesterone.

Gold nanoparticles generated by thermolysis of "all-in-one" gold(I) carboxylate complexes

Consecutive synthesis methodologies for the preparation of the gold(I) carboxylates [(Ph(3)P)AuO(2)CCH(2)(OCH(2)CH(2))(n)OCH(3)] (n = 0-6) (6a-g) are reported, whereby selective mono-alkylation of diols HO(CH(2)CH(2)O)(n)H (n = 0-6), Williamson ether synthesis and metal carboxylate (Ag, Au) formation are the key steps. Single crystal X-ray diffraction studies of 6a (n = 0) and 6b (n = 1) were carried out showing that the P-Au-O unit is essentially linear. These compounds were applied in the formation of gold nanoparticles (NP) by a thermally induced decomposition process and hence the addition of any further stabilizing and reducing reagents, respectively, is not required. The ethylene glycol functionalities, providing multiple donating capabilities, are able to stabilise the encapsulated gold colloids. The dependency of concentration, generation time and ethylene glycol chain lengths on the NP size and size distribution is discussed. Characterisation of the gold colloids was performed by TEM, UV/Vis spectroscopy and electron diffraction studies revealing that Au NP are formed with a size of 3.3 (±0.6) to 6.5 (±0.9) nm in p-xylene with a sharp size distribution. Additionally, a decomposition mechanism determined by TG-MS coupling experiments of the gold(i) precursors is reported showing that 1(st) decarboxylation occurs followed by the cleavage of the Au-PPh(3) bond and finally release of ethylene glycol fragments to give Au-NP and the appropriate organics.