Use of dispersive liquid–liquid microextraction for the determination of carbamates in juice samples by sweeping-micellar electrokinetic chromatography

Optimisation of dispersive liquid-liquid microextraction for plasma sample preparation in bioanalysis of CDK4/6 inhibitors in therapeutic combinations for breast cancer treatment

Cyclin D dependent kinase 4 and 6 (CDK 4/6) inhibitors are novel anticancer drugs used in therapeutic combinations with endocrine therapy for breast cancer treatment. Their determination in patient plasma is of high interest as a prerequisite for possible therapeutic drug monitoring. Dispersive liquid-liquid microextraction (DLLME) shows great potential in bioanalytical sample preparation. Its simplicity and speed, along with the suitability for using small amounts of sample and hazardous solvents are some of its main advantages. However, its application on plasma samples is scarce and requires further development. The aim of this work was to explore the applicability of DLLME in the simultaneous extraction of six drugs of interest from human plasma, with an emphasis placed on achieving high extraction recoveries with low sample and solvent consumption. To tackle the low availability and amount of the plasma sample, as well as the complexity of the biological matrix, three novel DLLME modes are proposed: organic sample DLLME (OrS-DLLME), aqueous sample DLLME (AqS-DLLME), and a modified air-assisted DLLME (AA-DLLME). The extractant and disperser type and volume, volume ratios of all the components in the ternary system, effect of pH and salting out were optimised for all three proposed modes of DLLME. Optimised representative DLLME-HPLC-DAD-FLD method was validated and shown to be linear (R > 0.994), precise (RSD ≤13.8%, interday), accurate (bias -13.1-13.1%, interday) and robust (relative effect -3.34-6.08%). Simultaneous extraction of all six drugs with high recoveries (81.65-95.58%) was achieved. Sample volumes used were as low as 50-100 μL, with necessary organic solvent volumes in μL ranges. Greenness scores obtained using the AGREE software were between 0.63 and 0.66, demonstrating compliance with green analytical chemistry principles. Finally, the validated method was successfully applied on breast cancer patient plasma samples.

Chromatographic Methods for Detection and Quantification of Carbendazim in Food

Carbendazim (CBZ), which is a fungicide widely used for the management of plant diseases, has been detected in a number of food products. The negative effects of CBZ to human health have stimulated the reduction of the maximum residue limits (MRLs), and subsequently the development of reliable and sensitive detection methods. Here, we are reviewing for the first time all reported chromatographic methods for the detection and quantification of CBZ in food. Several techniques, including liquid chromatography (LC), thin layer chromatography (TLC), micellar electrokinetic chromatography (MEKC), and supercritical fluid chromatography (SFC), were used for the separation and detection of CBZ, showing diverse characteristics and sensitivity. Some methods allowed the specific determination of CBZ, whereas other methods were successfully applied for the simultaneous quantification of a huge number of pesticides. Most reported methods showed limits of detection (LOD) and quantification (LOQ) lower than the MRLs. Relevant efforts in the field have been directed toward the simplification and optimization of the extraction steps prior to the chromatographic separation to increase the recovery and reduce the matrix effects. In this Review, the matrices, extraction procedures, and separation and detection parameters are detailed and compared in order to provide new insights on the development of new reliable methods for the detection of CBZ in food.

Analysis of Six β-Lactam Residues in Milk and Egg by Micellar Electrokinetic Chromatography with Large-Volume Sample Stacking and Polarity Switching

A new micellar electrokinetic chromatography method with large-volume sample stacking and polarity switching was developed to analyze amoxicllin, cephalexin, oxacillin, penicillin G, cefazolin, and cefoperazone in milk and egg. The important parameters influencing separation and enrichment factors were optimized. The optimized running buffer consisted of 10 mM phosphate and 22 mM SDS at pH 6.7. The sample size was 1.47 kPa × 690 s, the reverse voltage was 20 kV, and the electric current recovery was 95%. Under these optimum conditions, the enrichment factors of six β-lactams were 193-601. Their LODs were <0.26 ng/g, and LOQs were all 2 ng/g, which was only 1/50-1/2 of the maximum residual limits demanded by U.S. and Japanese regulations. The intraday and interday RSDs of method were lower than 3.70 and 3.91%, respectively. The method can be applied to determine these six antibiotic residues in egg and milk.

Recent Advances in the Determination of Pesticides in Environmental Samples by Capillary Electrophoresis

Nowadays, owing to the increasing population and the attempts to satisfy its needs, pesticides are widely applied to control the quantity and quality of agricultural products. However, the presence of pesticide residues and their metabolites in environmental samples is hazardous to the health of humans and all other living organisms. Thus, monitoring these compounds is extremely important to ensure that only permitted levels of pesticide are consumed. To this end, fast, reliable, and environmentally friendly methods that can accurately analyze dilute, complex samples containing both parent substances and their metabolites are required. Focusing primarily on research published since 2010, this review summarizes the use of various sample pretreatment techniques to extract pesticides from various matrices, combined with on-line preconcentration strategies for sensitivity improvement, and subsequent capillary electrophoresis analysis.

Determination of phthalic acid esters in Chinese white spirit using dispersive liquid-liquid microextraction coupled with sweeping β-cyclodextrin-modified micellar electrokinetic chromatography

A simple method that consumes low organic solvent is proposed for the analysis of phthalic acid esters in Chinese white spirit using dispersive liquid-liquid microextraction coupled with sweeping-micellar electrokinetic chromatography. Tetrachloromethane and white-spirit-containing ethanol were used as the extraction and dispersing solvents, respectively. The electrophoresis separation buffer was composed of 5 mM β-cyclodextrin, 50 mM sodium dodecyl sulfate and 25 mM borate buffer (pH 9.2) with 9% acetonitrile, enabling the baseline resolution of the analytes within 13 min. Under the optimum conditions, satisfactory linearities (5-1000 ng/mL, r ≥ 0.9909), good reproducibility (RSD ≤ 6.7% for peak area, and RSD ≤ 2.8% for migration time), low detection limits (0.4-0.8 ng/mL) and acceptable recovery rates (89.6-105.7%) were obtained. The proposed method was successfully applied to 22 Chinese white spirits, and the content of dibutyl phthalate in 55% of the samples exceeded the Specific Migration Limit of 0.3 mg/kg established by the domestic and international regulations.

Recent advances in enhancing the sensitivity of electrophoresis and electrochromatography in capillaries and microchips (2010-2012)

CE has been alive for over two decades now, yet its sensitivity is still regarded as being inferior to that of more traditional methods of separation such as HPLC. As such, it is unsurprising that overcoming this issue still generates much scientific interest. This review continues to update this series of reviews, first published in Electrophoresis in 2007, with updates published in 2009 and 2011 and covers material published through to June 2012. It includes developments in the field of stacking, covering all methods from field amplified sample stacking and large volume sample stacking, through to isotachophoresis, dynamic pH junction and sweeping. Attention is also given to online or inline extraction methods that have been used for electrophoresis.

Determination of pesticide residues in ginseng by dispersive liquid-liquid microextraction and ultra high performance liquid chromatography-tandem mass spectrometry

A procedure involving acetonitrile-based extraction combined with dispersive liquid-liquid microextraction (DLLME) and detection by ultra high performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS) was used for determination of 39 pesticides in ginseng. The extraction of pesticide residues in ginseng was performed with acetonitrile, applying QuEChERS methodology, and the extract was further disposed by DLLME method before analyzed by UHPLC-MS/MS. The average recoveries ranged from 70 to 120% for 82% of the analytes with RSD lower than 15%. The calibration curves obtained with blank matrices were linear with a correlation coefficient of over 0.99. The limits of detection were between 0.01 and 1.0μg/kg. Matrix effects were studied by comparing solvent calibration curves and matrix-matched calibration curves. The results indicate the feasibility of this method for the determination of 39 pesticides in ginseng.

Contemporary sample stacking in analytical electrophoresis

Sample stacking is a term denoting a multifarious class of methods and their names that are used daily in CE for online concentration of diluted samples to enhance separation efficiency and sensitivity of analyses. The essence of these methods is that analytes present at low concentrations in a large injected sample zone are concentrated into a short and sharp zone (stack) in the separation capillary. Then the stacked analytes are separated and detected. Regardless of the diversity of the stacking electromigration methods, one can distinguish four main principles that form the bases of nearly all of them: (i) Kohlrausch adjustment of concentrations, (ii) pH step, (iii) micellar methods, and (iv) transient ITP. This contribution is a continuation of our previous reviews on the topic and brings an overview of papers published during 2010-2012 and relevant to the mentioned principles (except the last one which is covered by another review in this issue).

Recent advances in enrichment techniques for trace analysis in capillary electrophoresis

CE is gaining great popularity as a well-established separation technique for many fields such as pharmaceutical research, clinical application, environmental monitoring, and food analysis, owing to its high resolving power, rapidity, and small amount of samples and reagents required. However, the sensitivity in CE analysis is still considered as being inferior to that in HPLC analysis. Diverse enrichment methods and techniques have been increasingly developed for overcoming this issue. In this review, we summarize the recent advances in enrichment techniques containing off-line preconcentration (sample preparation) and on-line concentration (sample stacking) to enhancing sensitivity in CE for trace analysis over the last 5 years. Some relatively new cleanup and preconcentration methods involving the use of dispersive liquid-liquid microextraction, supercritical fluid extraction, matrix solid-phase dispersion, etc., and the continued use and improvement of conventional SPE, have been comprehensively reviewed and proved effective preconcentration alternatives for liquid, semisolid, and solid samples. As for CE on-line stacking, we give an overview of field amplication, sweeping, pH regulation, and transient isotachophoresis, and the coupling of multiple modes. Moreover, some limitations and comparisons related to such methods/techniques are also discussed. Finally, the combined use of various enrichment techniques and some significant attempts are proposed to further promote analytical merits in CE.

Dispersive liquid-liquid microextraction combined with capillary electrophoresis and time-of-flight mass spectrometry for urine analysis

The combination of dispersive liquid-liquid microextraction (DLLME) with capillary electrophoresis (CE) and a time-of-flight mass spectrometer (TOF-MS) was evaluated for the toxicological screening in urine samples. A methodology based on design of experiments (DOE) was implemented to increase the extraction efficiency. Dichloromethane and isopropanol were selected as the extraction and dispersing solvents, respectively. Seven factors for DLLME were screened with the help of a Plackett-Burmann DOE using two model compounds before fine investigation of the important parameters to maximise the compound extraction. These experiments were performed in the CE-UV configuration to overcome potential MS matrix effects. The performance of the entire procedure was then evaluated using CE-ESI-TOF-MS. With a preconcentration factor of more than 130, the highly sensitive DLLME-CE-ESI-TOF-MS method allowed for the detection of 30 toxicological compounds (i.e., amphetamines and their derivatives, opiates, cocaine and its metabolites and pharmaceuticals) in urine with limits of detection in the sub-ng/mL level and was used to analyse real toxicological samples. The combination of DLLME and CE was particularly attractive because of the small amount of organic solvents required.