Development of a hollow fiber-liquid phase microextraction method using tissue culture oil for the extraction of free metoprolol from plasma samples

In this research, a method known as a hollow fiber-liquid-phase microextraction was employed to extract and concentrate free metoprolol from plasma samples. The extracted analyte was subsequently determined using high-performance liquid chromatography coupled with a diode-array detector. Several parameters, including hollow fiber length, sonication time, extraction temperature, and salt addition, were investigated and optimized to enhance extraction efficiency. After extracting the analyte under optimum conditions from plasma samples, the enrichment factor and extraction recovery were 50 and 86 %, respectively. Moreover, the method exhibited detection and quantification limits of 0.41 and 1.30 ng mL-1, respectively. The analysis of real samples demonstrated satisfactory relative recoveries in the range of 91-99 %.

Extraction performance of electromembrane extraction and liquid-phase microextraction in prototype equipment

In this comparative study, the performance of liquid-phase microextraction and electromembrane extraction in prototype equipment was evaluated for extraction of ninety basic substances from plasma. Using a commercial EME device based on conductive vials enabled a standardized and comprehensive comparison between the two methods. Extractions were performed from a pH-adjusted donor solution, across an organic liquid membrane immobilized in a porous polypropylene membrane, and into an acidic acceptor solution. In LPME, dodecyl acetate was used as the extraction solvent, while 2-nitrophenyl octyl ether was used for EME with an electric field applied across the system. To assess the extraction performance, extraction recovery plots and extraction time curves were constructed and analyzed. These plots provided insights into the efficiency and effectiveness of LPME and EME, allowing users to make better decisions about the most suitable method for a specific bioanalytical application. Both LPME and EME were effective for substances with 2.0 < log P < 4.0, with EME showing faster extraction kinetics. Small (200 µL) and large vials (600 µL) were compared, showing that smaller vials improved kinetics markedly in both techniques. Carrier-mediated extraction showed improved performance for analytes with log P < 2 in EME, however, with some limitations due to system instability. This is, to our knowledge, the first time LPME was performed in the commercial vial-based equipment. An evaluation of vial-based LPME investigating linearity, precision, accuracy, and matrix effects showed promising results. These findings contribute to a general understanding of the performance differences in vial-based LPME and EME.

A hydrophobic deep eutectic solvent-based vortex-assisted liquid-liquid microextraction applied for doping control of aromatase inhibitors from equine urine

Aromatase inhibitors (AIs) can indirectly cause increased testosterone in animals, which leads to the improvement of the athletic ability of horses. For the protection of horses and the consideration of fair competition, AIs were listed as prohibited drugs by the Federation Equestre Internationale (FEI). There were several disadvantages using traditional pretreatment methods before analyzing these drugs from biological samples. A rapid and green pretreatment method has been developed by utilizing the hydrophobic deep eutectic solvent (DES)-based vortex-assisted liquid-liquid microextraction (DES-VALLME) followed by ultra-high performance liquid chromatography tandem triple-quadrupole mass spectrometry (UHPLC-MS/MS) technique for the efficient extraction and sensitive detection of AIs in equine urine samples. The combination of menthol and 4-fluorophenol in a molar ratio 1:4 was chosen as the optimum composition of DES for extracting AIs. Under the optimum conditions, only 80 μL of DES, 1 mL equine urine and 2 min were expended. An external standard calibration method was utilized for determination, and a linear relationship was achieved with a concentration range of 0.02-4000 ng mL-1 (r2 ≥ 0.9983). The limits of detection of the method based on a signal-to-noise ratio of 3 were 0.01-4 ng mL-1. The accuracy recoveries ranged from 94.9% to 113.4% within the intra-day and inter-day relative standard deviations of less than 9.1%. Compared with traditional extraction methods, the DES-VALLME method had the advantages of rapidity, simplicity, efficiency, low toxicity, and low cost. This method has potential and possessed brilliant prospects for doping control.

Modern automated microextraction procedures for bioanalytical, environmental, and food analyses

Sample preparation frequently is considered the most critical stage of the analytical workflow. It affects the analytical throughput and costs; moreover, it is the primary source of error and possible sample contamination. To increase efficiency, productivity, and reliability, while minimizing costs and environmental impacts, miniaturization and automation of sample preparation are necessary. Nowadays, several types of liquid-phase and solid-phase microextractions are available, as well as different automatization strategies. Thus, this review summarizes recent developments in automated microextractions coupled with liquid chromatography, from 2016 to 2022. Therefore, outstanding technologies and their main outcomes, as well as miniaturization and automation of sample preparation, are critically analyzed. Focus is given to main microextraction automation strategies, such as flow techniques, robotic systems, and column-switching approaches, reviewing their applications to the determination of small organic molecules in biological, environmental, and food/beverage samples.

A study on the enrichment mechanism of three nitrophenol isomers in environmental water samples by charge transfer supramolecular-mediated hollow fiber liquid-phase microextraction

To explore the mechanism of extraction and enrichment of three nitrophenol isomers by charge-transfer supramolecular synergistic three-phase microextraction system, a charge transfer supramolecular-mediated hollow fiber liquid-phase microextraction (CTSM-HF-LPME) combined with high-performance liquid chromatography-ultraviolet detector (HPLC-UV) method was established for the determination of real environmental water samples. In this study, the three nitrophenols (NPs) formed charge-transfer supramolecules with electron-rich hollow fibers, which promoted the transport of NPs in the three-phase extraction system and greatly increased the EFs of NPs. The relationships between the EFs of NPs and their solubility, pK_a, apparent partition coefficient, equilibrium constant, and structural property parameters were investigated and discussed. At the same time, most of factors affecting the EFs of NPs were investigated and optimized, such as the type of extraction solvent, pH value of sample phase and acceptor phase, extraction time, and stirring speed. Under optimal conditions, the EFs of o-nitrophenol, m-nitrophenol, and p-nitrophenol were 163, 145, and 87, respectively. With good linearity in the range of 5 × 10^-7 ~ 1 µg/mL, and the limit of detection of 0.1 pg/mL, the relative standard deviations of the method precision were lower than 7.4%, and the average recoveries were between 98.6 and 106.4%. This method had good selectivity and sensitivity, satisfactory precision, and accuracy and had been successfully applied to the trace detection of real water samples.

Trends in hollow fibre liquid phase microextraction for the preconcentration of pharmaceutically active compounds in aqueous solution: A case for polymer inclusion membrane

Low concentrations of pharmaceutically active compounds have been reported in samples from highly complex aqueous environments. Due to their low concentrations, efficient sample pretreatment methods are needed to clean samples and concentrate the compounds of interest prior to instrumental analysis. Hollow fibre liquid-phase microextraction (HF-LPME) is an effective alternative to conventional techniques such as liquid-liquid extraction (LLE) and solid phase extraction (SPE) because it consumes less organic solvent and is less labour intensive with a short extraction time. HF-LPME involves the preconcentration and mass transfer of target analytes from an aqueous sample into an acceptor solution in the lumen of the fibre using a supported liquid membrane (SLM) impregnated in the hollow fibre pores. However, despite the high contaminant selectivity, reproducibility, and enrichment that HF-LPME offers, this technique is limited by membrane instability. Although several advances have been made to address membrane instability, they are either too costly or not feasible for industrial application. Hence, hollow fibre polymer inclusion membrane liquid-phase microextraction (HF-PIM-LPME) was introduced to ameliorate membrane instability. This new approach uses ionic liquids (ILs) as a green solvent, and has demonstrated high membrane stability, good contaminant enrichment, and similar selectivity and reproducibility to HF-SLM-LPME. Hence, this review aims to raise awareness of HF-PIM-LPME as a viable alternative for the selectivity and preconcentration of pharmaceuticals and other contaminants in aquatic environments.

Salting-out homogeneous liquid-liquid microextraction for the determination of azole drugs in human urine: Validation using total error concept

A salting-out homogeneous liquid-liquid microextraction was proposed for the quantification of four azole drugs in human urine prior to high-performance liquid chromatography analysis. The procedure involved the mixing of the sample with acetonitrile in appropriate volumes followed by the addition of sodium sulfate solution in order to facilitate phase separation. The parameters influencing the extraction performance were studied and optimized using a two-step experimental design. The analytical procedure was thoroughly validated using the accuracy profiles as a graphical decision-making tool. The β-expectation tolerance intervals did not exceed the acceptance criteria of ±15% meaning that 95% of future results will be included in the defined bias limits. The limits of detection of the procedure were satisfactory, ranging between 0.01 and 0.03 μg/mL. The mean analytical bias in the spiking levels was satisfactory and ranged between -10.3 and 4.2% while the relative standard deviation was lower than 5.6%. Monte-Carlo simulations followed by capability analysis were employed to investigate the ruggedness of the sample preparation protocol. The developed method offers advantages compared to previously reported approaches for the same type of analysis including extraction efficiency and scaling down of the sample volume and extraction time.

Recent applications of microextraction sample preparation techniques in biological samples analysis

Analysis of biological samples is affected by interfering substances with chemical properties similar to those of the target analytes, such as drugs. Biological samples such as whole blood, plasma, serum, urine and saliva must be properly processed for separation, purification, enrichment and chemical modification to meet the requirements of the analytical instruments. This causes the sample preparation stage to be of undeniable importance in the analysis of such samples through methods such as microextraction techniques. The scope of this review will cover a comprehensive summary of available literature data on microextraction techniques playing a key role for analytical purposes, methods of their implementation in common biological samples, and finally, the most recent examples of application of microextraction techniques in preconcentration of analytes from urine, blood and saliva samples. The objectives and merits of each microextration technique are carefully described in detail with respect to the nature of the biological samples. This review presents the most recent and innovative work published on microextraction application in common biological samples, mostly focused on original studies reported from 2017 to date. The main sections of this review comprise an introduction to the microextraction techniques supported by recent application studies involving quantitative and qualitative results and summaries of the most significant, recently published applications of microextracion methods in biological samples. This article considers recent applications of several microextraction techniques in the field of sample preparation for biological samples including urine, blood and saliva, with consideration for extraction techniques, sample preparation and instrumental detection systems.

Synthesis and characterization of new surface modified magnetic nanoparticles and application for the extraction of letrozole from human plasma and analysis with HPLC-fluorescence

Acetic acid-functionalized magnetic nanoparticles modified by (3-amino-propyl)-tri-ethoxy silane was synthesized and used as a new solid-phases adsorbent. Infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), x-ray diffraction (XRD), energy-dispersive x-ray spectroscopy (EDX), vibrating sample magnetometer (VSM) and Electrophoretic Light Scattering (ELS) were used to characterize the modified nanoparticles. The molecular interaction between letrozole and nanoparticles (NPs) was studied using density functional theory (DFT) calculations. The developed nanoparticles were applied for dispersive solid-phase extraction of letrozole (an anticancer drug) from human plasma. Extracted letrozole was quantified using an isocratic HPLC/FL method. The extraction efficiency was optimized using one experiment at a time optimization method based on the adsorbent quantity, sample pH, adsorption time, desorption time, and elution solvent type/volume. The analysis method was fully validated according to the FDA guideline for bioanalytical method validation. The linear quantification range was 0.01-1 μg/mL and the lower limit of quantification (LLOQ) was 0.01 μg/mL. Plasma samples of 6 patients were analyzed and the measured letrozole concentrations range was 0.04-0.31 μg/mL. The newly synthesized magnetic nanoparticles were used successfully for the extraction of letrozole from spiked and clinical plasma samples. The developed method is a precise and simple method that is suitable for pharmacokinetic studies and clinical applications.

A Comprehensive Review on Developed Pharmaceutical Analysis Methods by Iranian Analysts in 2018

This article summarizes the publishing activities including bioanalytical and pharmaceutical analyses researches carried out in Iran in 2018 in order to connect academic researchers to those in industry, medical care units and hospitals. A wide spectrum of analytical methods has been used to determine and/or evaluate drug levels in the biological samples, based on physical, chemical and biochemical principles. We have compiled a concise survey of the literature covering 125 reports and tabulated the relevant analytical parameters. Chromatographic and electrochemical methods were found to be the technique of choice for many workers and almost 83% studies were performed by using these methods. This is the first annual review of the literature searching in SCOPUS database for published bioanalytical and pharmaceutical analysis researches in Iran.

Hollow fiber-based liquid phase microextraction followed by analytical instrumental techniques for quantitative analysis of heavy metal ions and pharmaceuticals

Hollow-fiber liquid-phase microextraction (HF-LPME) and electromembrane extraction (EME) are miniaturized extraction techniques, and have been coupled with various analytical instruments for trace analysis of heavy metals, drugs and other organic compounds, in recent years. HF-LPME and EME provide high selectivity, efficient sample cleanup and enrichment, and reduce the consumption of organic solvents to a few micro-liters per sample. HF-LPME and EME are compatible with different analytical instruments for chromatography, electrophoresis, atomic spectroscopy, mass spectrometry, and electrochemical detection. HF-LPME and EME have gained significant popularity during the recent years. This review focuses on hollow fiber based techniques (especially HF-LPME and EME) of heavy metals and pharmaceuticals (published 2017 to May 2019), and their combinations with atomic spectroscopy, UV-VIS spectrophotometry, high performance liquid chromatography, gas chromatography, capillary electrophoresis, and voltammetry.

Microextraction approaches for bioanalytical applications: An overview

Biological samples are usually complex matrices due to the presence of proteins, salts and a variety of organic compounds with chemical properties similar to those of the target analytes. Therefore, sample preparation is often mandatory in order to isolate the analytes from troublesome matrices before instrumental analysis. Because the number of samples in drug development, doping analysis, forensic science, toxicological analysis, and preclinical and clinical assays is steadily increasing, novel high throughput sample preparation approaches are calling for. The key factors in this development are the miniaturization and the automation of the sample preparation approaches so as to cope with most of the twelve principles of green chemistry. In this review, recent trends in sample preparation and novel strategies will be discussed in detail with particular focus on sorptive and liquid-phase microextraction in bioanalysis. The actual applicability of selective sorbents is also considered. Additionally, the role of 3D printing in microextraction for bioanalytical methods will be pinpointed.