Separation of acidic compounds by strong anion-exchange capillary electrochromatography

Influence of the unpacked section on the chromatographic performance of duplex strong anion-exchange columns in capillary electrochromatography

This work describes initial investigations of strong anion-exchange (SAX) packing materials for capillary electrochromatography (CEC). The use of SAX phases in CEC is theoretically appealing for the analysis of negatively charged species. The reversed direction of the electroosmotic flow (EOF) generated by SAX phases (in comparison to reversed phases and strong cation-exchange phases) means that negative species can migrate with the EOF, not against it, hence the analysis times, of such species should be decreased and efficiencies improved. Duplex CEC columns (the standard for instruments using UV detection) consist of a packed and an unpacked section. Using common reversed-phase packing materials the direction of the EOF in both sections is co-linear, however when normal fused-silica capillaries are packed with SAX material the direction of the EOF in the two sections oppose one another. It has been shown, using conventional duplex CEC columns and fully packed CEC-MS columns that the opposing direction of EOF causes a massive degradation in column performance. Consequentially, it is demonstrated that if the EOF in the open section of the duplex SAX column can be controlled via pH or capillary derivatisation then good, reproducible CEC can be performed on anionic species using SAX packed CEC columns.

Capillary electrochromatography in anion-exchange and normal-phase mode using monolithic stationary phases

Hydrophilic macroporous weak and strong anion-exchange stationary phases have been prepared in a monolithic format within untreated fused-silica capillaries by the simple thermally or UV-initiated polymerization of 2-dimethylaminoethyl methacrylate, 2-hydroxyethyl methacrylate and ethylene dimethacrylate in the presence of a binary porogenic mixture of dodecanol and cyclohexanol. The tertiary amino functionalities were then alkylated in situ to afford strong anion-exchangers. These new monolithic stationary phases with optimized porous properties were used for the CEC separation of various organic anions. Thus, a mixture of 2-substituted propionic acid drugs (profens) was separated in 13 min and high column efficiencies of up to 231,000 plates/m were achieved. The separation of substituted benzoic acids indicates that the selectivity results primarily from the anion-exchange interactions, while electrophoretic migration contributes only slightly. In addition, these hydrophilic anion-exchangers are also able to separate weakly acidic, neutral and basic compounds such as phenols, xanthines and aromatic amines in normal-phase electrochromatographic mode.

Histidine-functionalized silica and its copper complex as stationary phases for capillary electrochromatography

A histidine-functionalized silica was prepared by covalent bonding of the functional groups to silane-treated silica gel. Conversion of functional groups was confirmed by infrared (IR) spectra, elemental analysis, and potentiometry. The functionality of the silica gel is 0.293 mmol g(-1). The coordination behavior of the histidine-functionalized silica was investigated by metal capacity and electron paramagnetic resonance (EPR). EPR measurements at different copper loadings were made. The results showed that the copper histidine complex might be distorted tetragonal. Both histidine-functionalized silica and its copper complex were employed as stationary phases for packed capillary electrochromatography (CEC). Electrical current was found helpful for evaluating the properties of frit construction and the stationary phase packing. Test samples include neutral compounds, inorganic anions and organic anions. Factors influencing the separation behavior have been studied. With copper-histidine functionalized silica under the condition of citrate buffer (10 mM, pH 4.0) and applied voltage of -20 kV, the separation of benzoic acid, D- and L-mandelic acid, phthalic acid and salicylic acid could be achieved within 12 min. The column efficiency for these acids was more than 1.2 x 10(5) plates m(-1), except salicylic acid.

Application of hydrophobic anion-exchange phases in capillary electrochromatography

Capillary electrochromatography (CEC) requires stationary phases that enable appropriate electroosmotic propel under various conditions. Analyte retention can be controlled through hydrophobic or electrostatic interaction with the packing material. The development and characterization of new strong anion-exchange materials with additional hydrophobic moieties (SAX/C18 mixed-mode phases) is described. The synthesis was based on polymer encapsulation of porous silica. The phases were systematically characterized by means of elemental analyses, HPLC frontal analyses and CEC experiments. The studies focused on the influence of various parameters (e.g., pH, kind of buffer, capillary wall) on the electroosmotic flow (EOF). Phases with high anion-exchange capacity generated a fast and constant EOF over a wide pH range. Long-time stability of EOF and hydrophobic retention under CEC conditions were demonstrated within the course of 100 consecutive injections. The applicability of the SAX/C18 phases in appropriate buffer systems is demonstrated for neutral, acidic and basic compounds.

Lonene-coated sulfonated silica as a packing material in the packed-capillary mode of electrochromatography

An aliphatic ionene (2-10-ionene) has been selected as a modifier to prepare a novel polymer-coated packing material for capillary electrochromatography. The packing material was produced by dynamical modification of a commercially available sulfonated silica Exsil-100 SCX. Strong ion-exchange interactions in the capillary packed with ionene-modified sulfonated silica have been demonstrated by the example of the retention of p-aminobenzoic acid. The total calculated anion-exchange capacity of the sorbent in the capillary was about 4 x 10(-9) mol. A fast separation (about 15 min) of several aromatic acids was achieved with the packing material. The highest number of theoretical plates obtained was about 120,000. Limits of detection of the aromatic acids were 2-5 microg/ml. The advantages and lacks of the approach are discussed briefly.

Anion-exchange capillary electrochromatography with indirect UV and direct contactless conductivity detection

Conductivity detection is applied to ion-exchange capillary electrochromatography (IE-CEC) with a packed stationary phase, using a capacitively coupled contactless conductivity detector with detection occurring through the packed bed. Columns were packed with a polymeric latex-agglomerate anion-exchanger (Dionex AS9-SC). A systematic approach was used to determine suitable eluants for IE-CEC separations using simultaneous indirect UV and direct conductivity detection. Salicylate and p-toluenesulfonate were identified as potential eluant competing anions having sufficient eluotropic strength to induce changes in separation selectivity, but salicylate was found to be unsuitable with regard to baseline stability. It was also found for both indirect UV and direct conductivity detection that homogenous column packing was imperative, and monitoring of the baseline could be used to assess the homogeneity of the packed bed. Using a p-toluenesulfonate eluant, the separation of eight common anions was achieved in 2.5 min. Direct conductivity detection was found to be superior to indirect UV detection with regard to both baseline stability and detection sensitivity with detection limits of 4-25 microg/L being obtained. However, the calibration for each anion was not linear over more than one order of magnitude. When using conductivity detection, the concentration of the eluant could be varied over a wider range (2.5-50 mM p-toluenesulfonate) than was the case with indirect UV detection (2.5-10 mM), thereby allowing greater changes in separation selectivity to be achieved. By varying the concentration of p-toluenesulfonate in the eluant, the separation selectivity could be manipulated from being predominantly ion-exchange in nature (2.5 mM) to predominantly electrophoretic in nature (50 mM).

Fast separation of pyrimidine derivatives by capillary electrochromatography on ion-exchange/reversed-phase mixed-mode stationary phases

This work describes the use of mixed-mode stationary phases which exhibit both strong ion-exchange (either cation-exchange, SCX, or anion-exchange, SAX) and reversed-phase chromatographic characteristics in capillary electrochromatographic separations of pyrimidine derivatives. Different packing materials, namely C6, SCX/C6 and SAX/C6, were compared and the influence of the composition of the carrier electrolyte (concentration of acetonitrile and pH) on the retention behavior of the selected solutes was investigated. A separation of all eight pyrimidine derivatives could be obtained on a 6.5 cm column packed with the SAX/C6 stationary phase in less than 3 min, with good peak shapes and efficiencies in the range 39,000 to 81,000 plates per meter.

Separation of basic, acidic and neutral compounds by capillary electrochromatography using uncharged monolithic capillary columns modified with anionic and cationic surfactants

A mode of capillary electrochromatography (CEC), based on the dynamical adsorption of surfactants on the uncharged monolithic stationary phases has been developed. The monolithic stationary phase, obtained by the in situ polymerization of butyl methacrylate with ethylene dimethacrylate, was dynamically modified with an ionic surfactant such as the long-chain quaternary ammonium salt of cetyltrimethylammonium bromide (CTAB) and long-chain sodium sulfate of sodium dodecyl sulfate (SDS). The ionic surfactant was adsorbed on the surface of polymeric monolith by hydrophobic interaction, and the ionic groups used to generate the electroosmotic flow (EOF). The electroosmotic mobility through these capillary columns increased with increasing the content of ionic surfactants in the mobile phase. In this way, the synthesis of the monolithic stationary phase with binary monomers can be controlled more easily than that with ternary monomers, one of which should be an ionic monomer to generate EOF. Furthermore, it is more convenient to change the direction and magnitude of EOF by changing the concentration of cationic or anionic surfactants in this system. An efficiency of monolithic capillary columns with more than 140000 plates per meter for neutral compounds has been obtained, and the relative standard deviations observed for to and retention factors of neutral solutes were about 0.22% and less than 0.56% for ten consecutive runs, respectively. Effects of mobile phase composition on the EOF of the column and the retention values of the neutral solutes were investigated. Simultaneous separation of basic, neutral and acidic compounds has been achieved.

Enantiomer separation by strong anion-exchange capillary electrochromatography with dynamically modified sulfated beta-cyclodextrin

A novel mode of capillary electrochromatography (CEC) based on a dynamically modified stationary phase was presented for chiral separation. The capillary column was packed with strong anion-exchange (SAX) stationary phase packing; the sulfated beta-cyclodextrin (S-CD), which was added to the mobile phase, was dynamically adsorbed to the packing surface. Separation of enantiomers was achieved by their different abilities to form an inclusion complex with the adsorbed S-CD. The enantiomers of tryptophan, praziquantel, atropine, metoprolol, and verapamil were successfully separated in this system with a column efficiency of 36000-412000 plates/m. The resolution value obtained for atropine was as high as 11.23. The superiority of CEC with a dynamically modified stationary phase over that with a physically adsorbed stationary phase was demonstrated. The influence of ionic strength, S-CD concentration, and methanol content on separation was also studied.

Capillary electrochromatography with physically and dynamically absorbed stationary phases

Adsorption is always considered a troublesome effect in capillary electrophoresis (CE) and capillary electrochromatography (CEC). However, the adsorption effect can also be exploited to prepare or optimize the stationary phase in CEC. Compared with the chemical synthesis of new stationary phase materials for CEC, this method is simpler and more convenient. This review is focused on CEC with physically and dynamically adsorbed stationary phases. Separation of some acidic, basic and neutral solutes as well as enantiomers in CEC with dynamically adsorbed stationary phases are presented. The theory for the migration of charged solutes and the stationary phases currently used in CEC are also briefly reviewed.

Dynamic modification of the capillary wall for electrophoretic separations of small ions

Separations of small ions were carried out under nonequilibrated conditions using capillaries treated with NaOH, HCl, or tris(hydroxymethyl)aminomethane (Tris) prior to analysis. For separations of benzoic acid isomers or acids and amines under weakly acidic conditions, capillaries flushed with 0.1 M NaOH and subsequently with running buffers prior to analysis were used. Separations of six benzoic acid isomers were accomplished in 4 min in 1 mM phosphate buffers, pH 4.01, containing 2.5 mM hydroxypropyl-beta-cyclodextrin. Without additives, the separation of biological amines and acids were also achieved in 10 min at pH 4.01. Capillaries treated with 0.1 M HCl prior to analysis were tested in separations of six phenols in 5 mM Tris solutions at pH 7.0. As a result of small electrophoretic mobilities of phenols against a small electroosmotic flow, resolution was optimized. We also found that reproducibility was improved using capillaries treated with HCl. The relative standard deviations of migration mobility of phenols were less than 1%, which were smaller than those obtained using capillaries treated with 0.1 M NaOH or Tris.