Analysis of Steroid Hormones in Water Using Palmitate-Coated Magnetite Nanoparticles Solid-Phase Extraction and Gas Chromatography–Tandem Mass Spectrometry

Preparation of a sustainable magnetic sorbent for the extraction and preconcentration of progestogens in natural water samples

A film composed of agarose and graphene (G) and magnetic nanoparticles (G-MNPs) is proposed as a sorbent for the extraction and determination of medroxyprogesterone (MED), levonorgestrel (LEV), norethisterone (NOR) and progesterone (PRO) in natural water samples. Both the preparation of the film and the extraction procedure were optimized. The optimal extraction parameters were as follows: isopropyl alcohol as activation solvent, sample pH value of 3.0, extraction time of 30 min, 1.00 mL of acetonitrile as eluent, elution time of 5 min and sample volume of 100.00 mL. HPLC with photodiode array detector was used for the separation and determination. The method presented a linear range between 2.50 and 75.0 μg L-1 for all analytes, and the LODs were between 1.40 and 1.80 μg L-1. The method was applied to natural water samples, obtaining satisfactory recovery values (75-111 %). In conclusion, for the immobilization of the G-MNPs, agarose was used, which is a non-toxic, renewable and biodegradable material. The G-MNPs-agarose film was reused up to 70 times, without losing its extraction capacity significantly and presenting excellent sorbent properties, which allow the extraction and preconcentration of the progestogens under study.

Iron oxide magnetic aggregates: Aspects of synthesis, computational approaches and applications

Superparamagnetic magnetite nanoparticles have been central to numerous investigations in the past few decades for their use in many applications, such as drug delivery, medical diagnostics, magnetic separation, and material science. However, the properties of single magnetic nanoparticles are sometimes not sufficient to accomplish tasks where a strong magnetic response is required. In light of this, aggregated magnetite nanoparticles have been proposed as an alternative advanced material, which may expand and combine some of the advantages of single magnetic nanoparticles, including superparamagnetism, with an enhanced magnetic moment and increased colloidal stability. This review comprehensively discusses the current literature on aggregates made of magnetic iron oxide nanoparticles. This review is divided into three sections. First, the current synthetic strategies for magnetite nanoparticle aggregates are discussed, together with the influence of different stabilizers on the primary crystals and the final aggregate size and morphology. The second section is dedicated to computational approaches, such as density functional methods (which permit accurate predictions of electronic and magnetic properties and shed light on the behavior of surfactant molecules on iron oxide surfaces) and molecular dynamics simulations (which provide additional insight into the influence of ligands on the surface chemistry of iron oxide nanocrystals). The last section discusses current and possible future applications of iron oxide magnetic aggregates, including wastewater treatment, water purification, medical applications, and magnetic aggregates for materials displaying structural colors.

Sample Preparation and Analytical Methods for Steroid Hormones in Environmental and Food Samples: An Update Since 2012

Steroid hormones (SHs) have been widely used over the past few decades as both human and veterinary drugs to prevent or treat infectious diseases and anti-inflammatory benefits in clinical. Unfortunately, their residues in foodstuffs and environmental samples can produce adverse effects on human and animal life such as disrupting the endocrine system. For these reasons, sensitive, simple and efficient methods have been developed for the determination of these compounds in various matrices. This critical review summarized the articles published in the period from 2012 to 2019 and can be used to help researchers to understand development of the sample pretreatment protocols and analytical methods used to detect SHs. The developed extraction and purification techniques used for steroids in different samples, such as cloud point extraction, solid phase extraction based on different novel materials, microextraction methods, QuEChERS and other methods are summarized and discussed. Analytical methods used to quantify these compounds, such as different chromatography methods, electrochemical methods, as well as other methods, are illustrated and compared. We focused on the latest advances in SHs pretreatment, and the application of new technologies in SHs analysis.

Capillary electrophoresis and liquid chromatography for determining steroids in concentrates of purified water from Päijänne Lake

The research was done with partial filling micellar electrokinetic chromatography, microemulsion electrokinetic chromatography, and ultra-high performance liquid chromatography. The study focuses on determination of male and female steroids from cold and hot tap water of households in Helsinki City. The district´s raw water is made run from Päijänne Lake through a water tunnel to the purification plants in Helsinki area. The effluents delivered from the plants to households as tap water were sampled and used for the study. They were concentrated with solid phase extraction to exceed the detection limits of the three methods. With partial filling method the limits were 0.50, 0.48, 0.33, and 0.50 mg/L for androsterone, testosterone, progesterone, and testosterone-glucuronide, respectively. In microemulsion method the limit values were 1.33, 1.11, and 0.40 mg/L for androsterone, testosterone, and progesterone, respectively, and 0.83, 0.45, and 0.50 mg/L for hydrocortisone, 17-α-hydroxyprogesterone, and 17-α-methyltestosterone, respectively. In the tap water samples, progesterone concentrations represented the highest values being 0.22 and 1.18 ng/L in cold and hot water, respectively. They also contained testosterone (in all samples), its glucuronide metabolite (in 25% of the samples), and androstenedione (in 75% of the samples). The ultra-high liquid chromatographic method with mass spectrometric detection was used for identification of the steroids at µg/L level.

Comparative study of substituted poly(4-vinylbenzyl chloride/ethylene glycol dimethacrylate) sorbents for enrichment of selected pharmaceuticals and estrogens from aqueous samples

This study reports the syntheses of four polymeric sorbents based on nucleophilic substitution of Poly(4-vinylbenzylchloride/ethylene glycol dimethacrylate). Polymerization was executed by a simple thermal initiated bulk polymerization procedure. Ground polymer particles were functionalized through reaction with the nucleophiles triethylamine, imidazole, piperidine and pyrrolidine. Mixed-mode phases were characterized by infrared spectroscopy, nitrogen sorption porosimetry and potentiometric titration for determination of chloride content. Furthermore, materials were tested and evaluated for enrichment of seven pharmaceutical and endocrine-disrupting compounds at low ng mL^-1 levels. Results demonstrate that the imidazole modified sorbent led to high and constant recovery rates for nearly all tested compounds. Therefore, this polymer was further tested for applicability with two environmental samples. Spiked tap and river water showed similar results as in evaluation experiments. Moreover, the developed method was validated regarding linearity, repeatability, instrumental limits and stability of analytes according to international guidelines.

Sensing Estrogen with Electrochemical Impedance Spectroscopy

This study demonstrates the application feasibility of electrochemical impedance spectroscopy (EIS) in measuring estrogen (17β-estradiol) in gas phase. The present biosensor gives a linear response (R² = 0.999) for 17β-estradiol vapor concentration from 3.7 ng/L to 3.7 × 10^-4 ng/L with a limit of detection (3.7 × 10^-4 ng/L). The results show that the fabricated biosensor demonstrates better detection limit of 17β-estradiol in gas phase than the previous report with GC-MS method. This estrogen biosensor has many potential applications for on-site detection of a variety of endocrine disrupting compounds (EDCs) in the gas phase.

Fast determination of 24 steroid hormones in river water using magnetic dispersive solid phase extraction followed by liquid chromatography-tandem mass spectrometry

The easiness-to-handle of the magnetic dispersive solid phase extraction (Mag-dSPE) procedure was developed for preconcentration of 24 steroid hormones in river water. Ethylenediamine-functionalized magnetic carbon nanotubes (EDA@Mag-CNTs) were synthesised by a simple one-pot reaction and were used as sorbent in Mag-dSPE procedure. The properties of the EDA@Mag-CNTs were characterized by transmission electron microscopy (TEM) and vibrating sample magnetometer (VSM). An ultra-fast liquid chromatography-tandem quadrupole mass spectrometry (UFLC-MS/MS) method for determination of 24 steroid hormones in river water at nanograms per liter had been developed with pretreatment of the samples by Mag-dSPE. The obtained results demonstrated the higher extraction capacity of EDA@Mag-CNT Mag-dSPE with recoveries between 82.1 and 113%. The limits of quantification (LOQs) for the steroid hormone were between 0.020 and 1.00 ng/L. The developed method had been successfully applied to 60 river water samples, and it was confirmed that EDA@Mag-CNT Mag-dSPE was a highly effective extraction method for the steroid hormone analyses.