Optically stimulated luminescence of natural NaCl mineral from Dead Sea exposed to gamma radiation

Thermoluminescence study of pellets prepared using NaCl from Khewra Salt Mines in Pakistan

In this study, the thermoluminescence characteristics of naturally occurring salt (NaCl) were assessed for the development of a radiation dosimeter. For this purpose, mined crystalline samples of salt were procured directly from Khewra salt mines in Pakistan. The samples were hand crushed, sieved, and compressed to pellets comparable in size to standard TLD chips, and irradiated to gamma radiation doses in the range of 5 mGy and 5000 mGy. Thermoluminescence (TL) response showed three main peaks in the glow curve around 115-130 °C, 150-170 °C, and 220-240 °C. A linear TL response was observed for the dose range of 5-100 mGy. The TL response became supra-linear for the dose ranges of 100-1000 mGy and 1000-5000 mGy. The T_m-T_stop method was applied to identify the overlapping peaks of the glow curve. Computerized glow curve deconvolution (CGCD) was then employed for the characterization of electron trap parameters such as frequency factor (s), activation energy (E), and the kinetic order (b), using General Order (GO) kinetics. The figure-of-merit (FOM) was found to be 1.08%, 0.94%, 0.77%, and 0.75%, at 500 mGy, 1 Gy, 2 Gy, and 5 Gy, respectively. The TL intensity faded by 20% within the first 24 h after irradiation and finally stabilized after two weeks. In addition, structural, morphological, and elemental analyses, were also performed using various analytical techniques. X-ray diffraction (XRD) showed that the salt crystallizes in a face-centered cubic structure. Scanning electron microscope (SEM) micrographs indicated that the crystallites are closely packed and cubic-shaped with non-uniform size, and mostly found in the agglomerated form. Similarly, the elemental analysis confirmed the presence of impurities such as Mg, Sr, S, K, O, and Ca, in the samples. The present study concludes that the pellets made from salt samples from Khewra mines have a potential for use as radiation dosimeters.

Natural dead sea salt and retrospective dosimetry

Accidents resulting in widespread dispersal of radioactive materials have given rise to a need for materials that are convenient in allowing individual dose assessment. The present study examines natural Dead Sea salt adopted as a model thermoluminescence dosimetry system. Samples were prepared in two different forms, loose-raw and loose-ground, subsequently exposed to ⁶⁰Co gamma-rays, delivering doses in the range 2-10 Gy. Key thermoluminescence (TL) properties were examined, including glow curves, dose response, sensitivity, reproducibility and fading. Glow curves shapes were found to be independent of given dose, prominent TL peaks for the raw and ground samples appearing in the temperature ranges 361-385 ºC and 366-401 ºC, respectively. The deconvolution of glow curves has been undertaken using GlowFit, resulting in ten overlapping first-order kinetic glow peaks. For both sample forms, the integrated TL yield displays linearity of response with dose, the loose-raw salt showing some 2.5 × the sensitivity of the ground salt. The samples showed similar degrees of fading, with respective residual signals 28 days post-irradiation of 66% and 62% for the ground and raw forms respectively; conversely, confronted by light-induced fading the respective signal losses were 62% and 80%. The effective atomic number of the Dead Sea salt of 16.3 is comparable to that of TLD-200 (Z_eff 16.3), suitable as an environmental radiation monitor in accident situations but requiring careful calibration in the reconstruction of soft tissue dose (soft tissue Z_eff 7.2). Sample luminescence studies were carried out via Raman and Photoluminescence spectroscopy as well as X-ray diffraction, ionizing radiation dependent variation in lattice structure being found to influence TL response.