Novel approaches to the analysis of steroid estrogens in river sediments

Simultaneous determination of non-steroidal anti-inflammatory drugs and oestrogenic hormones in environmental solid samples

Pharmaceuticals are continually being released into the environment. Because of their physical and chemical properties, many of them or their bioactive metabolites can accumulate in sediments, sludge and soils, and induce adverse effects in terrestrial organisms. However, due to the very limited methods permitting the detection of these low-level concentration compounds in such complex matrices, their concentrations in natural solids remain largely unknown. In this paper, an analytical method for the simultaneous determination of thirteen pharmaceuticals (eight non-steroidal anti-inflammatory drugs and five oestrogenic hormones) in solid matrices was developed. The proposed MAE-SPE-GC-MS(SIM) method has been successfully validated providing a linear response over a concentration range of 1(17)-1000(1200)ng/g, depending on the pharmaceuticals, with correlation coefficients above 0.991. The method detection limits were in the range of 0.3-5.7 ng/g, absolute recoveries above 50%, except estrone. The developed method was applied in the analysis of the target compounds in sediment, sludge and soils collected in Poland giving primary data on their concentrations in such matrices in Poland. The obtained results confirmed that the proposed method can be successfully used in the analysis of real environmental solid samples.

A new protocol for the analysis of pharmaceuticals, pesticides, and hormones in sediments and suspended particulate matter from rivers and municipal wastewaters

We developed a protocol to quantify 12 emerging contaminants (ECs) (pharmaceuticals and hormones) and pesticides extracted from suspended particulate matter (SPM) of river water and municipal wastewaters samples as well as river sediments. The separation of suspended solids was realized using filtration of water samples. We tested a series of six different filter types. The effect of filtration on the concentrations of dissolved contaminants was evaluated to minimize losses of target compounds. The river sediment samples were lyophilized, and both SPM and sediment samples were subjected to ultrasonic extraction combined with C18 cartridge clean-up. Quantifications were realized using mass spectrometry. The method recoveries of all compounds ranged from 38 to 112 % in all studied matrices; poorer recoveries were achieved for sulfamethoxazole and diclofenac (as low as 38 %), whereas the recoveries for all other compounds in the wastewater treatment plant (WWTP) samples were between 68 and 111 %. The detection limits in sediments and SPM from river samples for the 12 analytes varied from 0.7 to 9.4 ng g(-1) and from 21 to 92 ng g(-1) for WWTP SPM samples. All targeted ECs were detected with concentrations ranging from 3 to 5,440 ng g(-1) in the studied matrices with the highest concentrations observed in WWTP SPM samples. A significant portion of the contaminants in a water sample is clearly associated with the suspended particulates. Optimization of water-treatment processes and environmental fate must absolutely consider the fraction of contaminants that is particulate-bound if one hopes to have a reasonable mass balance.

Analysis of estrogens and estrogen mimics in edible matrices--a review

This review provides a brief survey of the biological effects of selected endocrine-disrupting compounds that are formed after internal exposure of organisms. Further, the present analytical methods available for the determination of these compounds in foodstuffs are critically evaluated. The attention is primarily devoted to the methods for sample pretreatment, which are the main source of errors and are usually the most time-consuming step of the whole analysis. This review is focused on selected natural and synthetic estrogens, estrogen conjugates, and chemical additives used in the plastic industry that can act as estrogen mimics.

Non-targeted analysis of petroleum metabolites in groundwater using GC×GC-TOFMS

Groundwater at fuel release sites often contains nonpolar hydrocarbons that originate from both the fuel release and other environmental sources, as well as polar metabolites of petroleum biodegradation. These compounds, along with other polar artifacts, can be quantified as "total petroleum hydrocarbons" using USEPA Methods 3510/8015B, unless a silica gel cleanup step is used to separate nonpolar hydrocarbons from polar compounds prior to analysis. Only a limited number of these metabolites have been identified by traditional GC-MS methods, because they are difficult to resolve using single-column configurations. Additionally, the targeted use of derivatization limits the detection of many potential metabolites of interest. The objective of this research was to develop a nontargeted GC×GC-TOFMS approach to characterize petroleum metabolites in environmental samples gathered from fuel release sites. The method tentatively identified more than 760 unique polar compounds, including acids/esters, alcohols, phenols, ketones, and aldehydes, from 22 groundwater samples collected at five sites. Standards for 28 polar compounds indicate that effective limits of quantitation for most of these compounds in the groundwater samples range from 1 to 11 μg/L.

Characterization of endocrine disruptors from a complex matrix using estrogen receptor affinity columns and high performance liquid chromatography-high resolution mass spectrometry

Complex mixtures of contaminants with potential adverse effects on human health and wildlife are found in the environment and in the food chain. These mixtures include numerous anthropogenic compounds of various origins and structures, which may behave as endocrine disruptors. Mixture's complexity is further enhanced by biotic and abiotic transformations. It is therefore necessary to develop new strategies allowing the identification of the structure of known, as well as unknown, nuclear receptor (NR) ligands present in complex matrices. We explored the possibility to use NR-based affinity columns to characterize the presence of bioactive molecules in environmental complex mixtures. Estrogen receptor α (ERα)-based affinity columns were used to trap and purify estrogenic substances present in surface sediment samples collected in a French river under mixed anthropogenic pressure. We combined biological, biochemical and analytical approaches to characterize the structure of ligands retained on columns and demonstrate the presence of known active molecules such as bisphenol A and octylphenol, but also of unexpected ERα ligands (n-butylparaben, hydroxyl-methyl-benzofuranone). High resolution mass spectrometry results demonstrate that ERα affinity columns can be used for the isolation, purification and identification of known as well as unknown estrogenic contaminants present in complex matrices.

Analysis of emerging organic contaminants in environmental solid samples

Spreading sewage sludge on agricultural lands has been actively promoted by national authorities as an economic way of recycling. However, as by-product of wastewater treatment, sewage sludge may contain toxic substances, which could be incorporated into agricultural products or be distributed in the environment. Moreover, sediments can be contaminated by the discharge of wastewater effluents into rivers. This article reviews the determination of emerging contaminants (surfactants, flame retardants, pharmaceuticals and personal care products) in environmental solid samples (sludge, soil and sediment). Sample preparation, including extraction and clean-up, as well as the subsequent instrumental determination of contaminants are discussed. Recent applications of extraction techniques, such as Soxhlet extraction, ultrasound assisted extraction, pressurised liquid extraction, microwave assisted extraction and matrix solid-phase dispersion to the analysis of emerging contaminants in environmental solid samples are reviewed. Determination of these contaminants, generally carried out by gas chromatography and liquid chromatography coupled with different detectors, especially mass spectrometry for the identification and quantification of residues, is also summarised and discussed.

Surfactant-coated aluminum hydroxide for the rapid removal and biodegradation of hydrophobic organic pollutants in water

The removal of hydrophobic organic pollutants in water to surfactant-coated aluminum hydroxide [surfactant-Al(OH)(3)] was investigated. Anionic surfactants such as sodium dodecyl sulfate (SDS), sodium bis(2-ethylhexyl)sulfosuccinate (AOT), and sodium oleate were sorbed on positively charged aluminum hydroxide at pH 7 and formed hydrophobic aggregates that can incorporate hydrophobic organic pollutants in water. Because of the hydrophobic interaction and decrease in the positive charge, surfactant-Al(OH)(3) was coagulated into precipitates that can readily be separated from water. Hydrophobic organic pollutants such as alkylphenols, polycyclic aromatic hydrocarbons, estrogens, chlorinated antifungals, and pesticides were well collected to the precipitates and thus efficiently removed from water. The collection of hydrophobic organic pollutants was correlated to their aqueous-octanol distribution coefficient. The decomposition of hydrophobic organic pollutants was examined using a bacterial agent (Bacillus subtilis). Hydrophobic organic compounds collected to AOT-Al(OH)(3) or sodium oleate-Al(OH)(3) were insufficiently decomposed. On the other hand, nonylphenol, octylphenol, and pendimethalin collected to SDS-Al(OH)(3) were decomposed within 1 week. The decomposition was accelerated by the collection to SDS-Al(OH)(3).

Analysis for estrogens as environmental pollutants--a review

The approaches to the analysis for estrogen compounds as environmental pollutants are critically reviewed and evaluated on the basis of significant, recent original publications. The importance of sample pretreatment and analyte preconcentration techniques is pointed out, with an emphasis on SPE and on the use of highly selective interactions such as molecular recognition. The hyphenated systems of high-performance gas or liquid chromatography and mass spectrometric techniques are discussed as the basic methods of determination of estrogens in environmental samples. Immunochemical procedures are shown to be useful in semiquantitative screening of estrogen pollutants (e.g. ELISA kits). Classical HPLC and GC with common UV/Vis, fluorescence and electrochemical detection are useful in routine checking on higher pollutant concentrations.