Quartz tuning fork based portable sensor for vapor phase detection of methanol adulteration of ethanol by using aniline-doped polystyrene microwires

Exploitations of Schiff's test and iodoform test for an effective quality assessment of alcohol-based hand sanitizers

In the period of the corona virus disease 2019 (COVID-19) outbreak, an alcohol-based hand sanitizer is one of the most in-demand products for disinfection purposes. Two major concerns are adulteration of methanol, which causes toxicity to human health, and the concentration of legal alcohol in hand sanitizers due to their effect on antivirus. In this work, the first report of the entire quality assessment of alcohol-based hand sanitizers in terms of detection of methanol adulteration and quantification of ethanol is presented. Detection of adulterated methanol is carried out based on Schiff's reagent after the oxidation of methanol to formaldehyde, giving a bluish-purple solution to detect at 591 nm. In cases where a colorless solution is observed, an iodoform reaction with turbidimetric detection is then performed for quantitative analysis of legal alcohol (ethanol or isopropanol). To comply with the regulation of quality assessment of alcohol-based hand sanitizers, a regulation chart with four safety zones is also presented, employing a combination of two developed tests. The coordinates of a point (x, y) obtained from the two tests are extrapolated to the safety zone in the regulation chart. The regulation chart also showed consistency of analytical results as compared with the gas chromatography-flame ionization detector.

Silver Enhances Hematite Nanoparticles Based Ethanol Sensor Response and Selectivity at Room Temperature

Gas sensors are fundamental for continuous online monitoring of volatile organic compounds. Gas sensors based on semiconductor materials have demonstrated to be highly competitive, but are generally made of expensive materials and operate at high temperatures, which are drawbacks of these technologies. Herein is described a novel ethanol sensor for room temperature (25 °C) measurements based on hematite (α‑Fe₂O₃)/silver nanoparticles. The AgNPs were shown to increase the oxide semiconductor charge carrier density, but especially to enhance the ethanol adsorption rate boosting the selectivity and sensitivity, thus allowing quantification of ethanol vapor in 2–35 mg L⁻¹ range with an excellent linear relationship. In addition, the α-Fe₂O₃/Ag 3.0 wt% nanocomposite is cheap, and easy to make and process, imparting high perspectives for real applications in breath analyzers and/or sensors in food and beverage industries. This work contributes to the advance of gas sensing at ambient temperature as a competitive alternative for quantification of conventional volatile organic compounds.

Highly selective detection of methanol over ethanol by a handheld gas sensor

Methanol poisoning causes blindness, organ failure or even death when recognized too late. Currently, there is no methanol detector for quick diagnosis by breath analysis or for screening of laced beverages. Typically, chemical sensors cannot distinguish methanol from the much higher ethanol background. Here, we present an inexpensive and handheld sensor for highly selective methanol detection. It consists of a separation column (Tenax) separating methanol from interferants like ethanol, acetone or hydrogen, as in gas chromatography, and a chemoresistive gas sensor (Pd-doped SnO2 nanoparticles) to quantify the methanol concentration. This way, methanol is measured within 2 min from 1 to 1000 ppm without interference of much higher ethanol levels (up to 62,000 ppm). As a proof-of-concept, we reliably measure methanol concentrations in spiked breath samples and liquor. This could enable the realization of highly selective sensors in emerging applications such as breath analysis or air quality monitoring.

CdFe2O4 films for electroresistive detection of ethanol and formaldehyde vapors

Spinel CdFe₂O₄ thin films were synthesized by spray pyrolysis. The structural probe studies confirmed the multicrystalline nature of the films with their spinel structure. The crystallites have sizes between 13 and 37 nm and island morphology. The energy dispersive spectroscopy reveals the presence of iron, oxygen and cadmium in the film. The room temperature electrical resistance of the thin film, best measured at a voltage of 10 V, decreases rapidly if it is exposed to vapors of formaldehyde or ethanol. The sensor has detection limits of 15 ppm for ethanol and of 15 ppm for formaldehyde and a sensitivity of 0.0387 nA per ppm of ethanol. Graphical abstract The perception on the interaction properties of alcohol vapors namely ethanol and formaldehyde in CdFe₂O₄ thin film. This work clearly suggested that the CdFe₂O₄ material is a good candidate for sensing ethanol and formaldehyde vapor molecules.

Specific bioanalytical optical and photoelectrochemical assays for detection of methanol in alcoholic beverages

Methanol is a poison which is frequently discovered in alcoholic beverages. Innovative methods to detect methanol in alcoholic beverages are being constantly developed. We report for the first time a new strategy for the detection of methanol using fluorescence spectroscopy and photoelectrochemical (PEC) analysis. The analytical system is based on the oxidation of cysteine (CSH) with hydrogen peroxide (H₂O₂) enzymatically generated by alcohol oxidase (AOx). H₂O₂ oxidizes capping agent CSH, modulating the growth of CSH-stabilized cadmium sulphide quantum dots (CdS QDs). Disposable screen-printed carbon electrodes (SPCEs) modified with a conductive osmium polymer (Os-PVP) complex were employed to quantify resulting CdS QDs. This polymer facilitates the "wiring" of in situ enzymatically generated CdS QDs, which photocatalyze oxidation of 1-thioglycerol (TG), generating photocurrent as the readout signal. Likewise, we proved that our systems did not suffer from interference by ethanol. The PEC assays showed better sensitivity than conventional methods, covering a wide range of potential applications for methanol quantification.