Comparative study of precise measurements of natural radionuclides and radiation dose using in-situ and laboratory γ-ray spectroscopy techniques

In this study, in-situ and laboratory γ-ray spectroscopy techniques were compared to evaluate the activity concentration of natural radionuclides in soil. The activity concentrations of 238U (226Ra), 232Th, and 40K in the soil in 11 sites were simultaneously measured with in-situ portable HPGe and the NaI(Tl) detectors. In parallel, 55 soil samples collected from these sites were analyzed with a laboratory γ-ray spectroscopy technique (HPGe). A strong correlation was observed between the in-situ and laboratory HPGe techniques with a linear correlation coefficient (R2) of 0.99 for 226Ra and 232Th and 0.975 for 40K, respectively. The in-situ HPGe technique shows a strong correlation with the NaI(Tl) detector. γ-Rays cps of 226Ra, 232Th, and 40K of the NaI (Tl) detector were then converted to specific activities (Bq kg-1 unit) in soil using the empirical formulas obtained in this study. The absorbed dose rate in air at 1 m height above ground due to these radionuclides was calculated using the Beck's formula and the results were compared with measured values obtained with an high pressure ionization chamber. The results of the calculated and measured dose rate show a strong correlation of R2 = 0.96. The reliability and precision of analytical spectroscopy techniques of radioactivity and radiation dose were confirmed in this work.

Surface Modification of CdSe Quantum-Dot Floating Gates for Advancing Light-Erasable Organic Field-Effect Transistor Memories

Photoresponsive transistor memories that can be erased using light-only bias are of significant interest owing to their convenient elimination of stored data for information delivery. Herein, we suggest a strategy to improve light-erasable organic transistor memories, which enables fast "photoinduced recovery" under low-intensity light. CdSe quantum dots (QDs) whose surfaces are covered with three different organic molecules are introduced as photoactive floating-gate interlayers in organic transistor memories. We determine that CdSe QDs capped or surface-modified with small molecular ligands lead to efficient hole diffusion from the QDs to the conducting channel during "photoinduced recovery", resulting in faster erasing times. In particular, the memories with QDs surface-modified with fluorinated molecules function as normally-ON type transistor memories with nondestructive operation. These memories exhibit high memory ratios over 10⁵ between OFF and ON bistable current states for over 10 000 s and good dynamic switching behavior with voltage-driven programming processes and light-assisted erasing processes within 1 s. Our study provides a useful guideline for designing photoactive floating-gate materials to achieve desirable properties of light-erasable organic transistor memories.

Evolving affinity between Coulombic reversibility and hysteretic phase transformations in nano-structured silicon-based lithium-ion batteries

Nano-structured silicon is an attractive alternative anode material to conventional graphite in lithium-ion batteries. However, the anode designs with higher silicon concentrations remain to be commercialized despite recent remarkable progress. One of the most critical issues is the fundamental understanding of the lithium-silicon Coulombic efficiency. Particularly, this is the key to resolve subtle yet accumulatively significant alterations of Coulombic efficiency by various paths of lithium-silicon processes over cycles. Here, we provide quantitative and qualitative insight into how the irreversible behaviors are altered by the processes under amorphous volume changes and hysteretic amorphous-crystalline phase transformations. Repeated latter transformations over cycles, typically featured as a degradation factor, can govern the reversibility behaviors, improving the irreversibility and eventually minimizing cumulative irreversible lithium consumption. This is clearly different from repeated amorphous volume changes with different lithiation depths. The mechanism behind the correlations is elucidated by electrochemical and structural probing.

Imidazolium Iodide-Doped PEDOT Nanofibers as Conductive Catalysts for Highly Efficient Solid-State Dye-Sensitized Solar Cells Employing Polymer Electrolyte

The electrical conductivity and catalytic activity of nanofibrous poly(3,4-ethylenedioxythiophene)s (PEDOT NFs) was improved by redoping with dimethyl imidazolium iodide (DMII) as a charge transfer facilitator. Addition of the new DMII dopant into the PEDOT NFs reduced the concentration of dodecyl sulfate anions (DS^-) predoped during the polymerization process and concomitantly enhanced the doping concentration of I^- by ion exchange. Redoping with DMII increased the mobility of the PEDOT NFs by up to 18-fold and improved the conductivity due to the enhanced linearization, suppressed aggregation, and improved crystallinity of the PEDOT chains. The catalytic activity was also improved, primarily due to the increase in the compatibility and the effective surface area upon replacement of sticky DS^- with the more basic and smaller I^- of DMII on the surface of the PEDOT NFs. The charge-transfer resistance across the interface between the poly(ethylene oxide)-based solid polymer electrolyte and PEDOT NF counter electrode (CE) was thus reduced to a large extent, giving an energy conversion efficiency (ECE) of 8.52% for solid-state dye-sensitized solar cells (DSCs), which is even better than that achieved with Pt CE (8.25%). This is the highest ECE reported for solid-state DSCs with conductive polymer CEs under 1 sun conditions.

The effect of surfactants on electrohydrodynamic jet printing and the performance of organic field-effect transistors

In this article, we report on the direct writing of multi-walled carbon nanotube (MWCNT) composite inks based on three different surfactants via the electrohydrodynamic (EHD) jet printing technique.

Direct Writing and Aligning of Small-Molecule Organic Semiconductor Crystals via "Dragging Mode" Electrohydrodynamic Jet Printing for Flexible Organic Field-Effect Transistor Arrays

Patterning and aligning of organic small-molecule semiconductor crystals over large areas is an important issue for their commercialization and practical device applications. This Letter reports "dragging mode" electrohydrodynamic jet printing that can simultaneously achieve direct writing and aligning of 6,13-bis(triisopropylsilylethynyl) pentacene (TIPS-PEN) crystals. Dragging mode provides favorable conditions for crystal growth with efficient controls over supply voltages and nozzle-to-substrate distances. Optimal printing speed produces millimeter-long TIPS-PEN crystals with unidirectional alignment along the printing direction. These crystals are highly crystalline with a uniform packing structure that favors lateral charge transport. Organic field-effect transistors (OFETs) based on the optimally printed TIPS-PEN crystals exhibit high field-effect mobilities up to 1.65 cm²/(V·s). We also demonstrate the feasibility of controlling pattern shapes of the crystals as well as the fabrication of printed flexible OFET arrays.

VUV spectroscopy in impurity injection experiments at KSTAR using prototype ITER VUV spectrometer

The ITER vacuum ultra-violet (VUV) core survey spectrometer has been designed as a 5-channel spectral system so that the high spectral resolving power of 200-500 could be achieved in the wavelength range of 2.4-160 nm. To verify the design of the ITER VUV core survey spectrometer, a two-channel prototype spectrometer was developed. As a subsequent step of the prototype test, the prototype VUV spectrometer has been operated at KSTAR since the 2012 experimental campaign. From impurity injection experiments in the years 2015 and 2016, strong emission lines, such as Kr xxv 15.8 nm, Kr xxvi 17.9 nm, Ne vii 46.5 nm, Ne vi 40.2 nm, and an array of largely unresolved tungsten lines (14-32 nm) could be measured successfully, showing the typical photon number of 10¹³-10¹⁵ photons/cm² s.

Environmental Escherichia coli: ecology and public health implications-a review

Escherichia coli is classified as a rod-shaped, Gram-negative bacterium in the family Enterobacteriaceae. The bacterium mainly inhabits the lower intestinal tract of warm-blooded animals, including humans, and is often discharged into the environment through faeces or wastewater effluent. The presence of E. coli in environmental waters has long been considered as an indicator of recent faecal pollution. However, numerous recent studies have reported that some specific strains of E. coli can survive for long periods of time, and potentially reproduce, in extraintestinal environments. This indicates that E. coli can be integrated into indigenous microbial communities in the environment. This naturalization phenomenon calls into question the reliability of E. coli as a faecal indicator bacterium (FIB). Recently, many studies reported that E. coli populations in the environment are affected by ambient environmental conditions affecting their long-term survival. Large-scale studies of population genetics revealed the diversity and complexity of E. coli strains in various environments, which are affected by multiple environmental factors. This review examines the current knowledge on the ecology of E. coli strains in various environments with regard to its role as a FIB and as a naturalized member of indigenous microbial communities. Special emphasis is given on the growth of pathogenic E. coli in the environment, and the population genetics of environmental members of the genus Escherichia. The impact of environmental E. coli on water quality and public health is also discussed.