Polyaniline-co-polyindole functionalized magnetic porous carbon derived from MIL-53(Fe) for separation/enrichment of nitrophenols pollutants before determination with high-performance liquid chromatography-ultraviolet detection

Herein, a novel polyaniline-co-polyindole functionalized magnetic porous carbon derived from MIL-53(Fe) was prepared and employed as an excellent nano-adsorbent to preconcentrate trace amounts of nitro-phenols in water and wastewater samples. Briefly, magnetic MIL-53(Fe) was synthesized by the addition of magnetite nanoparticles, terephthalic acid, and FeCl3 to the reaction medium. The magnetic MIL-53(Fe) was pyrolyzed under nitrogen protection to obtain a magnetic porous carbon nanocomposite, and finally, the nanomaterial was functionalized with polyaniline-co-polyindole via oxidation polymerization. The obtained nano-adsorbent was characterized via X-ray diffraction, Fourier-transform infrared spectroscopy, vibrating sample magnetometry, and transmission and scanning electron microscopies. After that, the fabricated nano-material was utilized as an excellent nano-adsorbent for the preconcentration of trace nitro-phenols (2-nitrophenol, 4-nitrophenol, and 2,4-dinitrophenol) in environmental water, and wastewater samples. The detection limits were obtained from 0.1 to 0.15 μg/L after performing the optimization process. The new method was in the range of 0.4-300 μg/L. The proposed method exhibited a good precision from 3.2% to 9.6% for within-day assay, and 5.2%-13.2% for between-day assay at three concentration levels (1, 50, and 250 μg/L). Eventually, this method was utilized to preconcentrate/determine the target analytes in three water, and wastewater samples, satisfactory (relative standard deviations, 5.4%-9.3%; relative recovery, 88%-109%).

Determination of phenols in natural and waste waters by capillary electrophoresis after preconcentration on magnetic nanoparticles coated with aminated hypercrosslinked polystyrene

An efficient sorbent for magnetic solid-phase extraction was developed from Fe₃ O₄ nanoparticles covered with aminated hypercrosslinked polystyrene. The sorbent has a saturation magnetization of 47 emu/g and a surface area of 509 mg/g and was tested for the extraction of 11 phenols from aqueous media. The optimum conditions were as follows: pH 3; adsorbent mass, 20.0 mg; adsorption time, 30 min; eluent (acetone) volume, 0.5 mL; and desorption time, 5 min. The enrichment factor after desorption reached 1595-1716 and the maximum adsorption capacity was 501-909 mg/g. Capillary electrophoresis was applied successively to separate 11 phenols after solid-phase extraction. The best separation was achieved using a fused silica capillary and borate buffer (pH 10.7) as a supporting electrolyte. After optimization, the linearity range was from 0.2 to 950 μg/L, and the limits of detection were 0.05-0.2 μg/L. The relative standard deviation varied from 6.1 to 8.7% (C = 1 μg/L) and from 2.9 to 3.5% (C = 500 μg/L). The determination of phenols is complicated in eutrophic water and spring water with a high content of humic and fulvic acids.

Sorption behavior of selected chlorophenols onto polyurethane foam treated with iron(III): kinetics and thermodynamic study

An efficient, selective, and inexpensive method for complete elimination of chlorophenols (CPs) from water has been established. The proposed procedure was based upon the use of n-tributyl phosphate (TBP)-plasticized iron(III) physically immobilized polyurethane foam (PUF) solid sorbent for complete removal of CPs from aqueous media at pH close to 0. The interaction of the complex ion [Fe(C₆H₅O)₆]^3- with protonated ether oxygen of the PUF sorbent forms ternary ion associate on/in the PUFs. The retention of 4-chlorophenol (4-C) and 2,4,6-trichlorophenol (TCP) by the TBP-treated iron(III)-immobilized PUF fitted well with the pseudo-second-order kinetic model with a rate constant (k) of 0.04 and 0.15 g (mg min)^-1, respectively. The sorption of 4-CP was endothermic whereas the uptake of TCP was favorable at low temperature approving the exothermic and non-spontaneous characteristics of its uptake. The ΔS value for 4-CP reveals good affinity of the ion [Fe(C₆H₅O)₆]^3- towards the PUF sorbent.