Advance in Detection Technique of Lean Meat Powder Residues in Meat Using SERS: A Review

Food that contains lean meat powder (LMP) can cause human health issues, such as nausea, headaches, and even death for consumers. Traditional methods for detecting LMP residues in meat are often time-consuming and complex and lack sensitivity. This article provides a review of the research progress on the use of surface-enhanced Raman spectroscopy (SERS) technology for detecting residues of LMP in meat. The review also discusses several applications of SERS technology for detecting residues of LMP in meat, including the enhanced detection of LMP residues in meat based on single metal nanoparticles, combining metal nanoparticles with adsorbent materials, combining metal nanoparticles with immunizing and other chemicals, and combining the SERS technology with related techniques. As SERS technology continues to develop and improve, it is expected to become an even more widely used and effective tool for detecting residues of LMP in meat.

Raman enhancement effect of different silver nanoparticles on salbutamol

Salbutamol is a β-adrenergic receptor agonist compound which has been abused as an animal growth promoter to improve carcass lean meat percentage. At present, the detection of salbutamol by SERS mostly uses gold colloid as substrate, which is expensive and has a high detection limit. In this report, Raman enhancement signal of salbutamol was compared with concentrated gold and silver colloids. The results show that the concentrated silver colloid prepared by reducing silver nitrate with hydroxylamine hydrochloride had superior performance. Three silver colloids with different particle sizes were synthesized by the same reducing agent and used as substrates for spectra acquisition of salbutamol to explore the enhancement performance of different silver nanoparticles sizes on salbutamol. The results showed that silver nanoparticles with larger particle sizes were more conducive to the adsorption of salbutamol. Finally, under the optimal conditions (Silver colloid A as enhanced substrate, 0.2 mol/L NaOH aqueous solution as aggregating compound), a better linear relationship between the concentration of salbutamol (ranged from 0.2 to 1 mg/L) and SERS intensity. The linear equation between SERS intensity and salbutamol concentration was C = 0.0023∙I-0.079 (mg/L) with a good linearity (R² =0.994) and lower root mean square error (RMSE_c = 0.022 mg/L), where C (mg/L) was the concentration of salbutamol solution and I was the SERS intensity of salbutamol solution. Validation set correlation coefficient was 0.988 and prediction root mean square error was 0.029 mg/L. This method provides a new idea for further reducing the detection limit of salbutamol. This study is helpful to further develop a simple and low-cost SERS detection method of salbutamol based on silver colloid.

•

Raman enhancement signal of salbutamol was compared with concentrated gold and silver colloids.

•

The effect of silver nanoparticles sizes on the enhancement effect are in particular broached.

•

The methods can realize salbutamol at trace concentrations detection.

Using Polar Ion-Pairs to Control Drug Delivery to the Airways of the Lungs

The rapid absorptive clearance of drugs delivered to the airways of the lungs means that many inhaled medicines have a short duration of action. The aim of this study was to investigate whether forming polar ion-pairs can modify drug absorption to slow down clearance from the airways. Salbutamol was used as a model drug and was formulated as ion-pairs in an aqueous solution with three negatively charged hydrophilic counterions: sulfate (molecular weight (MW) 142), gluconate (MW 218), and phytate (MW 736) (association constants of 1.57, 2.27, and 4.15, respectively) and one negatively charged hydrophobic counterion, octanoate (MW 166) (association constant, 2.56). All of the counterions were well tolerated by Calu-3 human bronchial epithelial cells when screened for toxicity in vitro using conditions that in silico simulations suggested maintain >80% drug-counterion association. The transport of salbutamol ion-pairs with higher polar surface area (PSA), i.e., the sulfate (PSA 52%), gluconate (PSA 50%), and phytate (PSA 79%) ion-pairs, was significantly lower compared to that of the drug alone (PSA 30%, p < 0.05). In contrast, the octanoate ion-pair (PSA 23%) did not significantly alter the salbutamol transport. The transport data for the gluconate ion-pair suggested that the pulmonary absorption half-life of the ion-paired drug would be double that of salbutamol base, and this illustrates the promise of increasing drug polarity using noncovalent complexation as an approach to control drug delivery to the airways of the lungs.

Surface nano-engineered wheat straw for portable and adjustable water purification

Wheat straw (WS), as a cheap and abundant agricultural waste, is usually burned directly in farmland and causes severe air pollution. Therefore, biochar derived from waste WS is prepared and modified by nanoscaled zinc oxide through a facile in-situ surface-modification process. For ease of use, a 3D printed finger-sized unit (FSU) loaded with the above as-prepared WS is designed and implemented. Each unit weighs only 4 g, and could simultaneously reduce three major water contaminants: bacteria, organic dyes, and heavy metal ions. Moreover, it is interesting to note that fresh wheat straw is a flexible material and has excellent electrical conductivity after carbonization. These two properties (flexibility and conductivity) could further adjust water purification performance. The subsequent cellular and animal tests confirmed the biosafety of the water purified with FSU alone.

1064 nm Dispersive Raman Microspectroscopy and Optical Trapping of Pharmaceutical Aerosols

Raman spectroscopy is a powerful tool for investigating chemical composition. Coupling Raman spectroscopy with optical microscopy (Raman microspectroscopy) and optical trapping (Raman tweezers) allows microscopic length scales and, hence, femtolitre volumes to be probed. Raman microspectroscopy typically uses UV/visible excitation lasers, but many samples, including organic molecules and complex tissue samples, fluoresce strongly at these wavelengths. Here we report the development and application of dispersive Raman microspectroscopy designed around a near-infrared continuous wave 1064 nm excitation light source. We analyze microparticles (1-5 μm diameter) composed of polystyrene latex and from three real-world pressurized metered dose inhalers (pMDIs) used in the treatment of asthma: salmeterol xinafoate (Serevent), salbutamol sulfate (Salamol), and ciclesonide (Alvesco). For the first time, single particles are captured, optically levitated, and analyzed using the same 1064 nm laser, which permits a convenient nondestructive chemical analysis of the true aerosol phase. We show that particles exhibiting overwhelming fluorescence using a visible laser (514.5 nm) can be successfully analyzed with 1064 nm excitation, irrespective of sample composition and irradiation time. Spectra are acquired rapidly (1-5 min) with a wavelength resolution of 2 nm over a wide wavenumber range (500-3100 cm^-1). This is despite the microscopic sample size and low Raman scattering efficiency at 1064 nm. Spectra of individual pMDI particles compare well to bulk samples, and the Serevent pMDI delivers the thermodynamically preferred crystal form of salmeterol xinafoate. 1064 nm dispersive Raman microspectroscopy is a promising technique that could see diverse applications for samples where fluorescence-free characterization is required with high spatial resolution.

Measurement of the Raman spectra and hygroscopicity of four pharmaceutical aerosols as they travel from pressurised metered dose inhalers (pMDI) to a model lung

Particle inhalation is an effective and rapid delivery method for a variety of pharmaceuticals, particularly bronchodilation drugs used for treating asthma and COPD. Conditions of relative humidity and temperature inside the lungs are generally very different from the outside ambient air, with the lung typically being warmer and more humid. Changes in humidity, from inhaler to lung, can cause hygroscopic phase transitions and particle growth. Increasing particle size and mass can negatively affect particle deposition within the lung leading to inefficient treatment, while deliquescence prior to impaction is liable to accelerate drug uptake. To better understand the hygroscopic properties of four pharmaceutical aerosol particles; pharmaceutical particles from four commercially available pressurised metered dose inhalers (pMDIs) were stably captured in an optical trap, and their composition was examined online via Raman spectroscopy. Micron-sized particles of salbutamol sulfate, salmeterol xinafoate, fluticasone propionate and ciclesonide were levitated and examined over a range of relative humidity values inside a chamber designed to mimic conditions within the respiratory tract. The effect of temperature upon hygroscopicity was also investigated for salbutamol sulfate particles. Salbutamol sulfate was found to have significant hygroscopicity, salmeterol xinafoate showed some hygroscopic interactions, whilst fluticasone propionate and ciclesonide revealed no observable hygroscopicity. Thermodynamic and structural modelling is used to explain the observed experimental results.

Rapid determination of ractopamine in swine urine using surface-enhanced Raman spectroscopy

Ractopamine is approved for use in swine to improve carcass leanness in the United States, but banned in the European Union and China because ractopamine residue may pose health risks. This study investigated the possibility of applying surface-enhanced Raman spectroscopy (SERS) for analysis of ractopamine in swine urine. Ractopamine (0.1-10 μg mL(-1)) was added to urine samples collected from 20 swine to prepare a total of 240 samples. A simple centrifugation, a liquid-liquid extraction (LLE) method, and a more complicated method involving liquid-liquid extraction and solid-phase extraction (LLE-SPE) were used to extract ractopamine from urine samples. Principal component analysis (PCA) and partial least-squares (PLS) regression were used for spectral data analyses. Although no satisfactory result was obtained with the centrifugation method, ractopamine could be detected at levels of 0.8 and 0.4 μg mL(-1) with the LLE and LLE-SPE extraction methods, respectively. The R2 of the PLS model of actual ractopamine values versus predicted values was 0.74 for the LLE method and 0.73 for the LLE-SPE method. The SERS method with simple sample preparation has great potential for rapid analysis of ractopamine in swine urine.

Adsorption of beta-adrenergic agonists used in sport doping on metal nanoparticles: a detection study based on surface-enhanced Raman scattering

The adsorption of beta(2)-adrenergic agonist (βAA) drugs clenbuterol, salbutamol, and terbutaline on metal surfaces has been investigated in this work by means of surface-enhanced Raman scattering (SERS). To assist in this investigation, a previous vibrational (IR and normal Raman) characterization of these drugs was performed, supported by ab initio density functional theory calculations. The application of SERS was aimed to apply this highly sensitive technique, based on localized surface plasmon resonance, in the detection of βAA at trace concentrations and as a possible alternative method which can be postulated in routine antidoping analysis. The adsorption of these drugs was studied in depth at different experimental conditions: on Au and Ag, at different pHs, and with varying adsorbate concentration. Moreover, plasmon resonance spectroscopy was employed to investigate the adsorption of these drugs on the metal nanoparticles as well as their aggregation. It was found that the adsorption of these molecules is more effective on gold nanoparticles and at acidic pH, based on the direct interaction of the aromatic or aliphatic moieties through ionic or coordination bonds with the metal. These drugs followed a Langmuir adsorption model from which the adsorption constant and the limit of detection can be determined.