Analysis of large oxygenated and nitrated polycyclic aromatic hydrocarbons formed under simulated diesel engine exhaust conditions (by compound fingerprints with SPE/LC-API-MS)

Direct target and non-target analysis of urban aerosol sample extracts using atmospheric pressure photoionisation high-resolution mass spectrometry

Polycyclic aromatic hydrocarbons (PAHs) are ubiquitous atmospheric pollutants of high concern for public health. In the atmosphere they undergo oxidation, mainly through reactions with ·OH and NOx to produce nitro- and oxygenated (oxy-) derivatives. In this study, we developed a new method for the detection of particle-bound PAHs, nitro-PAHs and oxy-PAHs using direct infusion into an atmospheric pressure photoionisation high-resolution mass spectrometer (APPI-HRMS). Method optimisation was done by testing different source temperatures, gas flow rates, mobile phases and dopants. Samples were extracted with methanol, concentrated by evaporation and directly infused in the APPI source after adding toluene as dopant. Acquisition was performed in both polarity modes. The method was applied to target analysis of seasonal PM_2.5 samples from an urban background site in Padua (Italy), in the Po Valley, in which a series of PAHs, nitro- and oxy-PAHs were detected. APPI-HRMS was then used for non-target analysis of seasonal PM_2.5 samples and results compared with nano-electrospray ionisation (nanoESI) HRMS. The results showed that, when samples were characterised by highly oxidised organic compounds, including S-containing compounds, like in summer samples, APPI did not bring any additional information with respect to nanoESI in negative polarity (nanoESI(-)). Conversely, for winter samples, APPI(-) could detect a series of aromatic and poly-aromatic compounds, mainly oxidised and nitrogenated aromatics, that were not otherwise detected with nanoESI.

The pre-separation of oxygen containing compounds in oxidised heavy paraffinic fractions and their identification by GC-MS with supersonic molecular beams

The heavy petroleum fractions produced during refining processes need to be upgraded to useable products to increase their value. Hydrogenated heavy paraffinic fractions can be oxidised to produce high value products that contain a variety of oxygenates. These heavy oxygenated paraffinic fractions need to be characterised to enable the control of oxidation processes and to understand product properties. The accurate identification of the oxygenates present in these fractions by electron ionisation (EI) mass spectrometry is challenging due to the complexity of these heavy fractions. Adding to this challenge is the limited applicability of EI mass spectral libraries due to the absence of molecular ions from the EI mass spectra of many oxygenates. The separation of oxygenates from the complex hydrocarbon matrix prior to high temperature GC-MS (HT-GC-MS) analysis reduces the complexity of these fractions and assists in the accurate identification of these oxygenates. Solid phase extraction (SPE) and supercritical fluid chromatography (SFC) were employed as prefractionation techniques. GC-MS with supersonic molecular beams (SMBs) (also named GC-MS with cold-EI) utilises a SMB interface with which EI is done with vibrationally cold sample compounds in a fly-through ion source (cold-EI) resulting in a substantial increase in the molecular ion signal intensity in the mass spectrum. This greatly enhances the accurate identification of the oxygenates in these fractions. This study investigated the ionisation behaviour of oxygenated compounds using cold-EI. The prefractionation by SPE and SFC and the subsequent analysis with GC-MS with cold-EI were applied to an oxygenated heavy paraffinic fraction.

A Review on Reactions of Polycyclic Aromatic Hydrocarbons with the Most Abundant Atmospheric Chemical Fragments: Theoretical and Experimental Data

Aerosols are ubiquitous in the atmosphere and have strong effects on climate and public health due to the importance of reactions of polycyclic aromatic hydrocarbon (PAH) compounds in air. Over the last decade, study of the reactions of PAHs and their derivatives in the atmosphere has become a key topic to find an effective way to decrease the impact of this spontaneous reaction and so reduce air pollution. This article aims to pool the majority of research on the reactions of PAHs with atmospheric agents such as oxygen, hydrogen and ozone and compare the theoretical and experimental results. In examining theoretical research, the number of aromatic rings is very important in calculating the rate constants and determining the main pathway of the reaction. So, while there are weak theoretical data, several papers issued in this field have concurred with key experimental results. For reactants with more than six aromatic rings, small basis sets have good conformity with experimental outcomes. Due to the abundance of OH in the atmosphere, much research has been done to find the best reaction pathway and calculate the associated rate constants experimentally and theoretically. In future, the opportunity exists for new researchers to detect the main intermediates, most important pathways, rate constants and the products of reactions with more than six aromatic rings and to detect PAHs in a dense atmosphere. Product identification will help to reduce air pollution.

An analytical investigation of 24 oxygenated-PAHs (OPAHs) using liquid and gas chromatography-mass spectrometry

We developed two independent approaches for separation and quantitation of 24 oxygenated polycyclic aromatic hydrocarbons (OPAHs) using both liquid chromatography-atmospheric pressure chemical ionization/mass spectrometry (LC-APCI/MS) and gas chromatography-electron impact/mass spectrometry (GC-EI/MS). Building on previous OPAH research, we examined laboratory stability of OPAHs, improved existing method parameters, and compared quantification strategies using standard addition and an internal standard on an environmental sample. Of 24 OPAHs targeted in this research, 19 compounds are shared between methods, with 3 uniquely quantitated by GC-EI/MS and 2 by LC-APCI/MS. Using calibration standards, all GC-EI/MS OPAHs were within 15 % of the true value and had less than 15 % relative standard deviations (RSDs) for interday variability. Similarly, all LC-APCI/MS OPAHs were within 20 % of the true value and had less than 15 % RSDs for interday variability. Instrument limits of detection ranged from 0.18 to 36 ng mL⁻¹ on the GC-EI/MS and 2.6 to 26 ng mL⁻¹ on the LC-APCI/MS. Four standard reference materials were analyzed with each method, and we report some compounds not previously published in these materials, such as perinaphthenone and xanthone. Finally, an environmental passive sampling extract from Portland Harbor Superfund, OR was analyzed by each method using both internal standard and standard addition to compensate for potential matrix effects. Internal standard quantitation resulted in increased precision with similar accuracy to standard addition for most OPAHs using 2-fluoro-fluorenone-¹³C as an internal standard. Overall, this work improves upon OPAH analytical methods and provides some considerations and strategies for OPAHs as focus continues to expand on this emerging chemical class.

Figure

Application of the Hough transform for the automatic determination of soot aggregate morphology

We report a new method for automated identification and measurement of primary particles within soot aggregates as well as the sizes of the aggregates and discuss its application to high-resolution transmission electron microscope (TEM) images of the aggregates. The image processing algorithm is based on an optimized Hough transform, applied to the external border of the aggregate. This achieves a significant data reduction by decomposing the particle border into fragments, which are assumed to be spheres in the present application, consistent with the known morphology of soot aggregates. Unlike traditional techniques, which are ultimately reliant on manual (human) measurement of a small sample of primary particles from a subset of aggregates, this method gives a direct measurement of the sizes of the aggregates and the size distributions of the primary particles of which they are composed. The current version of the algorithm allows processing of high-resolution TEM images by a conventional laptop computer at a rate of 1-2 ms per aggregate. The results were validated by comparison with manual image processing, and excellent agreement was found.

Efficient analysis of non-polar environmental contaminants by MALDI-TOF MS with graphene as matrix

In this Application Note, we describe, for the first time, the rapid analysis of hydrophobic compounds present in environmental contaminants, which includes polycyclic aromatic hydrocarbons (PAHs) and estrogen, by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) with the use of graphene as matrix. MALDI-TOF MS with conventional matrix has limitations in analyzing low-polarity compounds owing to their difficulty in ionization. We demonstrate that compared with conventional matrix, graphene displays higher desorption/ionization efficiencies for PAHs, and no fragment ions are observed. The method also holds potential in quantitative analysis. In addition, the ionization signal increases with the increasing number of benzene rings in the PAHs, suggesting that graphene binds to PAHs via π-π stacking interactions. Furthermore, graphene as adsorbent for solid-phase extraction of coronene from river water sample displays good performance with a detection limit of 10(-7) M. This work provides a novel and convenient method for analyzing low-polarity environmental contaminants by MALDI-TOF MS.

Atmospheric Heterogeneous Reactions of Benzo(a)pyrene

This experimental study deals with heterogeneous reactions of benzo(a)pyrene (BaP) with ozone, nitrogen dioxide and hydroxyl radicals. BaP was adsorbed on silica particles chosen here as a model of mineral atmospheric particles. Compound extractions were assisted by focused microwave and analyses were performed by gas chromatography coupled with mass spectroscopy in single ion monitoring mode. Pseudo-first order rate constants were obtained from the fit of experimental decays of particulate-BaP concentration versus reaction time. Second order rate constants were determined considering the different oxidant gaseous concentrations except for the case of hydroxyl radicals where only a pseudo-first order rate constant was proposed. Values obtained at room temperature are (2.1±0.5)×10−15 cm3 molecule−1 s−1 for (BaP + ozone), (5.8±1.4)×10−16 cm3 molecule−1 s−1 for (BaP + nitrogen dioxide) and (3.4±0.8)×10−2 s−1 for (BaP + OH) reactions. Products have only been investigated for the NO2 and the OH (in the presence of NOx) reactions. 1-, 3- and 6-nitrobenzo(a)pyrenes were detected as degradation products and quantified. Reaction rate constants for product formation are (3.7±0.9)×10−16 cm3 molecule−1 s−1 for 6-NBaP, (2.2±0.6)×10−17 cm3 molecule−1 s−1 for 1-NBaP and (5.3±1.3)×10−17 cm3 molecule−1 s−1 for 3-NBaP. 1-, 3- and 6-nitroBaP account respectively for approximately 5%, 12% and 83% of total nitrated species. If in the presence of only nitrogen dioxide, BaP was totally degraded within few minutes, only 20 to 25 % of the initial BaP led to nitrated compounds when reacting with OH (in the presence of NOx).