Novel lateral flow assay to detect H2O2 by utilizing self-biotinylation of G-quadruplex

We herein describe a novel lateral flow assay (LFA) to detect H2O2 by utilizing self-biotinylation of G-quadruplex (G4). In this strategy, the G4 strand promotes the self-biotinylation of G4 itself in the presence of H2O2, which is then allowed to bind to the FAM-labeled complementary detector probe. The resulting biotin-labeled G4/FAM-detector probe complex is captured on the test line, producing a red-colored band during lateral flow readout. Based on this unique approach, we achieved the naked-eye detection of target H2O2 at concentrations as low as 1 μM, with reliable quantification down to 0.388 μM. This method also demonstrated exceptional specificity in distinguishing H2O2 from other non-target molecules. We further verified its versatile applicability by reliably identifying another biomolecule, choline, by coupling with choline oxidase, which generates H₂O₂ during oxidation. This novel LFA strategy holds great promise as a powerful point-of-care testing (POCT) platform for detecting a large spectrum of target biomolecules by employing their corresponding oxidases.

A novel peptide fluorescent chemical sensor capable of detecting Cu2+, Zn2+, and S2

A novel peptide-based chemical fluorescence sensor L (Dansyl-His-Pro-Thr-Cys-NH2) was designed and synthesized. This sensor exhibits an "On-Off-On" detection cycle to detect Cu2+, Zn2+, and S2- in solution. According to the chelation-enhanced fluorescence (CHEF) mechanism, when Zn2+ is present, the fluorescence is significantly enhanced and a blue shift occurs, representing a "Turn-On" phase of the fluorescence detection mode. Because copper ions (Cu2+) have a paramagnetic quenching sensing mechanism, the fluorescence of L quenches rapidly with the formation of the L-Cu system, representing the "Turn-Off" phase. The subsequent introduction of S2- to the L-Cu system results in the recovery of the L-fluorescence, thereby representing the second "Turn-On" phase. As a peptide molecule, the sensor L has several advantages over other types of sensors, including water solubility, high sensitivity, and good biocompatibility, with a very low detection limit. The detection lines of Zn2+ and Cu2+ are 97 nM (R = 0.993) and 75 nM (R = 0.995), respectively. Additionally, the sensor does not exhibit any obvious cell toxicity. These results indicate that this peptide chemiluminescent sensor has the potential to be applied in in vivo detection.

Interactions between forsythoside E and two cholinesterases at the different conditions: fluorescence sections

Forsythoside E is one secondary metabolite ofForsythia suspensa(Thunb.) Vahl. In the study, the interactions between forsythoside E and two types of cholinesterases, acetylcholinesterase and butyrylcholinesterase were investigated in the different conditions. Forsythoside E increased the fluorescence intensity of acetylcholinesterase but quenched the fluorescence of butyrylcholinesterase. Aβ25-35used in the study may not form complexes with cholinesterases, and did not affect the interaction between forsythoside E and cholinesterases. The charged quaternary group of AsCh interacted with the 'anionic' subsite in acetylcholinesterase, which did not affect the interaction between forsythoside E and acetylcholinesterase. The enhancement rate of forsythoside E to acetylcholinesterase fluorescence from high to low was acid solution (pH 6.4), neutral solution (pH 7.4) and alkaline solution (pH 8.0), while the reduction rate of forsythoside E to butyrylcholinesterase fluorescence was in reverse order. Metal ions may interact with cholinesterases, and increased the effects of forsythoside E to cholinesterases fluorescence, in order that Fe3+was the highest, followed by Cu2+, and Mg2+. A forsythoside E-butyrylcholinesterase complex at stoichiometric ratio of 1:1 was spontaneously formed, and the static quenching was the main quenching mode in the process of forsythoside E binding with butyrylcholinesterase. TheKvalues of two complexes were pretty much the same, suggesting that the interaction between cholinesterases and forsythoside E was almost unaffected by acid-base environment and metal ions. Thennumbers of two cholinesterases approximately equaled to one, indicating that there was only one site on each cholinesterase applicable for forsythoside E to bind to.

A Cascade Signal Amplification Strategy for the Ultrasensitive Fluorescence Detection of Cu2+ via λ-Exonuclease-Assisted Target Recycling with Mismatched Catalytic Hairpin Assembly

Herein, an ultrasensitive DNAzyme-based fluorescence biosensor for detecting Cu2+ was designed using the cascade signal amplification strategy, coupling λ-exonuclease-assisted target recycling and mismatched catalytic hairpin assembly (MCHA). In the designed detection system, the target, Cu2+, can activate the Cu2+-dependent DNAzyme to cause a cleavage reaction, releasing ssDNA (tDNA). Then, tDNA binds to hairpin DNA (H0) with an overhanging 5'-phosphorylated terminus to form dsDNA with a blunt 5'-phosphorylated terminus, which activates the dsDNA to be digested by λ-Exo and releases tDNA along with another ssDNA (iDNA). Subsequently, the iDNA initiates MCHA, which can restore the fluorescence of carboxyfluorescein (FAM) previously quenched by tetramethylrhodamine (TAMRA), resulting in a strong fluorescent signal. Furthermore, MCHA efficiently improves the signal-to-noise ratio of the detection system. More importantly, tDNA recycling can be achieved with the λ-Exo digestion reaction to release more iDNA, efficiently amplifying the fluorescent signal and further improving the sensitivity to Cu2+ with a detection limit of 60 fM. The practical application of the developed biosensor was also demonstrated by detecting Cu2+ in real samples, proving it to be an excellent analytical strategy for the ultrasensitive quantification of heavy metal ions in environmental water sources.

Carbon dots fabricated by solid-phase carbonization using p-toluidine and l-cysteine for sensitive detection of copper

In this study, a label-free "turn off" fluorescent sensor has been resoundingly fabricated using carbon dots (CDs) for ultrasensitive detection of copper ions (Cu²⁺). CDs are prepared by solid phase carbonization method using p-toluidine and l-cysteine as the precursors. The synthesized CDs exhibited the highest fluorescence intensity with excitation and emission wavelengths set at 300 nm and 400 nm, respectively. The CDs were selective and sensitive to Cu²⁺ due to the static quenching mechanism. The concentration of CDs, and solution pH and incubation time were important parameters for the developed sensor. The experimental results showed that 20 mgL^-1 was enough for the analysis. As the solution pH was concerned, it was apparent that the sensor was endowed with an excellent response signal to Cu²⁺ and provided high sensitivity at pH 12. The interaction occurred very quickly, and the incubation time could be set at 1 min. The sensor provided a two-stage calibration curve to Cu²⁺ in the range of 0.05-0.7 and 0.7-4 μM with a limit of detection of 47 nM. The obtained results clearly demonstrated that this facile method was fast, reliable and selective for detecting Cu²⁺, which would explore a prospective strategy for developing effective and low-cost sensors for monitoring metal ions in aqueous environments.

A Sensitive and Selective Colorimetric Method Based on the Acetylcholinesterase-like Activity of Zeolitic Imidazolate Framework-8 and Its Applications

In this study, a simple colorimetric method was established to detect copper ion (Cu²⁺), sulfathiazole (ST), and glucose based on the acetylcholinesterase (AChE)-like activity of zeolitic imidazolate framework-8 (ZIF-8). The AChE-like activity of ZIF-8 can hydrolyze acetylthiocholine chloride (ATCh) to thiocholine (TCh), which will further react with 5,5′-dithiobis (2-nitrobenzoic acid) (DTNB) to generate 2-nitro-5-thiobenzoic acid (TNB) that has a maximum absorption peak at 405 nm. The effects of different reaction conditions (buffer pH, the volume of ZIF-8, reaction temperature and time, and ATCh concentration) were investigated. Under the optimized conditions, the value of the Michaelis-Menten constant (K_m) is measured to be 0.83 mM, which shows a high affinity toward the substrate (ATCh). Meanwhile, the ZIF-8 has good storage stability, which can maintain more than 80.0% of its initial activity after 30 days of storage at room temperature, and the relative standard deviation (RSD) of batch-to-batch (n = 3) is 5.1%. The linear dependences are obtained based on the AChE-like activity of ZIF-8 for the detection of Cu²⁺, ST, and glucose in the ranges of 0.021–1.34 and 5.38–689.66 µM, 43.10–517.24 µM, and 0.0054–1.40 mM, respectively. The limit of detections (LODs) are calculated to be 20.00 nM, 9.25 µM, and 5.24 µM, respectively. Moreover, the sample spiked recoveries of Cu²⁺ in lake water, ST in milk, and glucose in strawberry samples were measured, and the results are in the range of 98.4–115.4% with the RSD (n = 3) lower than 3.3%. In addition, the method shows high selectivity in the real sample analysis.

Biosensing with DNAzymes

This article provides a comprehensive review of biosensing with DNAzymes, providing an overview of different sensing applications while highlighting major progress and seminal contributions to the field of portable biosensor devices and point-of-care diagnostics. Specifically, the field of functional nucleic acids is introduced, with a specific focus on DNAzymes. The incorporation of DNAzymes into bioassays is then described, followed by a detailed overview of recent advances in the development of in vivo sensing platforms and portable sensors incorporating DNAzymes for molecular recognition. Finally, a critical perspective on the field, and a summary of where DNAzyme-based devices may make the biggest impact are provided.

Embedding carbon dots and gold nanoclusters in metal-organic frameworks for ratiometric fluorescence detection of Cu2

Herein, a dual-emission metal-organic framework based ratiometric fluorescence nanoprobe was reported for detecting copper(II) ions. In particular, carbon dots (CDs) and gold nanoclusters (AuNCs) were embedded into ZIF-8 (one of the classical metal-organic frameworks) to form CDs/AuNCs@ZIF-8 nanocomposites, which exhibited dual-emission peaks at UV excitation. In the presence of Cu²⁺, the fluorescence attributed to AuNCs can be rapidly quenched, while the fluorescence of CDs serves as reference with undetectable changes. Therefore, the CDs/AuNCs@ZIF-8 nanocomposites were utilized as a ratiometric fluorescence nanoprobe for sensitive and selective detection of Cu²⁺. A good linear relationship between the ratiometric fluorescence signal of CDs/AuNCs@ZIF-8 and Cu²⁺ concentration was obtained in the range of 10^-3-10³ μM, and the detection limit was as low as 0.3324 nM. The current ratiometric fluorescence nanoprobe showed promising prospects in cost-effective and rapid determination of Cu²⁺ ions with good sensitivity and selectivity. Furthermore, this nanoprobe has been successfully applied for the quantitative detection of Cu²⁺ in serum samples, indicating its value of practical application. Graphical abstract Carbon dots (CDs) and gold nanoclusters (AuNCs) were embedded into metal-organic frameworks (ZIF-8) to form CDs/AuNCs@ZIF-8 nanocomposites, which exhibited dual-emission peaks at 365 nm excitation. In the presence of Cu²⁺, the fluorescence emission peak at 574 nm can rapidly respond by quenching, while the fluorescence at 462 nm serves as reference with undetectable changes.

Colorimetric Assay for Uracil DNA Glycosylase Activity Based on Toehold-Mediated Strand Displacement Circuit

Herein, a novel enzyme-free and label-free strategy for colorimetric assay of uracil DNA glycosylase (UDG) activity, which relies on a target-activated toehold-mediated strand displacement (TMSD) circuit is described. The strategy employs a detection duplex probe composed of a uracil-containing strand (US) and a catalyst strand (CS). UDG present in a sample will cleave uracil bases within US and destabilize the detection duplex probe, which then leads to the dissociation of the detection duplex, releasing CS. The free CS promotes the TMSD reaction, consequently liberating a G-quadruplex DNAzyme strand (GS) which is initially caged by a blocker strand (BS). Notably, a fuel strand (FS) is supplemented to recycle the CS to promote another cycle of TMSD reaction. As a consequence, a large number of GSs are activated by UDG activity and a distinct colorimetric signal is produced through the oxidation of ABTS promoted by the peroxidase mimicking activity of the liberated GSs. Based on this design principle, UDG activity down to 0.006 U mL^-1 with excellent selectivity is successfully determined. The practical applicability of this assay is also demonstrated by reliably determining UDG activities in human serum.

Multifunctional supramolecular self-assembly system for colorimetric detection of Hg2+, Fe3+, Cu2+ and continuous sensing of volatile acids and organic amine gases

A novel multifunctional gelator (1) based on an azobenzene derivative was designed and characterized. This compound could gelate some solvents including hexane, petroleum ether, DMSO, acetonitrile and ethanol through a heating-cooling procedure. The self-assembly process in different solvents was studied by means of UV-vis absorption and Fourier transform infrared (FTIR) spectra, field emission scanning electron microscopy (FESEM), rheological measurements, X-ray powder diffraction and water contact angle experiments. Interestingly, compound 1 had a high-contrast colorimetric detection ability towards Hg2+, Cu2+, Fe3+ and volatile acids and further organic amine gases in solution through its color change. At the same time, organogel 1 in acetonitrile also exhibited detection performance through a color or gel state change. In the response process, the self-assembly structures were changed from a nanofiber into a microsphere under induction by analytes. More significantly, film 1 could continuously detect volatile acids and organic amine gases. The number of cycles of film 1 for the detection of volatile acids and organic amine gases was at least seven times. The limit of detection (LOD) of film 1 towards TFA was calculated to be 0.0848 ppb. The sensing mechanisms were studied using 1HNMR, FESEM, UV-vis absorption spectra and HRMS. The intramolecular cyclization occurred on molecule 1 and a H2S molecule was lost during the detection process of Hg2+. It was proposed that the -N[double bond, length as m-dash]N- bonding could be coordinated by Fe3+ and Cu2+ and this further induced the absorption spectra and color change. For a volatile acid, it was possible that the volatile acid was combined with the N,N-dimethyl amine group of molecule 1. This research opens up a novel pathway to the fabrication of supramolecular self-assembly gels to detect polymetallic ions and trace volatile acids in the environment.