Selbstorganisierte Gelbildner für die organische Elektronik

Supramolecular Depolymerization in the Mixture of Two Poor Solvents: Mechanistic Insights and Modulation of Supramolecular Polymerization of Ionic π-Systems

Solvents are fundamentally essential for the synthesis and processing of soft materials. Supramolecular polymers (SPs), an emerging class of soft materials, are usually stable in single and mixtures of poor solvents. In contrast to these preconceived notions, here we report the depolymerization of SPs in the mixture of two poor solvents. This surprising behavior was observed for well-known cationic perylene diimides (cPDIs) in the mixtures of water and amphiphilic organic solvents such as isopropanol (IPA). cPDIs form stable SPs in water and IPA but readily depolymerize into monomers in 50-70 vol% IPA containing water. This is due to the selective solvation of the π-surface of cPDIs by alkyl chains of IPA and ionic side chains by water, as evidenced by molecular dynamic simulations. Moreover, by systematically changing the ratio between water and amphiphilic organic solvent, we could achieve an unprecedented supramolecular polymerization both by increasing and decreasing the solvent polarity.

Supramolecular Nanowires from an Acceptor-Donor-Acceptor Conjugated Chromophore

Oligothiophene derivatives have been extensively studied as p-type semiconducting materials in organic electronics applications. This work reports the synthesis, self-assembly and photophysical properties of acceptor-donor-acceptor (A-D-A)-type oligothiophene derivatives by end-group engineering of quaterthiophene (QT) with naphthalene monoimide (NMI) chromophores that are further connected to a trialkoxy benzamide wedge. Conjugation to the NMI units reduces the HOMO-LUMO gap significantly, and consequently the absorption spectrum exhibits a bathochromic shift of about 50 nm compared with QT. Furthermore, extended H-bonding interactions among the amido groups of the peripheral wedges produce entangled fibrillar nanostructures and gelation in hydrocarbon solvents such as methylcyclohexane, wherein the A-D-A chromophore exhibits typical H-aggregation. On the contrary, the fact that the same chromophore, lacking only the amido units, does not produce gels or H-aggregates indicates strong impact of H-bonding on the self-assembly. Computational studies revealed the electronic properties of the chromophore and predicted the geometry of a dimer in the H-aggregate that reasonably matches with the experimental results. Bulk electrical conductivity measurements determined an excellent conductivity of 2.3×10^-2  S cm^-1 for the H-aggregated system (OT-1), which is two orders of magnitude higher than that of the same chromophore lacking the amido groups (OT-2).

Photoconductive Core-Shell Liquid-Crystals of a Perylene Bisimide J-Aggregate Donor-Acceptor Dyad

A novel core-shell structured columnar liquid crystal composed of a donor-acceptor dyad of tetraphenoxy perylene bisimide (PBI), decorated with four bithiophene units on the periphery, was synthesized. This molecule self-assembles in solution into helical J-aggregates guided by π-π interactions and hydrogen bonds which organize into a liquid-crystalline (LC) columnar hexagonal domain in the solid state. Donor and acceptor moieties exhibit contrasting exciton coupling behavior with the PBIs' (J-type) transition dipole moment parallel and the bithiophene side arms' (H-type) perpendicular to the columnar axis. The dyad shows efficient energy and electron transfer in solution as well as in the solid state. The synergy of photoinduced electron transfer (PET) and charge transport along the narcissistically self-assembled core-shell structure enables the implementation of the dye in two-contact photoconductivity devices giving rise to a 20-fold increased photoresponse compared to a reference dye without bithiophene donor moieties.

Pathway Control in Cooperative vs. Anti-Cooperative Supramolecular Polymers

Controlling the nanoscale morphology in assemblies of π-conjugated molecules is key to developing supramolecular functional materials. Here, we report an unsymmetrically substituted amphiphilic Pt^II complex 1 that shows unique self-assembly behavior in nonpolar media, providing two competing anti-cooperative and cooperative pathways with distinct molecular arrangement (long- vs. medium-slipped, respectively) and nanoscale morphology (discs vs. fibers, respectively). With a thermodynamic model, we unravel the competition between the anti-cooperative and cooperative pathways: buffering of monomers into small-sized, anti-cooperative species affects the formation of elongated assemblies, which might open up new strategies for pathway control in self-assembly. Our findings reveal that side-chain immiscibility is an efficient method to control anti-cooperative assemblies and pathway complexity in general.

Mechanistic Insights into the Self-Assembly of an Acid-Sensitive Photoresponsive Supramolecular Polymer

The supramolecular polymerization of an acid‐sensitive pyridyl‐based ligand (L₁) bearing a photoresponsive azobenzene moiety was elucidated by mechanistic studies. Addition of trifluoroacetic acid (TFA) led to the transformation of the antiparallel H‐bonded fibers of L₁ in methylcyclohexane into superhelical braid‐like fibers stabilized by H‐bonding of parallel‐stacked monomer units. Interestingly, L₁ dimers held together by unconventional pyridine–TFA N⋅⋅⋅H⋅⋅⋅O bridges represent the main structural elements of the assembly. UV‐light irradiation caused a strain‐driven disassembly and subsequent aggregate reconstruction, which ultimately led to short fibers. The results allowed to understand the mechanism of mutual influence of acid and light stimuli on supramolecular polymerization processes, thus opening up new possibilities to design advanced stimuli‐triggered supramolecular systems.

A Tautoleptic Approach to Chiral Hydrogen-Bonded Supramolecular Tubular Polymers with Large Cavity

A new strategy towards tubular hydrogen-bonded polymers based on the self-assembly of isocytosine tautomers in orthogonal directions is proposed and experimentally verified, including by 1 H fast magic-angle spinning (MAS) solid-state NMR. The molecular tubes obtained possess large internal diameter and tailor-made outer functionalities rendering them potential candidates for a number of applications.

Electroactive Amphiphiles for Addressable Supramolecular Nanostructures

In this focus review we aim to highlight an exciting class of materials, electroactive amphiphiles (EAAs). This class of functional amphiphilic molecules has been the subject of sporadic investigations over the last few decades, but little attempt has been made to date to gather or organise these investigations into a logical fashion. Here we attempted to gather the most important contributions, provide a framework in which to discuss them, and, more importantly, point towards the areas where we believe these EAAs will contribute to solving wider scientific problems and open new opportunities. Our discussions cover materials based on low molecular weight ferrocenes, viologens and anilines, as well as examples of polymeric and supramolecular EAAs. With the advances of modern analytical techniques and new tools for modelling and understanding optoelectronic properties, we believe that this area of research is ready for further exploration and exploitation.

Supramolecular Gels Derived from the Salts of Variously Substituted Phenylacetic Acid and Dicyclohexylamine: Design, Synthesis, Structures, and Dye Adsorption

A well-studied supramolecular synthon, namely, secondary ammonium monocarboxylate (SAM), was exploited to generate a new series of organic salts derived from variously substituted phenylacetic acid and dicyclohexylamine as potential low-molecular-weight gelators. As much as 25 % of the SAM salts under study were gelators. The gels were characterized by rheology, and the morphology of the gel networks was studied by high-resolution electron microscopy. Single-crystal and powder XRD data were employed to study structure-property (gelation) correlations. One of the gels could adsorb a hydrophobic dye (Nile Red) more efficiently than that of a hydrophilic dye (Calcein) from dimethyl sulfoxide; this might provide useful clues towards the development of stain-removing gels.

Redox-Active Peptide-Functionalized Quinquethiophene-Based Electrochromic π-Gel

An electrochromic system based on a self-assembled dipeptide-appended redox-active quinquethiophene π-gel is reported. The designed peptide-quinquethiophene consists of a symmetric bolaamphiphile that has two segments: a redox-active π-conjugated quinquethiophene core for electrochromism, and peptide motif for the involvement of molecular self-assembly. Investigations reveal that self-assembly and electrochromic properties of the π-gel are strongly dependent on the relative orientation of peptidic and quinquethiophene scaffolds in the self-assembly system. The colors of the π-gel film are very stable with fast and controlled switching speed at room temperature.

Fabrication of diverse nano-architectures through the self-assembly of a naphthalene diimide derivative bearing four carbamates

We found that naphthalene diimide (W2) bearing four carbamates bonds can organise various well-defined self-assembled nanostructures driven by π–π interaction and carbamate H-bonding.

Role of Co-Sensitizers in Dye-Sensitized Solar Cells

Co-sensitization is a popular route towards improved efficiency and stability of dye-sensitized solar cells (DSSCs). In this context, the power conversion efficiency (PCE) values of DSSCs incorporating Ru- and porphyrin-based dyes can be improved from 8-11 % to 11-14 % after the addition of additives, co-adsorbents, and co-sensitizers that reduce aggregation and charge recombination in the device. Among the three supporting material types, co-sensitizers play a major role to enhance the performance and stability of DSSCs, which is requried for commercialization. In this Minireview, we highlight the role co-sensitizers play in improving photovoltaic performance of devices containing Ru- and porphyrin-based sensitizers.

Organogelator-Cellulose Composite for Practical and Eco-Friendly Marine Oil-Spill Recovery

Marine oil spills pose serious threats to the ecosystem and economy. There is much interest in developing sorbents that can tackle such spills. We have developed a novel sorbent by impregnating cellulose pulp with a sugar-derived oleogelator, 1,2:5,6-di-O-cyclohexylidene-mannitol. The gelator molecules mask the surface-exposed hydroxyl groups of cellulose fibrils by engaging them in H-bonding and expose their hydrophobic parts making the fibers temporarily hydrophobic (water contact angle 110°). This sorbent absorbs oil effectively, selectively and instantly from oil-water mixtures due to its hydrophobicity. Then the gelator molecules get released uniformly in the oil and later self-assemble to fibers, as evident from SEM analysis, congealing the oil within the matrix. This hierarchical entrapment of the oil by non-covalent polymeric fibers within a covalent polymer matrix makes the gel very strong (230-fold increase in the yield stress) and rigid, making it suitable for practical use.

Unprecedented Charge-Transfer Complex of Fused Diporphyrin as Near-Infrared Absorption-Induced High-Aspect-Ratio Nanorods

Charge-transfer (CT) complexes of near-infrared absorbing systems have been unknown until now. Consequently, structural similarities between donor and acceptor are rather important to achieve this phenomenon. Herein, we report electron donors such as non-fused diporphyrin-anthracene (DP), zinc diporphyrin-anthracene (ZnDP) and fused zinc diporphyrin-anthracene (FZnDP) in which FZnDP absorbs in NIR region and permits a CT complex with the electron acceptor, perylene diimide (PDI) in CHCl₃ exclusively. UV/Vis-NIR absorption, ¹ H NMR, NOESY and powder X-ray diffraction analysis demonstrated that the CT complex formation occurs by π-π stacking between perylene units in FZnDP and PDI upon mixing together in a 1:1 molar concentration in CHCl₃ , unlike non-fused ZnDP and DP. TEM and AFM images revealed that the CT complex initially forms nanospheres leading to nanorods by diffusion of CH₃ OH vapors into the CHCl₃ solution of FZnDP/PDI (1:1 molar ratio). Therefore, these CT nanorods could lead to significant advances in optical, biological and ferroelectric applications.

Derivatizing Tribenzothiophene-Fused Hexa-peri-hexabenzocoronenes with Tunable Optoelectronic Properties

A series of trisbenzothieno[1,2:7,8:13,14]hexa-peri-hexabenzocoronenes were synthesized and characterized by a combination of NMR, 2D NMR, MALDI-TOF MS, UV/Vis absorption spectroscopy, and 2D-WAXS measurement. By structural modulation like decoration of electro-donating alkoxyl chain, and conversion from an electron-rich thiophene ring into an electron-poor thiophene-S,S-dioxide moiety, the highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) levels of the hexabenzocoronenes derivatives can be effectively tuned which is further verified by the DFT calculations and cyclic voltammetry.

Selective Extraction and In Situ Reduction of Precious Metal Salts from Model Waste To Generate Hybrid Gels with Embedded Electrocatalytic Nanoparticles

A hydrogel based on 1,3:2,4-dibenzylidenesorbitol (DBS), modified with acyl hydrazides which extracts gold/silver salts from model waste is reported, with preferential uptake of precious heavy metals over other common metals. Reduction of gold/silver salts occurs spontaneously in the gel to yield metal nanoparticles located on the gel nanofibers. High nanoparticle loadings can be achieved, endowing the gel with electrochemical activity. These hybrid gels exhibit higher conductances than gels doped with carbon nanotubes, and can be used to modify electrode surfaces, enhancing electrocatalysis. We reason this simple, industrially and environmentally relevant approach to conducting materials is of considerable significance.

Contrasting Response of Two Dipolar Fluorescence Probes in a Leucine-Based Organogel and Its Implications

The microenvironments of a leucine-based organogel are probed by monitoring the fluorescence behavior of coumarin 153 (C153) and 4-aminophthalimide (AP). The steady-state data reveals distinctly different locations of the two molecules in the gel. Whereas AP resides close to the hydroxyl moieties of the gelator and engages in hydrogen-bonding interactions, C153 is found in bulk-toluene-like regions. In contrast to C153, AP exhibits excitation-wavelength-dependent emission, indicating that the environments of the hydrogen-bonded AP molecules are not all identical. A two-component fluorescence decay of AP in gel, unlike C153, supports this model. A time-resolved fluorescence anisotropy study of the rotational motion of the molecules also reveals the strong association of only AP with the gelator. That AP influences the critical gelation concentration implies its direct involvement in the gel-formation process. The results highlight the importance of guest-gelator interactions in gels containing guest molecules.