Extraction and preconcentration of salbutamol and terbutaline from aqueous samples using hollow fiber supported liquid membrane containing anionic carrier

Micro-scale membrane extraction of glyphosate and aminomethylphosphonic acid in water followed by high-performance liquid chromatography and post-column derivatization with fluorescence detector

A carrier-mediated supported liquid membrane micro-extraction using single hollow fiber membrane suitable for the determination of the herbicide glyphosate and its main metabolite aminomethylphosphonic acid in water is reported. A solution of 0.20 M Aliquat-336, a cationic carrier, in di-n-hexyl ether was selected as the supported liquid. A 20 microL of 1.0 M potassium chloride as the acceptor phase was filled in the membrane lumen. The membrane was immersed in a 20 mL of pH 9.0 sample solution. After 60-min extraction, the acceptor phase was analyzed by high-performance liquid chromatography with post-column derivatization. The enrichment factors were found to be 853 and 136 for glyphosate and aminomethylphosphonic acid, respectively. The method detection limits are 0.22 microg/L for glyphosate and 3.40 microg/L for aminomethylphosphonic acid. The procedure was validated and showed good accuracy and precision over a large linear dynamic range. The validated method was tested for the analysis of both analytes in spiked groundwater with good success.

Liquid-phase microextraction with porous hollow fibers, a miniaturized and highly flexible format for liquid–liquid extraction

Since 1999, substantial research has been devoted to the development of liquid-phase microextraction (LPME) based on porous hollow fibers. With this technology, target analytes are extracted from aqueous samples, through a thin supported liquid membrane (SLM) sustained in the pores in the wall of a porous hollow fiber, and further into a microL volume of acceptor solution placed inside the lumen of the hollow fiber. After extraction, the acceptor solution is directly subjected to a final chemical analysis by liquid chromatography (HPLC), gas chromatography (GC), capillary electrophoresis (CE), or mass spectrometry (MS). In this review, LPME will be discussed with focus on extraction principles, historical development, fundamental theory, and performance. Also, major applications have been compiled, and recent forefront developments will be discussed.

Solid substrate-room temperature phosphorimetry for the determination of trace terbutaline sulfate based on its inhibition oxidation of rhodamine 6G by sodium periodate

When 1.00 mol l(-1) I(-) is used as ion perturber, rhodamine 6G (Rh 6G) can emit strong and stable room temperature phosphorescence (RTP) on filter paper substrate in KHC(8)H(4)O(4)-HCl buffer solution (pH = 3.50), heated at 70 degrees C for 10 min. NaIO(4) can oxidize Rh 6G, which makes the RTP signal quench. Terbutaline sulfate (TBS) can inhibit NaIO(4) from oxidizing Rh 6G, which makes the RTP signal of Rh 6G enhance sharply. The content of TBS is linear correlation to DeltaIp of the system. Based on the facts above, a new inhibition solid substrate-room temperature phosphorimetry (SS-RTP) for the determination of trace TBS has been established. The linear range of this method is 0.0104-2.08 pg spot(-1) (corresponding concentration: 0.026-5.2 ng ml(-1), with a sample volume of 0.4 microl) with a detection limit (L.D.) of 2.6 fg spot(-1) (corresponding concentration: 6.5 x 10(-12) g ml(-1)), and the regression equation of working curve is DeltaIp = 2.040 + 54.54 m(TBS) (pg spot(-1)), n = 6, correlation coefficient is 0.9994. For the samples containing 0.0104 pg spot(-1) and 2.08 pg spot(-1) TBS, the relative standard deviation (RSD) are 3.8% and 2.3% (n = 8), respectively, indicating good precision. This method has been applied to determination of trace TBS in the practical samples with satisfactory results. The reaction mechanism of NaIO(4) oxidizing Rh 6G to inhibit SS-RTP for the determination of trace TBS is also discussed.

Hollow-fibre supported liquid membrane extraction for determination of fluoxetine and norfluoxetine concentration at ultra trace level in sewage samples

In this study, a method was developed for determining the concentration of the pharmaceutical fluoxetine and its metabolite, norfluoxetine, in sewage water samples. Sample preparation was performed by hollow-fibre supported liquid membrane (HF-SLM) extraction with final analysis using liquid chromatography with UV detection. Several parameters were studied including type of organic solvent, sample and acceptor pH, and salt and humic acid content. The optimised method allowed determination of the analyte at the ng/L level in sewage water. A linear plot gave a correlation coefficient better than 0.991 for both analytes and resulted in limits of detection in sewage water of 11 and 12 ng/L, for fluoxetine and norfluoxetine, respectively. The enrichment factor was over 1700 for both analytes in sewage water. The repeatability and reproducibility were better than 8% and 17%, respectively. The developed methodology was used to study daily variations of fluoxetine and norfluoxetine in municipal sewage streams. Norfluoxetine has been detected for the first time in sewage water and a preliminary analysis gave average concentrations of 150 and 225 ng/L for norfluoxetine and fluoxetine, respectively.

Three phase liquid phase microextraction of phenylacetic acid and phenylpropionic acid from biological fluids

Three phase liquid phase microextraction (three phase LPME) technique coupled with HPLC-UV has been applied as a sensitive and efficient sample preparation method to determine phenylacetic acid (PAA) as a biomarker of depressive disorders and phenylpropionic acid (PPA) in biological fluids. The compounds were extracted from 3.0 ml aqueous solution with the adjustment of pH at a fixed value in the range of 2.0-3.5 (donor solution) into an organic phase (1-hexanol) layered on the surface of the donor solution and finally back-extracted into 4.0 microl of the acceptor microdrop (pH 11.1) located at the end of the microsyringe needle. After a prescribed back-extraction time, the acceptor microdrop was withdrawn into the microsyringe and then directly injected into the HPLC system. In order to achieve maximum extraction efficiency, different parameters affecting the extraction conditions were optimized. At the optimum conditions (donor solution: 2.3M Na(2)SO(4), pH 2.0-3.5; organic membrane: 95 microl of 1-hexanol; acceptor solution: 4.0 microl of 0.1M NH(3)/NH(4)(+) with pH 11.1; donor solution temperature: 45-50 degrees C; extraction time: 20 min and back-extraction time: 12 min), up to 110-fold enrichment factor was obtained. The calibration curve for these analytes was linear in the range of 1-5000 microg/l with r(2)>0.998. The intraday and interday RSD% were below 6.5% and the limits of detection (LODs) for both analytes were 0.2 microg/l (based on S/N=3). The proposed technique is a low cost, simple and sensitive method with highly clean-up effect. Finally, this technique was successfully utilized for the detection of target analytes in human urine, serum and plasma.

A novel hollow-fibre microporous membrane liquid–liquid extraction for determination of free 4-isobutylacetophenone concentration at ultra trace level in environmental aqueous samples

In this study, a method was developed for determination of the free concentration of 4-isobutylacetophenone, a toxic degradation product of ibuprofen, in river and sewage water samples from Sweden. Sample preparation and analysis were performed by a hollow-fibre microporous membrane liquid-liquid extraction (HF-MMLLE) set-up and gas chromatography-mass spectrometry (GC-MS), respectively. In this novel approach, only the liquid in the membrane pores is utilised for non-depleting extraction. Several parameters were studied, including: type of organic solvent, sample pH, and salt and humic acid content. The optimised method allowed the determination of the analyte at the ng L(-1) level in river and sewage water. A linear plot gave a correlation coefficient better than 0.992 and resulted in a limit of detection of 7 and 14 ng L(-1) for river and sewage water, respectively. The enrichment factor was over 2000 in the fibre and over 300 after dilution. The repeatability and reproducibility were better than 5% and 10%, respectively. For the first time, 4-isobutylacetophenone was found at free concentrations of 40 ng L(-1) or below in sewage waters, while it could not be quantified in a river downstream from a municipal sewage treatment plant.

Development of an analytical method for the determination of beta2-agonist residues in animal tissues by high-performance liquid chromatography with on-line electrogenerated [Cu(HIO6)2]5- -luminol chemiluminescence detection

A novel method was developed for the simultaneous determination of beta2-agonist residues such as terbutaline, salbutamol, and clenbuterol by high-performance liquid chromatography (HPLC) coupled with chemiluminescence (CL) detection. The procedure was based on the enhancement effect of beta2-agonists on the CL reaction between luminol and the complex of trivalent copper and periodate ([Cu(HIO6)2]5-), which was on-line electrogenerated by constant current electrolysis. The HPLC separation used a Nucleosil RP-C18 column (250 mm x 4.6 mm i.d., 5 microm; pore size, 100 A) with a mobile phase consisting of 90% acetonitrile and 10% aqueous ammonium acetate (20 mmol L-1, pH 4.0) at a flow rate of 1.0 mL min-1. The effects of several parameters on the HPLC resolution and CL emission were studied systematically. Liver samples were hydrolyzed with beta-glucuronidase followed by a solid-phase extraction procedure using Waters OasisMCX cartridges. Under optimum conditions, the limits of detection at a signal-to-noise ratio of 3 ranged from 0.007 to 0.01 ng g-1 and the limits of quantification at a signal-to-noise ratio of 10 ranged from 0.023 to 0.033 ng g-1 for three beta2-agonists. The relative standard deviations (RSDs) of intra- and interday precision were below 4.5%. The average recoveries for beta2-agonists (spiked at the levels of 0.05-5.0 ng g-1) in pig liver ranged from 84 to 110%, and the RSDs of the quantitative results were from 1.6 to 7.2%. The proposed method was successfully applied to the determination of beta2-agonist residues in pig liver samples.

Development of a simple hollow fibre supported liquid membrane extraction method to extract and preconcentrate dinitrophenols in environmental samples at ngL−1 level by liquid chromatography

An easy and rapid hollow-fibre supported liquid membrane method (HFSLM) has been developed to extract and determinate the total concentration of four dinitrophenols in environmental water at ng L(-1) level. This extraction method provides a high selectivity, short extraction time and very low cost for real samples. It is a three-phase system, aqueous-organic-aqueous, where the organic solvent is held into the fibre pores, being in contact with the two other phases. The organic phase is formed by two different organic solvents, with two different polarities, n-undecane and toluene (1:1). The optimization step was performed using a three-variable Doehler design, involving three factors, stirring speed, fibre length and sample volume. The organic phase composition, as well as the pH of the acceptor and donor phases was also optimized. The extraction equilibrium was reached after 30 min, after which essentially the total amount (90-80%) of the four dinitrophenolic compounds were extracted from the sample. Better repeatability and reproducibility at the expense of lower enrichment factors was obtained compared with other methods, employing incomplete extraction during a fixed time. The matrix effect was tested by performing extractions from leachate water and river water. This method is linear in the range 0.1-100 microgL(-1) in different matrices, with detection limit around 100 ng L(-1), after extraction of 6 mL of sample and using high performance liquid chromatography for final analysis.

A new liquid-phase microextraction method based on solidification of floating organic drop

In the present study, a new and versatile liquid-phase microextraction method is described. This method requires very simple and cheap apparatus and also a small amount of organic solvent. Eight microliters of 1-undecanol was delivered to the surface of solution containing analytes and solution was stirred for a desired time. Then sample vial was cooled by inserting it into an ice bath for 5 min. The solidified 1-undecanol was transferred into a suitable vial and immediately melted; then, 2 microL of it was injected into a gas chromatograph for analysis. Some polycyclic aromatic hydrocarbons (PAHs) were used as model compounds for developing and evaluating of the method performance. Analysis was carried out by gas chromatography/flame ionization detection (GC/FID). Several factors influencing the microextraction efficiency, such as the nature and volume of organic solvent, the temperature and volume of sample solution, stirring rate and extraction time were investigated and optimized. The applicability of the technique was evaluated by determination of trace amounts of PAHs in environmental samples. Under the optimized conditions, the detection limits (LOD) of the method were in the range of 0.07-1.67 microg L(-1) and relative standard deviations (R.S.D.) for 10 microg L(-1) PAHs were <7%. A good linearity (r(2)>0.995) in a calibration range of 0.25-300.00 microg L(-1) was obtained. After 30 min extraction duration, enrichment factors were in the range of 594-1940. Finally, the proposed method was applied to the determination of trace amounts of PAHs in several real water samples, and satisfactory results were resulted. Since very simple devices were used, this new technique is affordable, efficient, and convenient for extraction and determination of low concentrations of PAHs in water samples.