The composting potential of different organic solid wastes: experience from the island of Crete

Assessment of municipal solid waste compost quality using standardized methods before preparation of plant growth media

The quality of compost and its suitability for agricultural application depend upon physical and chemical parameters such as water-holding capacity, porosity, pH, electrical conductivity, C/N ratio, available nutrients and the absence of toxic substances. In the present study a complete characterization of an industrial municipal solid waste compost (MSWC) based on standardized European methods (CEN) for soil improvers and growing media was obtained, and compared with the quality of other Spanish composted biowaste and conventional substrates such as peat and pine bark. The MSWC was obtained from the main composting plant in Galicia (Spain), which processes organic waste that has been separated at origin and collected from more than 100 000 inhabitants. The MSWC presented a lower C/N ratio (15) than peat (84) and composted pine bark (CPB) (211), but had a similar ratio to other marketed MSWC. The nutrients and heavy metals were extracted using different recommended solvents (water, CaCl2 + diethylen triamin pentaacetic acid, and aqua regia). The nutrient concentrations of composted urban waste or manure were much higher than those of peat, CPB or pine bark. On the basis of the results of the plant tolerance test, the MSWC could be employed directly as a soil improver, but would need to be diluted with other low-salt components such as peat or CPB before being used as a growing media.

Composting anaerobic and aerobic sewage sludges using two proportions of sawdust

Sawdust has been proven to be a good bulking agent for sludge composting; however, studies on the most suitable ratio of sludge:sawdust for sludge composting and on the influence of the sludge nature (aerobic or anaerobic) on the composting reaction rate are scarce. In this study two different sewage sludges (aerobic, AS, and anaerobic, ANS) were composted with wood sawdust (WS) as bulking agent at two different ratios (1:1 and 1:3 sludge:sawdust, v:v). Aerobic sludge piles showed significantly higher microbial activity than those of anaerobic sludge, organic matter mineralization rates being higher in the AS mixtures. The lowest thermophilic temperatures during composting were registered when the anaerobic sludge was mixed with sawdust at 1:1 ratio, suggesting the presence of substances toxic to microorganisms. This mixture also showed the lowest decreases of ammonium during composting. All this matched with the inhibitory effect on the germination of Lepidium sativum seeds of this mixture at the first stages of composting, and with its low values of microbial basal respiration. However, the ANS+WS 1:3 compost developed in a suitable way; the higher proportion of bulking agent in this mixture appeared to have a diluting effect on these toxic compounds. Both the proportions assayed allowed composting to develop adequately in the case of the aerobic sludge mixture, yielding suitable composts for agricultural use. However, the ratio 1:1 seems more suitable because it is more economical than the 1:3 ratio and has a lower dilution effect on the nutritional components of the composts. In the case of the anaerobic sludge with its high electrical conductivity and ammonium content, and likely presence of other toxic and phytotoxic substances, the 1:3 ratio is to be recommended because of the dilution effect.

Efforts to Explain and Control the Prolonged Thermophilic Period in Two-phase Olive Oil Mill Sludge Composting

The aim of this paper was to evaluate the use of different bulking agents in different ratios as a means to control, optimise and eventually reduce the duration of the thermophilic period in two-phase olive oil mill sludge (OOMS) composting. The bulking agents used were: (i) olive tree leaves (OTL), (ii) olive tree shredded branches (OTB) and (iii) woodchips (WDC). The selection of these materials was based on their abundance and availability on the island of Crete, the southernmost point of Greece. The ratios studied were: Pile 1, OOMS:OTL in 1:1 v/v; Pile 2, OOMS:WDC in 1:1.5 v/v; Pile 3, OOMS:OTL in 1:2 v/v; Pile 4, OOMS:OTL:OTB in 1:1:1 v/v; and Pile 5, OOMS:OTL:OTB in 1:1:2 v/v. The composting system used was that of windrows with the volume of each pile approximately 20-25 m3. The experiments took place over two consecutive years. A composting turner was used and turnings were performed at one and two week intervals. In each pile a variety of physiochemical parameters were monitored. Temperature remained high in all five trials. Piles 1, 2, 3, 4 and 5 temperatures recorded values of above 50 degrees C for 106, 158, 160, 175 and 183 days, respectively. Volumes were reduced by approximately 67%, 62%, 63%, 80% and 84%, respectively. Temperature remained high, mainly due to the presence in large amounts of oily substances which during their complete oxidation release important amounts of energy and aid the cometabolism of more stable molecules such as lignin. This process is better described as the slow "burning" of a "fuel" mixture in an "engine" than composting. This approach is based on the extensive similarities of this process to that of crude oil sludge or similar waste composting.

Influence of dairy manure addition on the biological and thermal kinetics of composting of greenhouse tomato plant residues

A laboratory-scale bioreactor was used to investigate the influence of dairy manure addition (as an inoculum and a carbon source) on the biological and thermal kinetics of the composting process of tomato plant residues-wood shavings mixture. Urea was added (as a nitrogen source) to correct the initial C:N ratio to 30:1 and the initial moisture content was also adjusted to 60%. The result of this study indicated that manure addition to the tomato residues-wood shavings mixture is a good source of macro and micronutrients required for supporting the composting microorganisms. Manure addition increased the rate of temperature increase and the duration of maximum temperature and reduced the lag and the peak time, all of which resulted in a significant reduction in the retention time. However, thermophilic temperature (> or = 40 degrees Celsius) was only achieved with 30%, 40% and 50% manure addition for 3, 7 and 9h. Total carbon reductions were in the range of 9.4-10.8% and TKN reductions were in the range of 3.4-6.0%. Neither the nitrogen nor the moisture content were limiting factors as the C:N ratio remained in the range of 26:1 to 28:1 and the moisture content remained within the optimum range of 58-61%. The maximum temperature of each mixture correlated with the reduction of total carbon, but carbon availability was a limiting factor in these experiments. In order to attain and sustain a thermophilic phase during the composting process, the addition of a readily available carbon source to the tomato should be investigated and carbon type (carbohydrates, proteins and fats) should be taken into account.

Heavy metals fractionation during the thermophilic phase of sewage sludge composting in aerated static piles

An aerated static pile system with temperature feedback control was used for the composting of sewage sludge amended with olive tree leaves in a 1:1 (SS1) and 1:2 (SS2) v/v ratio, on two different occasions. The two piles were approximate 20 m3 each of similar dimensions; 2.0 wide at the base, 1.3 m height and 11 m long. Samples were taken from the core of the piles on four occasions: day 0 (establishment), day 15, day 30 and day 60 of the thermophilic phase. Heavy metal (Cu, Ni, Pb and Zn) fractions in each of the samples were monitored using sequential extraction with H2O (for the water soluble fraction), KCL (for the exchangeable fraction), Na2EDTA (for the inorganic bound fraction), NaOH (for the organically bound fraction) and HNO3 due the significant residual fraction of these metals in both piles and in all four samplings, which reduced any losses through leaching when water was added. For Ni the water soluble and the exchangeable fractions were dominant, reaching values of 45% in SS1 and 35% in SS2, resulting in some losses into the leachates. The fraction of metals connected to the organic matter was similar for Ni in both piles, larger in SS2 for Pb than in SS1, whereas Cu and Zn presented far larger values in SS1 than in SS2. There was no common pattern of fractionation variation among the metals in each pile or when comparing both piles.

Olive pomace amendment in Mediterranean conditions: effect on soil and humic acid properties and wheat (Triticum turgidum L.) yield

The effects of the addition of either crude or exhausted olive pomace at two rates (10 and 20 t ha(-)(1)) on soil and soil humic acid (HA) properties and durum wheat (Triticum turgidum L.) yield were investigated in open-field Mediterranean conditions. Soil amendment with olive pomaces produced a significant increase of total organic, total extractable, humified and nonhumified C forms, and available K contents. With respect to control soil HA, humic-like acids isolated from crude and exhausted olive pomaces were characterized by larger phenolic OH group contents, smaller carboxyl group contents, a prevalent aliphatic character, extended molecular heterogeneity, and smaller aromatic polycondensation and humification degrees. In general, application of olive pomaces to soil produced a number of modifications in soil HAs, including the increase of O and acidic functional group contents, C/N ratio, and aliphaticity and the decrease of C/H ratio and N and C contents. Wheat grain yield increased significantly as an effect of olive pomace amendment. In particular, the increases were related to kernel weight, kernel number per square meter, and soil organic matter content. Possibly, the enhanced amount of soil organic matter in olive-pomace-amended soils relieved wheat of drought stress from anthesis to maturity by promoting a good soil structure, thereby reducing water loss by evaporation.

The use of sewage sludge and horticultural waste to develop artificial soil for plant cultivation in Singapore

Greenhouse pot experiments were performed with Ipomoea aquatica (Kang Kong) to evaluate artificial soil produced from poor fertility subsoil, horticultural compost, and sewage sludge. The addition of horticultural compost and sewage sludge to subsoil substantially improved plant growth, improved the physical properties of subsoil and enriched subsoil by essential nutrients for plants. The effect was enhanced when the two ingredients were added to subsoil together. The highest yield of biomass of I. aquatica was observed in artificial soil prepared by mixing subsoil with 4% (wet weight/wet weight) of horticultural compost and 2% (dry weight/wet weight) of sewage sludge. The contents of heavy metals in plants, grown in the artificial soil, were significantly lower than toxic levels. The artificial soil could be recommended for urban landscaping and gardening in Singapore.

In-vessel composting--bioremediation of aged coal tar soil: effect of temperature and soil/green waste amendment ratio

The biodegradation of 16 United States Environmental Protection Agency (USEPA)-listed polycyclic aromatic hydrocarbons (PAHs) present in contaminated soil from a manufactured gas plant site was investigated using laboratory-scale in-vessel composting-bioremediation reactors over 8 weeks. The influence of temperature (T, 38, 55, and 70 degrees C) and soil/green waste ratio (S:GW, 0.6:1, 0.7:1, 0.8:1, and 0.9:1) was investigated. A comparative study using a temperature profile during in-vessel composting-bioremediation to meet current regulatory requirements was also investigated. Temperature and amendment ratio were found to be important operating parameters for PAH removal for in-vessel composting-bioremediation of aged coal tar-contaminated soil. After 8 weeks of continuous treatment, the highest removal of 16 USEPA PAHs was observed at T=38 degrees C and S:GW=0.8:1 (75.2%). Lower removal of 16 USEPA PAHs was observed for temperature profile treatment (60.8%). We recommend that when conventional composting processes using temperature profiles to meet regulatory requirements for pathogen control need to be used, these should start with a prolonged mesophilic stage (6 weeks in this investigation) followed by thermophilic, cooling, and maturation stages.

Influence of olive mill wastewater in composting and impact of the compost on a Swiss chard crop and soil properties

The suitability of olive mill wastewater (OMW) for composting was studied by the addition of this liquid waste to a mixture of cotton gin waste and sewage sludge, and its composting was compared with that of another pile of similar composition, but without olive mill wastewater. Both piles were composted by the Rutgers static pile system in a pilot plant. To study the effects of both composts on plant yield and soil properties, a plot experiment was carried out with Swiss chard (Beta vulgaris L. var. cicla). Five treatments were applied: mineral fertiliser and two doses (30 and 60 tons ha(-1)) of both composts. The olive mill wastewater addition produced a compost with lower organic matter and nitrate concentrations, higher electrical conductivity, and a stabilised and humified organic matter similar to that of the compost produced without olive mill wastewater. The olive mill wastewater compost application to soil did not injure plants, producing a similar plant yield to both compost without olive mill wastewater and inorganic fertiliser. Also, the accumulation of potentially toxic heavy metals in plants cultivated with organic or mineral fertilisers did not reveal significant differences. The olive mill wastewater compost application to soil also improved the chemical and physicochemical properties of the soil.

Treatment of olive mill effluents Part II. Complete removal of solids by direct flocculation with poly-electrolytes

The pre-treatment of three different olive oil processing effluents by means of direct flocculation (i.e. without prior coagulation) was investigated. Four cationic and two anionic poly-electrolytes were tested and most of them were found capable of removing nearly completely total suspended solids (TSS) as well as reducing considerably the concentration of chemical (COD) and biochemical oxygen demand (BOD(5)) without altering solution pH. Flocculant dosage was crucial to achieve effective separation. For three cationic and one anionic poly-electrolytes, the minimum dosage required to initiate separation was about 2.5-3 g/L. The remaining two poly-electrolytes failed to cause separation even at dosages as high as 7 g/L. Lime and ferric chloride were also tested as reference coagulants and found quite effective in terms of TSS removal although the degree of COD reduction was generally lower than that with poly-electrolytes. However, lime treatment would require greater dosages and longer treatment times than that with poly-electrolytes and would also increase considerably solution pH. A preliminary cost analysis showed that lime treatment for complete solids removal was generally less costly than that with poly-electrolytes presumably due to its low market price. Nonetheless, cost-benefits may be defied by several drawbacks associated with the use of lime.