Integrated electrochemical treatment systems for facilitating the bioremediation of oil spill contaminated soil

Phase inverted hydrophobic polyethersulfone/iron oxide-oleylamine ultrafiltration membranes for efficient water-in-oil emulsion separation

Exploration and transportation of oil offshore can result in oil spills that cause a wide range of adverse environmental consequences and destroy aquatic life. Membrane technology outperformed the conventional procedures for oil emulsion separation due to its improved performance, reduced cost, removal capacity, and greater eco-friendly. In this study, a hydrophobic iron oxide-oleylamine (Fe-Ol) nanohybrid was synthesized and incorporated into polyethersulfone (PES) to prepare novel PES/Fe-Ol hydrophobic ultrafiltration (UF) mixed matrix membranes (MMMs). Several characterization techniques were performed to characterize the synthesized nanohybrid and fabricated membranes, including scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), Fourier transform-infrared spectroscopy (FT-IR), X-ray diffraction (XRD), thermal gravimetric analysis (TGA), contact angle, and zeta potential. The membranes' performance was assessed using a surfactant-stabilized (SS) water-in-hexane emulsion as a feed and a dead-end vacuum filtration setup. The incorporation of the nanohybrid enhanced the hydrophobicity, porosity, and thermal stability of the composite membranes. At 1.5 wt% Fe-Ol nanohybrid, the modified PES/Fe-Ol MMM membranes reported high water rejection efficiency of 97.4% and 1020.4 LMH filtrate flux. The re-usability and antifouling properties of the membrane were examined over five filtration cycles, demonstrating its great potential for use in water-in-oil separation.

Stimulation of atrazine degradation by activated carbon and cathodic effect in soil microbial fuel cell

Soil microbial fuel cells (MFCs) have been increasingly studied in recent years and have attracted significant attention as an environmentally sustainable bioelectrochemical technology. However, the poor conductivity of the soil matrix and the neglect of the cathodic function have limited its application. In this study, quartz sand and activated carbon were subjected to investigation on their influence on atrazine degradation. Atrazine was introduced in different layers (cathode, upper layer) to explore the cathodic effect on atrazine removal. The results revealed that activated carbon could reduce the internal resistance (693 Ω) and generate the highest power density (25.51 mW/m²) of the soil MFCs, and thus increase the removal efficiency (97.92%) of atrazine. The dynamic degradation profiles of atrazine were different for different adding layers. The cathode electrode acted as an electron donor could increase the distance of the effective influence of the soil MFCs' cathode from the middle to the cathode layer. The cathode (region) and the region close to the cathode could degrade atrazine with the atrazine removal efficiencies ranging from 60.67% to 92.79%, and the degradation ability of the cathode was stronger than that of other layers. The degradation effect followed the order: cathode > upper > lower > middle). Geobacter, Desulfobulbus, and Desulfuromonas belonging to the δ-Proteobacteria class were identified as the dominant electroactive microorganisms in the anode layer, while their relative abundances are quite low in the upper and cathode layers. Pseudomonas is an atrazine-degrading bacterium, but its relative abundance was only 0.13-0.51%. Thus, bioelectrochemistry rather than microbial degradation was the primary driving force.

Emerging bio-dispersant and bioremediation technologies as environmentally friendly management responses toward marine oil spill: A comprehensive review

Marine oil spills emanating from wells, pipelines, freighters, tankers, and storage facilities draw public attention and necessitate quick and environmentally friendly response measures. It is sometimes feasible to contain the oil with booms and collect it with skimmers or burn it, but this is impracticable in many circumstances, and all that can be done without causing further environmental damage is adopting natural attenuation, particularly through microbial biodegradation. Biodegradation can be aided by carefully supplying biologically accessible nitrogen and phosphorus to alleviate some of the microbial growth constraints at the shoreline. This review discussed the characteristics of oil spills, origin, ecotoxicology, health impact of marine oils spills, and responses, including the variety of remedies and responses to oil spills using biological techniques. The different bioremediation and bio-dispersant treatment technologies are then described, with a focus on the use of green surfactants and their advances, benefits/drawbacks. These technologies were thoroughly explained, with a timeline of research and recent studies. Finally, the hurdles that persist as a result of spills are explored, as well as the measures that must be taken and the potential for the development of existing treatment technologies, all of which must be linked to the application of integrated procedures.

Remediation of soil polluted with petroleum hydrocarbons and its reuse for agriculture: Recent progress, challenges, and perspectives

Petroleum hydrocarbons (PHs) are used as raw materials in many industries and primary energy sources. However, excessive PHs act as soil pollutants, posing serious threats to living organisms. Various ex-situ or in-situ chemical and biological methods are applied to restore polluted soil. However, most of the chemical treatment methods are expensive, environmentally unfriendly, and sometimes inefficient. That attracts scientists and researchers to develop and select new strategists to remediate polluted soil through risk-based analysis and eco-friendly manner. This review discusses the sources of PHs, properties, distribution, transport, and fate in the environment, internal and external factors affecting the soil remediation and restoration process, and its effective re-utilization for agriculture. Bioremediation is an eco-friendly method for degrading PHs, specifically by using microorganisms. Next-generation sequencing (NGS) technologies are being used to monitor contaminated sites. Currently, these new technologies have caused a paradigm shift by giving new insights into the microbially mediated biodegradation processes by targeting rRNA are discussed concisely. The recent development of risk-based management for soil contamination and its challenges and future perspectives are also discussed. Furthermore, nanotechnology seems very promising for effective soil remediation, but its success depends on its cost-effectiveness. This review paper suggests using bio-electrochemical systems that utilize electro-chemically active microorganisms to remediate and restore polluted soil with PHs that would be eco-friendlier and help tailor-made effective and sustainable remediation technologies.

Review on microbial fuel cells applications, developments and costs

The microbial fuel cell (MFC) technology has attracted significant attention in the last years due to its potential to recover energy in a wastewater treatment. The idea of using an MFC in industry is very attractive as the organic wastes can be converted into energy, reducing the waste disposal costs and the energy needs while increasing the company profit. However, taking aside these promising prospects, the attempts to apply MFCs in large-scale have not been succeeded so far since their lower performance and high costs remains challenging. This review intends to present the main applications of the MFC systems and its developments, particularly the advances on configuration and operating conditions. The diagnostic techniques used to evaluate the MFC performance as well as the different modeling approaches are described. Towards the introduction of the MFC in the market, a cost analysis is also included. The development of low-cost materials and more efficient systems, with high higher power outputs and durability, are crucial towards the application of MFCs in industrial/large scale. This work is a helpful tool for discovering new operation and design regimes.

Simulated Ageing of Crude Oil and Advanced Oxidation Processes for Water Remediation since Crude Oil Pollution

Crude oil can undergo biotic and abiotic transformation processes in the environment. This article deals with the fate of an Italian crude oil under simulated solar irradiation to understand (i) the modification induced on its composition by artificial ageing and (ii) the transformations arising from different advanced oxidation processes (AOPs) applied as oil-polluted water remediation methods. The AOPs adopted were photocatalysis, sonolysis and, simultaneously, photocatalysis and sonolysis (sonophotocatalysis). Crude oil and its water-soluble fractions underwent analysis using GC-MS, liquid-state 1H-NMR, Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR-MS), and fluorescence. The crude oil after light irradiation showed (i) significant modifications induced by the artificial ageing on its composition and (ii) the formation of potentially toxic substances. The treatment produced oil oxidation with a particular effect of double bonds oxygenation. Non-polar compounds present in the water-soluble oil fraction showed a strong presence of branched alkanes and a good amount of linear and aromatic alkanes. All remediation methods utilised generated an increase of C5 class and a decrease of C6–C9 types of compounds. The analysis of polar molecules elucidated that oxygenated compounds underwent a slight reduction after photocatalysis and a sharp decline after sonophotocatalytic degradation. Significant modifications did not occur by sonolysis.

Enhanced removal of bisphenol A from contaminated soil by coupling Bacillus subtilis HV-3 with electrochemical system

Exposure to endocrine disruptors interferes with the synthesis, release, transport and metabolic activities of hormones, thus impairing human health significantly. Bisphenol A (BpA), an endocrine disruptor, commonly released into the environment by industrial activities and needs immediate attention. This study aims at investigating the process and prospects of deploying bio-electrochemical systems (BES) for the removal of BpA from artificially contaminated soil using Bacillus subtilis HV-3. The BES was setup with desired operating conditions: initial concentration of BpA (80-150 mg/L), pH (3-11) and applied potential voltage (0.6-1.4 V). Under optimized conditions (initial BpA concentration, 100 mg/L; pH 7; and applied voltage 1.0 V), close to 98% degradation of BpA was achieved. The intermediates produced during degradation were analysed using High performance liquid chromatography-Mass spectrometry and the possible degradation pathway was elucidated. Phytotoxicity studies in the remediated soil with Phaseolus mungo confirmed the environmental applicability of the BES system.

Molecular-level investigation of soils contaminated by oil spilled during the Gulf War

In this study, molecular-level chemical compositions of soils contaminated by oil spilled during the Gulf War were studied. Two soil samples, respectively collected at 0.1 m and between 0.5 and 1 m below the surface from an oil spill site, were extracted with organic solvents and water. The extracts were analyzed via ultrahigh resolution FT-ICR and two-dimensional gas chromatography/high resolution mass spectrometry. The data showed that the spilled oil was significantly affected by vaporization due to high surface temperatures in the desert. The data obtained with (+) atmospheric pressure photo ionization (APPI) and (-) electrospray ionization (ESI) coupled with ultrahigh resolution-mass spectrometry (UHR-MS) indicated that the degradation of aromatic compounds and increase in oxygen-containing classes occurred in the following order: surface soil > below surface soil > crude oil. The oxygenated compounds were confirmed by principal component analysis. The score and loading plots of O_x and SO_x showed that they were the major contributors to differentiate the samples. However, a comparison with previously reported oceanic oil spills showed that less significant degradation occurred even after almost 30 years. Our data can provide an information basis for designing a strategy for clean-up and restoration efforts of Gulf War oil spills.

Crude oil removal from aqueous solution using raw and carbonized Xanthoceras sorbifolia shells

Fruit shell residue from Xanthoceras sorbifolia was investigated as a potential biosorbent to remove crude oil from aqueous solution. The shell powder and its carbonized material were compared while assessing various factors that influenced oil removal capacity. The structure and sorption mechanism were characterized using scanning electron microscopy and Fourier-transform infrared spectroscopy. The oil removal capacity of the raw material (75.1 mg g^-1) was better than the carbonized material (49.5 mg g^-1). The oil removal capacity increased with greater saponin content, indicating that hydrophobic and lipophilic surface characteristics of the saponins improved adsorption by the raw X. sorbifolia shell. An orthogonal experimental design was used to optimize the adsorption. Using 4 g L^-1 of raw X. sorbifolia shell (particle size of < 0.15 mm), the highest crude oil removal efficiency was obtained using an initial oil concentration of 400 mg L^-1, adsorption temperature of 30 °C, adsorption time of 10 min at a shaking speed of 150 rpm. The adsorption of crude oil onto X. sorbifolia shell was best described using a pseudo-second-order kinetic model. Raw X. sorbifolia shell material was more efficient than the carbonized material at crude oil removal from aqueous solution. This was attributable to the functional groups of saponins in raw X. sorbifolia shell. This study highlights that some agricultural and forest residues could be a promising source of low-cost biosorbents for oil contaminants from water-without requiring additional processing such as carbonization.

Ozone-cathode microbial desalination cell; An innovative option to bioelectricity generation and water desalination

Microbial desalination cell (MDC) is a new approach of water desalination methods, which is based on ionic species removal from water in proportion to the electric current generated by bacteria. However, the low current generation and insufficient deionization in this technology have created challenges to improve the process. Here, the performance of MDC using ozone as a new electron acceptor (O₃-MDC) was evaluated versus another operated independently with oxygen (O₂-MDC). Results showed the maximum open-circuit voltages of 628 and 1331 mV for 20 g L^-1 NaCl desalination in O₂-MDC and O₃-MDC, respectively. The O₃-MDC produced a maximum power density of 4.06 W m^-2 (about 11 times higher than O₂-MDC) while at the same time was able to remove about 74% of salt (55.58% in the O₂-MDC). Each cycle of O₂-MDC and O₃-MDC operation lasted about 66 and 94 h, respectively, indicating a more stable current profile in the O₃-MDC. Moreover, sequencing test based on 16S rRNA gene showed that the anode biofilm had more diverse microbial community than anolyte sample. Proteobacteria, Firmicutes and Acidobacteria were from dominant microbial communities in anode biofilm sample. Accordingly, the results revealed that ozone can enhance MDC performance either as a desalination process or as a pre-treatment reactor for downstream desalination processes.