Real-Time Probe for the Efficient Sensing of Inorganic Fluoride and Copper Ions in Aqueous Media

Rhodamine 6G derivative for the selective copper detection and remediation using nanoporous diatomaceous earth-engineered functional receptor

A rhodamine-derived receptor was synthesized and comprehensively characterized for structural confirmation. The receptor was able to distinguish the copper ions (Cu²⁺) from other competing cations. The yellow color of the receptor changed to pink upon adding Cu²⁺ ions, however, other competing cations ions were impotent towards any color variation. The UV-visible titration studies revealed the binding stoichiometry of a 1:1 ratio with a detection limit of 9.663 × 10^-8 M. Additionally, a novel idea of the work resides in the use of diatom for the practical application, where the receptor has been tethered on nanoporous diatomaceous earth microparticles (P2D) to remove Cu²⁺ ions. The results confirmed that 50 mg receptor functionalized DE could adsorb 10 mL of 1 ppm Cu²⁺ ions from water. Furthermore, a proof-of-concept device that is inexpensive, simple to operate, and continuously removes Cu²⁺ ions from water has been developed. The efficiency of the device in Cu²⁺ ion removal could be realized through the naked eye by observing the color change of P2D particles, which has excellent potential for application in remote locations where water contamination is a significant issue.

Development of a new electrochemical method for the determination of copper(ii) at trace levels in environmental and food samples

This paper presents the fabrication of a new modified carbon paste electrode (CPE) with N 1-hydroxy-N 1,N 2-diphenylbenzamidine (HDPBA) and functionalized multi-walled carbon nanotubes (MWCNTs) (HDPBA-MWCNTs/CPE) for highly sensitive and selective determination of Cu(ii) using the square wave anodic stripping voltammetry (SWASV) technique. The fabricated electrode was characterized using various spectroscopic techniques to study its morphological, structural, and electrochemical properties. The accumulation of Cu(ii) on the surface of HDPBA-MWCNTs/CPE was done in 0.1 M ammonium chloride (NH4Cl, pH 5) solution at an applied potential of -0.70 V versus Ag/AgCl for 180 s, followed by electrochemical stripping in the positive scan of the voltammetry after a resting time of 10 s. The developed HDPBA-MWCNTs/CPE was found to be highly selective, sensitive and reproducible. At optimal conditions of the experiment, the proposed method exhibited a very low limit of detection (0.0048 nM Cu(ii)), a wide linear dynamic range (0.00007-1.5000 μM Cu(ii)), and good reproducibility with relative standard deviation (RSD) value of 3.7%. The effect of various foreign ions on the voltammetric response of Cu(ii) was investigated and the electrode was found to be highly selective to Cu(ii). The practical applicability of the proposed HDPBA-MWCNTs/CPE was studied by applying the electrode for the quantification of Cu(ii) contents in environmental water (wastewater and tap water), soft drink (Fanta and Sprite), and food supplement (commercially available multi-mineral/vitamin tablets) samples. The present method was validated with atomic absorption spectrometry (AAS). The results found from the two methods are in good agreement with a 95% confidence level.

Nontoxic Tb3+-induced hyaluronic nano-poached egg aggregates for colorimetric and luminescent detection of Fe3+ ions

This study demonstrates that a luminescent Tb³⁺ complex with green emission can be complexed with hyaluronic (hya) to form nanoparticles. The structure of complexation is composed of a Tb(acac)₂phen core with a hya surface, similar to those of the nano-poached eggs. What makes the structure unique is that Tb(acac)₂phen and hya are connected by chemical bonds. To confirm their utility, we illustrate that the luminescence is rapidly and selectively quenched in the presence of Fe³⁺. Initial cytotoxicity experiments with human liver carcinoma cells show that the luminescent lanthanide complexes are cytotoxic, however, complexing lanthanides to hya renders them cytocompatible. The new complex integrates the advantages of superior lanthanide luminescence, the unique shape of nano-poached eggs, compatibility with aqueous systems, and cytocompatibility. Tb³⁺-induced hyaluronic nano-poached eggs (THNE) can, therefore, be used for Fe³⁺ detection in aqueous systems.

The original Tb³⁺-induced hyaluronic nano-poached eggs (THNE) integrates the advantages of superior lanthanide luminescence, the unique shape of nano-poached eggs, and non-toxicity, for the sensing of Fe³⁺ in aqueous surroundings.

Recent Advances in Microfluidic Platform for Physical and Immunological Detection and Capture of Circulating Tumor Cells

CTCs (circulating tumor cells) are well-known for their use in clinical trials for tumor diagnosis. Capturing and isolating these CTCs from whole blood samples has enormous benefits in cancer diagnosis and treatment. In general, various approaches are being used to separate malignant cells, including immunomagnets, macroscale filters, centrifuges, dielectrophoresis, and immunological approaches. These procedures, on the other hand, are time-consuming and necessitate multiple high-level operational protocols. In addition, considering their low efficiency and throughput, the processes of capturing and isolating CTCs face tremendous challenges. Meanwhile, recent advances in microfluidic devices promise unprecedented advantages for capturing and isolating CTCs with greater efficiency, sensitivity, selectivity and accuracy. In this regard, this review article focuses primarily on the various fabrication methodologies involved in microfluidic devices and techniques specifically used to capture and isolate CTCs using various physical and biological methods as well as their conceptual ideas, advantages and disadvantages.

New optofluidic based lab-on-a-chip device for the real-time fluoride analysis

A PDMS (Polydimethylsiloxane) microfluidic channel coupled with UV-vis fibre-optic spectrometer and new synthesized colorimetric probe was integrated into an optofluidic based Lab-on-a-chip device for highly sensitive and real-time quantitative measurements of fluoride ions (F¯). An 'S' shaped microchannel in a microfluidic device was designed to act as microreactor to facilitate the continuous reaction between synthetized colorimetric probe (sensor) and F¯ ions. Following this reaction, the UV-vis optical probe in the downstream detection zone of the microfluidic device was used to capture their spectrum and present as F¯ concentration in real-time conditions. An initial study of the developed colorimetric probe with multi-colour change with several binding and chromophore groups such as -OH, -NH and -NO₂ groups confirmed its high sensitivity and selectivity for F¯ ions with a detection limit of 0.79 ppm. The performance of the developed optofluidic device was evaluated for the selective, sensitive detection of F¯ ions including real samples out-performing conventional methods. The technology has advantages such as low sample consumption, rapid analysis, high sensitivity and portability. Presented new Lab-on-a-chip device provides many competitive advantages for the real-time analysis of F¯ ions needed across broad sectors.

A Selective Ratiometric Receptor 2-((E)-(3-(prop-1-en-2-yl)phenylimino)methyl)-4-nitrophenol for the Detection of Cu2+ ions Supported By DFT Studies

A Schiff-base 2-((E)-(3-(prop-1-en-2-yl)phenylimino)methyl)-4-nitrophenol (Receptor 1) colorimetric probe was synthesized and its UV-visible and fluorescence spectral properties for the sensing of Cu^+ 2 ions in CH₃OH/H₂O (60:40,v/v) solvent system was explored. The Receptor 1 showed the discriminating spectral behavior with the addition of Cu²⁺ ions solution. The other metal ions showed no significant effect towards Receptor 1. Moreover, the addition of Cu²⁺ ions to the Receptor 1 demonstrated the shift in the peak towards longer wavelength of 405 nm due to the ligand to metal charge transfer (LMCT) effect. The red-shift and new peak at 405 nm are due to the deprotonation of the -OH group and formation of complex and O-Cu covalent bond, respectively. A slight increase in the Cu²⁺ ion concentration exhibited strong absorption and fluorescence properties, leading to the spontaneous change in color from pale yellow to orange. Additionally, Density Functional Theory (DFT) studies were performed to investigate the interaction of Cu²⁺ ions with Receptor 1. The decrease in the energies (3.59062 kcal/mol to 0.36028 kcal/mol) of Cu²⁺-Receptor-1 complex compared to Receptor 1 confirms the strong interaction with high stability. The association constant (Ka) of Cu²⁺-Receptor-1 complex was found as 175000 M^- 1. The limit of detection (LOD) was calculated and noted as 179 nM.

Simultaneous Multiplexed Detection of Protein and Metal Ions by a Colorimetric Microfluidic Paper-based Analytical Device

In order to improve the efficiency of disease diagnosis and environmental monitoring, it is desirable to detect the concentration of proteins and metal ions simultaneously, since the current popular diagnostic platform can only detect proteins or metal ions independently. In this work, we developed a colorimetric microfluidic paper-based analytical device (µPAD) for simultaneous determination of protein (bovine serum albumin, BSA) and metal ions [Fe(III) and Ni(II)]. The µPAD consisted of one central zone, ten reaction zones and ten detection zones in one device, in which reaction solutions were effectively optimized for different types of chromogenic reactions. Fe(III), Ni(II) and BSA can be easily identified by the colored products, and their concentrations are in good accordance with color depth based on the established standard curves. The detection limits are 0.1 mM for Fe(III), 0.5 mM for Ni(II) and 1µM for BSA, respectively. Best of all, we demonstrated the efficiency of the µPAD with accurate detection of Fe(III), Ni (II) and BSA from river water samples within 15 minutes. The µPAD detection is efficient, instrument-free, and easy-to-use, holding great potential for simultaneous detection of cross type analytes in numerous diagnostic fields.

Naturally available diatomite and their surface modification for the removal of hazardous dye and metal ions: A review

The presence of toxic pollutants such as dyes and metal ions at higher concentrations in water is very harmful to the environment. Removal of these pollutants using diatomaceous earth or diatomite (DE) and surface-modified DE has been extensively explored due to their excellent physio-chemical properties and low cost. Therefore, naturally available DE being inexpensive, their surface modified adsorbents could be one of the potential candidates for the wastewater treatment in the future. In this context, the current review has been summarized for the removal of both pollutants i.e., dyes and metal ions by surface-modified DE using the facile adsorption process. In addition, this review is prominently focused on the various modification process of DE, their cost-effectiveness; the physio-chemical characteristics and their maximum adsorption capacity. Further, real-time scenarios of reported adsorbents were tabulated based on the cost of the process along with the adsorption capacity of these adsorbents.

Xerogel activated diatoms as an effective hybrid adsorbent for the efficient removal of malachite green

The surface of a naturally available diatom was modified using a xerogel for the enhanced removal of malachite green from aqueous media.