Quantification of sofosbuvir in human serum by liquid chromatography with negative ionization mass spectrometry using the parent peak and its source-induced fragment: Application to a bioequivalence study

An environmentally sustainable synchronous spectrofluorimetric method coupled with second derivative signal processing for simultaneous determination of velpatasvir and simeprevir in pharmaceutical and plasma samples

Velpatasvir and simeprevir are two direct acting antivirals that are often used in combination with sofosbuvir to treat HCV infections. Herein, an environmentally benign spectrofluorimetric method was developed for simultaneous quantification of velpatasvir and simeprevir in pharmaceutical and plasma samples. To address the issue of overlapping fluorescence spectra presented by these compounds, this method integrates synchronous fluorescence and second-derivative spectroscopy. By employing the second derivative of the synchronous fluorescence spectra measured at Δλ of 140 nm, the accurate determination of velpatasvir at 400 nm and simeprevir at 426 nm was achieved without any interference. Different experimental parameters affecting the synchronous fluorescence of the studied drugs were carefully optimized. The plots of second-derivative amplitudes against concentrations showed linearity in the range of 5-400 ng/mL for velpatasvir and 80-800 ng/mL for simeprevir. The method was very sensitive, with lower detection limits of 1.11 ng/mL and 25.40 ng/mL, and quantification limits of 3.36 ng/mL and 76.96 ng/mL for velpatasvir and simeprevir, respectively.The method was effectively used to determine velpatasvir and simeprevir simultaneously in their pure forms, pharmaceutical dosage forms, and human plasma with no interference. The suggested technique was additionally evaluated for its eco-friendliness through the utilization of the Analytical GREEnness (AGREE) and Green Analytical Procedure Index (GAPI) evaluation metrics, revealing that the method is indeed sustainable.

Rapid bioanalytical LC-MS/MS method for the simultaneous determination of sofosbuvir and velpatasvir in human plasma-application to a pharmacokinetic study in Egyptian volunteers

A novel, rapid and validated LC-MS/MS bioanalytical method has been developed for the extraction and determination of sofosbuvir and velpatasvir simultaneously in human plasma using ledipasvir as an internal standard (IS). The simple and reproducible protein precipitation technique with acetonitrile was successfully used for the deproteinization and extraction of the analytes from human plasma matrix. The developed method achieved consistent recoveries over different concentrations with average extraction recoveries of 81.72% and 80.46% for sofosbuvir and velpatasvir, respectively. The chromatographic separation was performed within only 2.80 min as a run time by an isocratic elution through C18 Zorbox eclipse plus (100 × 4.6 mm, 5 μm). Optimum mobile phase consisted of 0.1% formic acid in water: acetonitrile: methanol (30:60:10, v/v/v) pumped at a flow rate of 0.55 mL min^-1 and injection volume was 10 μL. LC-MS/MS detection was done by multiple reaction monitoring transitions operating at positive ionization mode for both analytes and IS. Bioanalytical method validation as per EMA guidelines was carried out where the proposed method revealed linearity over the concentration range of 5-5000 and 10-1500 ng mL^-1 for sofosbuvir and velpatasvir, respectively. After validation, the method was applied to the analysis of the two drugs after a single oral administration of Epclusa 400/100 mg tablets to Egyptian healthy volunteers.

Development of a highly sensitive high-performance thin-layer chromatography method for the screening and simultaneous determination of sofosbuvir, daclatasvir, and ledipasvir in their pure forms and their different pharmaceutical formulations

The combination of sofosbuvir and daclatasvir or sofosbuvir and ledipasvir is now widely used as an ideal treatment for hepatitis C virus infection. For this purpose, a simple, sensitive, accurate, economic, and precise high-performance thin-layer chromatography was developed and validated for the determination of sofosbuvir, daclatasvir, and ledipasvir in their pure form as well as their different pharmaceutical products. The method used Merck high-performance thin-layer chromatography aluminum plates precoated with silica gel 60 F254 as a stationary phase and mobile phase consisting of methylene chloride/methanol/ethyl acetate/ammonia (25%) (6:1:4:1, v/v/v/v). This system was found to give compact symmetric peaks of sofosbuvir, daclatasvir, and ledipasvir with retardation factors of 0.27 ± 0.01, 0.50 ± 0.007, and 0.68 ± 0.008, respectively. The densitometric scanner was set at 275 nm using a deuterium lamp. The calibration curves were linear over the range of 100-3000 ng/spot for sofosbuvir, and daclatasvir, and range of 50-3000 ng/spot for ledipasvir. The detection limits were 22.5, 31.90, and 15.80 for sofosbuvir, daclatasvir, and ledipasvir. The quantitation limits were 67.50, 95.60, and 47.50 for sofosbuvir, daclatasvir, and ledipasvir. The proposed method was validated according to International Conference on Harmonization (ICH) guidelines and the results were acceptable.

Development and validation of a new HPLC-DAD method for quantification of sofosbuvir in human serum and its comparison with LC-MS/MS technique: Application to a bioequivalence study

Although for many analyses tandem mass spectrometry (LC-MS/MS) systems have significant advantage over the high-performance liquid chromatography with diode array detection (HPLC-DAD) however, the HPLC methods are easier, cheaper and more available to perform. As no published method is available for quantitative HPLC analysis of sofosbuvir (SOF), an orally administered anti-hepatitis drug in human serum, this study was aimed to evaluate applicability of the HPLC technique to quantify sofosbuvir and comparison of the two methods for analytical performance. Following extraction of the drug and an internal standard (Hexobarbital), same chromatographic conditions were used for both the systems. After the chromatographic separation on a reverse phase C18 column using a mobile phase consisting of water (containing formic acid 0.5mL/L) and acetonitrile (57:43; v/v) at a flow rate of 0.8mL/min, the eluate was introduced into a DAD detector set at 261nm, then passed through the mass spectrometry system in single ion monitoring mode (SIM). For UV and mass spectrometry detections the calibration curves were linear over a concentration range of 25-3200 and 10-3200ng/mL, respectively and the linearity was over 0.998 for both the systems. Lower limit of quantification (LLOQ) for mass spectrometry and DAD detections were 10 and 25ng/mL, respectively. In conclusion sensitivity of DAD detection is sufficient enough to determine concentrations down to 0.5% of C_max which achieved in bioequivalence study of sofosbuvir and meet FDA requirements for these types of studies.

Current antiviral drugs and their analysis in biological materials - Part II: Antivirals against hepatitis and HIV viruses

This review is a Part II of the series aiming to provide comprehensive overview of currently used antiviral drugs and to show modern approaches to their analysis. While in the Part I antivirals against herpes viruses and antivirals against respiratory viruses were addressed, this part concerns antivirals against hepatitis viruses (B and C) and human immunodeficiency virus (HIV). Many novel antivirals against hepatitis C virus (HCV) and HIV have been introduced into the clinical practice over the last decade. The recent broadening portfolio of these groups of antivirals is reflected in increasing number of developed analytical methods required to meet the needs of clinical terrain. Part II summarizes the mechanisms of action of antivirals against hepatitis B virus (HBV), HCV, and HIV, their use in clinical practice, and analytical methods for individual classes. It also provides expert opinion on state of art in the field of bioanalysis of these drugs. Analytical methods reflect novelty of these chemical structures and use by far the most current approaches, such as simple and high-throughput sample preparation and fast separation, often by means of UHPLC-MS/MS. Proper method validation based on requirements of bioanalytical guidelines is an inherent part of the developed methods.