Removal of ethyl benzene vapor pollutant from the air using TiO2 nanoparticles immobilized on the ZSM-5 zeolite under UVradiation in lab scale

Investigation of photocatalytic-proxone process performance in the degradation of toluene and ethyl benzene from polluted air

In this study, toluene and ethylbenzene were degraded in the photocatalytic-proxone process using BiOI@NH₂-MIL125(Ti)/Zeolite nanocomposite. The simultaneous presence of ozone and hydrogen peroxide is known as the proxone process. Nanocomposite Synthesis was carried out using the solvothermal method. Inlet airflow, ozone concentrations, H₂O₂ concentrations, relative humidity, and initial pollutants concentrations were studied. The nanocomposite was successfully synthesized based on FT-IR, BET, XRD, FESEM, EDS element mapping, UV-Vis spectra and TEM analysis. A flow rate of 0.1 L min^-1, 0.3 mg min^-1 of ozone, 150 ppm of hydrogen peroxide, 45% relative humidity, and 50 ppmv of pollutants were found to be optimal operating conditions. Both pollutants were degraded in excess of 95% under these conditions. For toluene and ethylbenzene, the synergistic of mechanisms effect coefficients were 1.56 and 1.76, respectively. It remained above 95% efficiency 7 times in the hybrid process and had good stability. Photocatalytic-proxone processes were evaluated for stability over 180 min. The remaining ozone levels in the process was insignificant (0.01 mg min^-1). The CO₂ and CO production in the photocatalytic-proxone process were 58.4, 5.7 ppm for toluene and 53.7, and 5.5 ppm for ethylbenzene respectively. Oxygen gas promoted and nitrogen gas had an inhibitory effect on the effective removal of pollutants. During the pollutants oxidation, various organic intermediates were identified.

Gaseous ethylbenzene removal by photocatalytic TiO2 nanoparticles immobilized on glass fiber tissue under real conditions: evaluation of reactive oxygen species contribution to the photocatalytic process

Photocatalytic oxidation (PCO) using a TiO₂ catalyst is an effective technique to remove gaseous volatile organic compounds (VOCs). Herein, a lab-scale continuous reactor is used to investigate the photocatalytic performance toward ethylbenzene (EB) vapor removal over TiO₂ nanoparticles immobilized on glass fiber tissue. The role of the reactive species in the removal of EB and the degradation pathway were studied. Firstly, the effect of key operating parameters such as EB concentration (13, 26, 60 mg/m³), relative humidity levels (From 5 to 80%), gas carrier composition (dry air + EB, O₂ + EB and N₂ + EB) and ultraviolet (UV) radiation wavelength (UV-A _365 nm, UV-C _254 nm) were explored. Then, using superoxide dismutase and tert-butanol as trapping agents, the real contribution of superoxide radical anion (O₂^.-) and hydroxyl radicals (OH^.) to EB removal was quantified. The results show that (i) small water vapor content enhances the EB degradation; (ii) the reaction atmosphere plays an important role in the photocatalytic process; and (iii) oxygen atmosphere/UV-C radiation shows the highest EB degradation percentage. The use of radical scavengers confirms the major contribution of the hydroxyl radical to the photocatalytic mechanism with 75% versus 25% for superoxide radical anion.

Particulate matter exposure in construction sites is associated with health effects in workers

Background

Exposure to suspended particulate matters (PMs) at high concentrations, mainly observed in the construction workplace, is found to be a risk factor for major health outcomes. The present study was conducted to investigate the degree of exposure to suspended PMs in different stages of construction of the buildings and the health risk associated with the exposure in Lar, Fars, Iran.

Methods

In this cross-sectional study, two construction sites were selected in Lar. Cancer and non-cancer health risks of exposure to PM_2.5 and PM₁₀ were assessed using the US Environmental Protection Agency method in three-dimensions: inhalation, digestion, and dermal absorption. The hazard quotient (HQ) and total cancer risk (TCR) were considered as parameters for risk analysis.

Results

The highest level of non-cancer risk for workers in the concentrations of PM_2.5 and PM₁₀ particles in the drilling process were determined to be 2.97 × 10^-1 and 8.52 × 10^-2, respectively. In the cancer risk analysis, PM₁₀ concentrations were estimated to be at the highest level (1.7 × 10^-7) in the drilling process and the lowest level (4.29 × 10^-8) in the facilities process. For suspended PM_2.5, it was an unacceptable risk level in all processes, except for the implementation of facilities.

Conclusion

These results show that the construction industry, especially in developing countries such as Iran, needs better management to maintain the health of construction workers.

High-efficiency removal of benzene vapor using activated carbon from Althaea officinalis L. biomass as a lignocellulosic precursor

Benzene is a primary air pollutant commonly found widespread in the indoor environment. It has always been a research focus on the environment due to the causes of significant human health concerns. It has been widely utilized in the synthesis of solvent production, which can rarely be found in high concentrations in outdoor air or high amounts in indoor air, depending on its sources. It is aimed to remove different initial benzene concentrations (from 5 to 1500 ppm) with the production of activated carbon as an excellent adsorbent with a high surface area to be used in these situations. Lignocellulosic wastes have great potential for activated carbon for their advantages (abundant, recycled, and low-cost materials, etc.). This study aimed to evaluate biowaste material for activated carbon production from Althaea officinalis L. biomass by chemical activation (H₂SO₄, LiOH, and ZnCl₂) at temperatures between 500 and 900 °C. Newly developed powdered activated carbons (Ao-ACs) are also tabulated as Ao-AC1-45 for easy reference. Benzene vapor was collected into Tenax TA® tubes by automatic thermal desorption in conjunction with a capillary gas chromatography-mass spectrometry (TD-GC/MS). The significant surface area and production yield of Ao-ACs were obtained at 1424 m²/g (Ao-AC43) and up to 40.32%, respectively. The maximum gas-phase benzene adsorption capacity was 140 mg/g at 270 min. This research has focused on adsorption gas-phase benzene removal onto Ao-ACs as a low-cost adsorbent from the Althaea officinalis L. biomass. Conspicuously, more study is needed to perform the enhanced adsorption of airborne pollutants capacity with inexpensive activated carbon from waste biomass materials.

Photocatalytic oxidation technology for indoor air pollutants elimination: A review

As more people are spending the majority of their daily lives indoors, indoor air quality has been acknowledged as an important factor influencing human health, with increasing research attention in recent decades. Indoor air pollutants (IAPs), such as volatile organic compounds (VOCs) and semi-volatile organic compounds (SVOCs), can cause acute irritation and chronic diseases. Photocatalytic oxidation (PCO) technology is an efficient approach for eliminating IAPs. In this review, the development of PCO technology was explained and discussed to promote future development of PCO technology for IAP elimination. First, the health effects and the measured concentrations of typical VOCs and SVOCs in indoor environments worldwide were briefly introduced. Subsequently, the development and limitations of some typical photocatalytic reactors (including packed-bed reactors, monolithic reactors, optical fiber reactors, and microreactors) were summarized and compared. Then, the influences of operating parameters (including initial concentration of contaminants, relative humidity, space velocity, light source and intensity, catalyst support materials, and immobilization method) and the degradation pathways as well as intermediates of PCO technology were elucidated. Finally, the possible challenges and future development directions regarding PCO technology for IAP elimination were critically proposed and addressed.