Large Isotope Effects in Organometallic Chemistry

Hydrogen Tunneling Exhibiting Unexpectedly Small Primary Kinetic Isotope Effects

Probing quantum mechanical tunneling (QMT) in chemical reactions is crucial to understanding and developing new transformations. Primary H/D kinetic isotopic effects (KIEs) beyond the semiclassical maximum values of 7-10 (room temperature) are commonly used to assess substantial QMT contributions in one-step hydrogen transfer reactions, because of the much greater QMT probability of protium vs. deuterium. Nevertheless, we report here the discovery of a reaction model occurring exclusively by H-atom QMT with residual primary H/D KIEs. 2-Hydroxyphenylnitrene, generated in N2 matrix, was found to isomerize to an imino-ketone via sequential (domino) QMT involving anti to syn OH-rotamerization (rate determining step) and [1,4]-H shift reactions. These sequential QMT transformations were also observed in the OD-deuterated sample, and unexpected primary H/D KIEs between 3 and 4 were measured at 3 to 20 K. Analogous residual primary H/D KIEs were found in the anti to syn OH-rotamerization QMT of 2-cyanophenol in a N2 matrix. Evidence strongly indicates that these intriguing isotope-insensitive QMT reactivities arise due to the solvation effects of the N2 matrix medium, putatively through coupling with the moving H/D tunneling particle. Should a similar scenario be extrapolated to conventional solution conditions, then QMT may have been overlooked in many chemical reactions.

Ligand effects, solvent cooperation, and large kinetic solvent deuterium isotope effects in gold(I)-catalyzed intramolecular alkene hydroamination

Kinetic studies on the intramolecular hydroamination of protected variants of 2,2-diphenylpent-4-en-1-amine were carried out under a variety of conditions with cationic gold catalysts supported by phosphine ligands. The impact of ligand on gold, protecting group on nitrogen, and solvent and additive on reaction rates was determined. The most effective reactions utilized more Lewis basic ureas, and more electron-withdrawing phosphines. A DCM/alcohol cooperative effect was quantified, and a continuum of isotope effects was measured with low KIE's in the absence of deuterated alcoholic solvent, increasing to large solvent KIE's when comparing reactions in pure MeOH to those in pure MeOH-d4. The effects are interpreted both within the context of a classic gold π-activation/protodeauration mechanism and a general acid-catalyzed mechanism without intermediate gold alkyls.

The Intrinsic Barrier Width and Its Role in Chemical Reactivity

Chemical reactions are in virtually all cases understood and explained on the basis of depicting the molecular potential energy landscape, i.e., the change in atomic positions vs the free-energy change. With such landscapes, the features of the reaction barriers solely determine chemical reactivities. The Marcus dissection of the barrier height (activation energy) on such a potential into the thermodynamically independent (intrinsic) and the thermodynamically dependent (Bell-Evans-Polanyi) contributions successfully models the interplay of reaction rate and driving force. This has led to the well-known and ubiquitously used reactivity paradigm of "kinetic versus thermodynamic control". However, an analogous dissection concept regarding the barrier width is absent. Here we define and outline the concept of intrinsic barrier width and the driving force effect on the barrier width and report experimental as well as theoretical studies to demonstrate their distinct roles. We present the idea of changing the barrier widths of conformational isomerizations of some simple aromatic carboxylic acids as models and use quantum mechanical tunneling (QMT) half-lives as a read-out for these changes because QMT is particularly sensitive to barrier widths. We demonstrate the distinct roles of the intrinsic and the thermodynamic contributions of the barrier width on QMT half-lives. This sheds light on resolving conflicting trends in chemical reactivities where barrier widths are relevant and allows us to draw some important conclusions about the general relevance of barrier widths, their qualitative definition, and the consequences for more complete descriptions of chemical reactions.

Non-Covalent Isotope Effects

In this Perspective, we present examples of isotope effects that originate from noncovalent interactions, mainly hydrogen bonding, electrostatics, and confinement. They are traditionally widely used in isotopic enrichment processes, as well as in studies of mechanisms of different (bio)chemical and physical phenomena. We then show the emerging areas of their applications, mainly medical and material sciences. We stress that these emerging applications require either high enrichment or isotopic substitution, which requires the development of new effective techniques of isotopic purification.

Zirconium-Catalyzed C-H Alumination of Polyolefins, Paraffins, and Methane

C-H/Et-Al exchange in zirconium-catalyzed reactions of saturated hydrocarbons and AlEt₃ affords versatile organoaluminum compounds and ethane. The grafting of commercially available Zr(OtBu)₄ on silica/alumina gives monopodal ≡SiO-Zr(OtBu)₃ surface pre-catalyst sites that are activated in situ by ligand exchange with AlEt₃. The catalytic C-H alumination of dodecane at 150 °C followed by quenching in air affords n-dodecanol as the major product, revealing selectivity for methyl group activation. Shorter hydrocarbon or alcohol products were not detected under these conditions. Catalytic reactions of cyclooctane and AlEt₃, however, afford ring-opened products, indicating that C-C bond cleavage occurs readily in methyl group-free reactants. This selectivity for methyl group alumination enables the C-H alumination of polyethylenes, polypropylene, polystyrene, and poly-α-olefin oils without significant chain deconstruction. In addition, the smallest hydrocarbon, methane, undergoes selective mono-alumination under solvent-free catalytic conditions, providing a direct route to Al-Me species.

A Contrasting Effect of Acid in Electron Transfer, Oxygen Atom Transfer, and Hydrogen Atom Transfer Reactions of a Nickel(III) Complex

There have been many examples of the accelerating effects of acids in electron transfer (ET), oxygen atom transfer (OAT), and hydrogen atom transfer (HAT) reactions. Herein, we report a contrasting effect of acids in the ET, OAT, and HAT reactions of a nickel(III) complex, [Ni^III(PaPy₃*)]²⁺ (1) in acetone/CH₃CN (v/v 19:1). 1 was synthesized by reacting [Ni^II(PaPy₃*)]⁺ (2) with magic blue or iodosylbenzene in the absence or presence of triflic acid (HOTf), respectively. Sulfoxidation of thioanisole by 1 and H₂O occurred in the presence of HOTf, and the reaction rate increased proportionally with increasing concentration of HOTf ([HOTf]). The rate of ET from diacetylferrocene to 1 also increased linearly with increasing [HOTf]. In contrast, HAT from 9,10-dihydroanthracene (DHA) to 1 slowed down with increasing [HOTf], exhibiting an inversely proportional relation to [HOTf]. The accelerating effect of HOTf in the ET and OAT reactions was ascribed to the binding of H⁺ to the PaPy₃* ligand of 2; the one-electron reduction potential (E_red) of 1 was positively shifted with increasing [HOTf]. Such a positive shift in the E_red value resulted in accelerating the ET and OAT reactions that proceeded via the rate-determining ET step. On the other hand, the decelerating effect of HOTf on HAT from DHA to 1 resulted from the inhibition of proton transfer from DHA^•+ to 2 due to the binding of H⁺ to the PaPy₃* ligand of 2. The ET reactions of 1 in the absence and presence of HOTf were well analyzed in light of the Marcus theory of ET in comparison with the HAT reactions.

Does Reduction-Induced Isomerization of a Uranium(III) Aryl Complex Proceed via C-H Oxidative Addition and Reductive Elimination across the Uranium(II/IV) Redox Couple?

Reaction of the uranium(III) bis(amidinate) aryl complex {TerphC(NⁱPr)₂}₂U(Terph) (2, where Terph = 4,4″-di-tert-butyl-m-terphenyl-2'-yl) with a strong reductant enabled isolation of isomeric uranium(III) bis(amidinate) aryl product {TerphC(NⁱPr)₂}₂U(Terph*) (3, where Terph* = 4,4″-di-tert-butyl-m-terphenyl-4'-yl). In terms of connectivity, 3 differs from 2 only in the positions of the U-C and C-H bonds on the central aryl ring of the m-terphenyl-based ligand. A deuterium labeling study ruled out mechanisms for this isomerization involving intermolecular abstraction or deprotonation of the ligand C-H bonds activated during the reaction. Due to the complexity of this rapid, heterogeneous reaction, experimental studies could not further distinguish between two different intramolecular C-H activation mechanisms. However, high-level computational studies were consistent with a mechanism that included two sets of unimolecular, mononuclear C-H oxidative addition and reductive elimination steps involving uranium(II/IV).

Heme compound II models in chemoselectivity and disproportionation reactions

Heme compound II models bearing electron-deficient and -rich porphyrins, [FeIV(O)(TPFPP)(Cl)]- (1a) and [FeIV(O)(TMP)(Cl)]- (2a), respectively, are synthesized, spectroscopically characterized, and investigated in chemoselectivity and disproportionation reactions using cyclohexene as a mechanistic probe. Interestingly, cyclohexene oxidation by 1a occurs at the allylic C-H bonds with a high kinetic isotope effect (KIE) of 41, yielding 2-cyclohexen-1-ol product; this chemoselectivity is the same as that of nonheme iron(iv)-oxo intermediates. In contrast, as observed in heme compound I models, 2a yields cyclohexene oxide product with a KIE of 1, demonstrating a preference for C[double bond, length as m-dash]C epoxidation. The latter result is interpreted as 2a disproportionating to form [FeIV(O)(TMP+˙)]+ (2b) and FeIII(OH)(TMP), and 2b becoming the active oxidant to conduct the cyclohexene epoxidation. In contrast to 2a, 1a does not disproportionate under the present reaction conditions. DFT calculations confirm that compound II models prefer C-H bond hydroxylation and that disproportionation of compound II models is controlled thermodynamically by the porphyrin ligands. Other aspects, such as acid and base effects on the disproportionation of compound II models, have been discussed as well.

Inverse Isotope Effects in Single-Crystal to Single-Crystal Reactivity and the Isolation of a Rhodium Cyclooctane σ-Alkane Complex

The sequential solid/gas single-crystal to single-crystal reaction of [Rh(Cy₂P(CH₂)₃PCy₂)(COD)][BAr^F₄] (COD = cyclooctadiene) with H₂ or D₂ was followed in situ by solid-state ³¹P{¹H} NMR spectroscopy (SSNMR) and ex situ by solution quenching and GC-MS. This was quantified using a two-step Johnson–Mehl–Avrami–Kologoromov (JMAK) model that revealed an inverse isotope effect for the second addition of H₂, that forms a σ-alkane complex [Rh(Cy₂P(CH₂)₃PCy₂)(COA)][BAr^F₄]. Using D₂, a temporal window is determined in which a structural solution for this σ-alkane complex is possible, which reveals an η²,η²-binding mode to the Rh(I) center, as supported by periodic density functional theory (DFT) calculations. Extensive H/D exchange occurs during the addition of D₂, as promoted by the solid-state microenvironment.

The continuum of carbon-hydrogen (C-H) activation mechanisms and terminology

As a rapidly growing field across all areas of chemistry, C-H activation/functionalisation is being used to access a wide range of important molecular targets. Of particular interest is the development of a sustainable methodology for alkane functionalisation as a means for reducing hydrocarbon emissions. This Perspective aims to give an outline to the community with respect to commonly used terminology in C-H activation, as well as the mechanisms that are currently understood to operate for (cyclo)alkane activation/functionalisation.

Nitrene Photochemistry of Manganese N-Haloamides*

Manganese complexes supported by macrocyclic tetrapyrrole ligands represent an important platform for nitrene transfer catalysis and have been applied to both C-H amination and olefin aziridination catalysis. The reactivity of the transient high-valent Mn nitrenoids that mediate these processes renders characterization of these species challenging. Here we report the synthesis and nitrene transfer photochemistry of a family of Mn^III N-haloamide complexes. The S=2 N-haloamide complexes are characterized by ¹ H NMR, UV-vis, IR, high-frequency and -field EPR (HFEPR) spectroscopies, and single-crystal X-ray diffraction. Photolysis of these complexes results in the formal transfer of a nitrene equivalent to both C-H bonds, such as the α-C-H bonds of tetrahydrofuran, and olefinic substrates, such as styrene, to afford aminated and aziridinated products, respectively. Low-temperature spectroscopy and analysis of kinetic isotope effects for C-H amination indicate halogen-dependent photoreactivity: Photolysis of N-chloroamides proceeds via initial cleavage of the Mn-N bond to generate Mn^II and amidyl radical intermediates; in contrast, photolysis of N-iodoamides proceeds via N-I cleavage to generate a Mn^IV nitrenoid (i.e., {MnNR}⁷ species). These results establish N-haloamide ligands as viable precursors in the photosynthesis of metal nitrenes and highlight the power of ligand design to provide access to reactive intermediates in group-transfer catalysis.